Tripp Lite OMNIX350HG Bedienungsanleitung

Tripp Lite Nicht kategorisiert OMNIX350HG

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Tripp Lite OMNIX350HG (68 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/68

Owner’s Manual

SMX & OMNIX

Medical Grade UPS Systems

Models:

Important Safety Instructions 2

Package Contents 5

Quick Installation 6

Basic Operation 8

Guidance and Manufacturer’s Declaration 14

Storage & Service 16

Regulatory Compliance 17

Español 18

Français 35

Deutsch 52

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

OMNIX350HG

(Series Number: AGOM6832)

SMX700HG

(Series Number: AGSM6833)

SMX1200XLHG

(Series Number: AGSM6834)

Important Safety Instructions

Statement of Intended Use

Tripp Lite Medical-Grade UPS Systems are intended to support and protect non-medical computer

equipment and medical devices that require leakage current reduction, surge protection, voltage

regulation, line noise ﬁltering and battery backup during power outages and generator testing, both

inside and outside patient care areas. Tripp Lite’s Medical-Grade UPS Systems come with hospital-

grade plugs and receptacles that reduce leakage to below 100μA.

Product Information

OMNIX350HG SMX700HG SMX1200XLHG

AC Input Voltage 230V 230V 230V

Input Amp(s) 1.78 4 5

Output Amp(s) 1.5 2 3.3

Rated Power (VA/Watts) 350VA, 225W 700VA, 450W 1000VA, 750W

Frequency 50/60 Hz 50/60 Hz 50/60 Hz

No. of Phases Single Single Single

Class Type Class I Class I Class I

Plug/Connector Type Inlet C14 with dongle Inlet C14 with dongle Inlet C14 with dongle

Operation Continuous Continuous Continuous

AC Input Protection (Qty/type/rating) Input breaker (2 x 3A)

thermal

Input breaker (2 x 5A)

thermal

Input breaker (2 x 6A)

thermal

Max Leakage Current (uA) Less than 100uA Less than 100uA Less than 100uA

Weight 11.5 kg 19.1 kg 20.6 kg

Known Contraindication None None None

SAVE THESE INSTRUCTIONS

This manual contains important instructions that should be followed during the installation,

operation and storage of all Tripp Lite UPS Systems. Failure to heed these warnings may affect

your warranty.

Note: Your UPS incorporates overcurrent protection in both the L1 and L2 input conductors.

UPS Location Warnings

Relevant Symbols

Denotes that information in the manual should be reviewed before use.

Used to signal as a warning that a statement is particularly important and could pose a safety

risk.

Warning-Dangerous Voltage No sitting

Denotes general warning sign No stepping on surface

Refer to Instruction Manual/Booklet No pushing

Important Safety Instructions

• Do not use this equipment within oxygen-enriched atmospheres, or within 0.3 m of a point at

which an oxygen-enriched atmosphere is intentionally vented.

• Use caution when lifting UPS. Because of the considerable weight of all UPS systems, at least

two people should assist in lifting and installing them.

• Install your UPS indoors, away from excess moisture or heat, dust or direct sunlight.

• For best performance, the UPS should be used in a location that meets the following conditions:

Temperature: 0 to 40° C; Humidity: 0 to 95% (non-condensing);

Elevation: <2,000 m above sea level; Pressure: >95kPa

• Leave adequate space around all sides of the UPS for proper ventilation. Do not obstruct its vents

or fan openings.

• Do not mount unit with its front or rear panel facing down (at any angle). Mounting in this manner

will seriously inhibit the unit’s internal cooling, eventually causing product damage not covered

under warranty.

UPS Connection Warnings

• The UPS contains its own energy source (battery). The output terminals may be live even when

the UPS is not connected to an AC supply.

• Connect your UPS to a properly grounded AC power outlet. Do not modify the UPS’s plug in a

way that would eliminate the UPS’s connection to ground. Do not use adapters that eliminate the

UPS’s connection to ground.

• Do not plug your UPS into itself; this will damage the UPS and void your warranty.

• If you are connecting your UPS to a motor-powered AC generator, the generator must provide

ﬁltered, frequency-regulated output. Connecting your UPS to a generator will void its Ultimate

Lifetime Insurance.

• To remove the UPS from the supply mains, the appliance inlet serves as a disconnect device.

• Once connected, do not limit access to the input plug. The plug must be accessible to be used as

a means of disconnection.

CAUTION: Do not remove cover for 5 minutes after disconnecting all sources of

supply. Risk of electric shock—hazardous live parts inside. Do not remove cover.

No user serviceable parts inside. Refer servicing to qualiﬁed service personnel.

This UPS receives power from more DC sources; disconnection of the AC and DC

source is required to de-energize the unit before servicing.

CAUTION: To ensure proper grounding with supply mains power, the input cord must

be connected with an approved country-speciﬁc plug with a protective earth ground

connection.

CAUTION: If this product is operated on battery (not connected to mains power),

adequate safeguards should be employed to protect against accidental contact

with AC power conductors.

CAUTION: Do not exceed total rated output.

WARNING: No modiﬁcation of this equipment is allowed.

Produktspezifikationen

Marke:	Tripp Lite
Kategorie:	Nicht kategorisiert
Modell:	OMNIX350HG
Akustische Signale:	Ja
Breite:	130.8 mm
Tiefe:	188 mm
Gewicht:	11520 g
Produktfarbe:	Schwarz
Akku-/Batterietyp:	RBC52
Höhe:	269.2 mm
Stecker:	C14-Koppler
Betriebstemperatur:	0 - 40 °C
Relative Luftfeuchtigkeit in Betrieb:	0 - 95 %
Verpackungsbreite:	264.9 mm
Verpackungstiefe:	209 mm
Verpackungshöhe:	358.9 mm
Paketgewicht:	12430 g
Warentarifnummer (HS):	85078000
Ursprungsland:	China
LED-Anzeigen:	Ja
Temperaturbereich bei Lagerung:	-15 - 50 °C
Luftfeuchtigkeit bei Lagerung:	0 - 95 %
Anzahl Produkte pro Versandkarton:	1 Stück(e)
Gewicht Versandkarton:	12430 g
Länge des Versandkartons:	209 mm
Breite des Versandkartons:	264.9 mm
Höhe des Versandkartons:	358.9 mm
Schnittstelle:	Serial, USB
Formfaktor:	Tower
Ausgangsleistung:	225 W
Eingangsfrequenz:	50/60 Hz
Anzahl der AC-Ausgänge:	6 AC-Ausgänge
USV-Topologie:	Line-Interaktiv
Eingangs-Betriebsspannung (min):	159 V
Eingangs-Betriebsspannung (max):	266 V
Ausgangskapazität:	0.35 kVA
Ausgangs-Betriebsspannung (min):	230 V
Ausgangs-Betriebsspannung (max):	230 V
AC-Steckertypen:	C13-Koppler
Typische Backup-Zeit bei halber Belastung:	37 min
Typische Backup-Zeit bei voller Belastung:	15.5 min
Wellenform:	Sine
Nominale Eingang Spannung:	230 V
Nominale Ausgang Spannung:	230 V