Tripp Lite CSHANDLEKIT Bedienungsanleitung

Tripp Lite Nicht kategorisiert CSHANDLEKIT

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Tripp Lite CSHANDLEKIT (8 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/8

Installation Guide

PROTECT YOUR INVESTMENT!

You could also win an ISOBAR6ULTRA surge protector—a $50 value!

www.tripplite.com/warranty

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

CSHANDLEKIT

Caster and Handle Accessory for

Tablet/Chromebook™ Charging Stations

Español p.3 • Français p.5 • Póññêèé p.7

Parts List

x16

x12

x16 x16

x12

WARNING!

Do not attempt to install casters with equipment inside the charging station cabinet. Remove all

electronic devices from the charging station cabinet before installing casters. Failure to heed this

warning may result in damage to the charging station and equipment or personal injury.

• Do not push the charging station from the side panels to move it. Pushing from the side panels will cause a tipping hazard.

• When rolling the charging station on its casters, always push it from behind; never pull it toward you.

• A rolling charging station can cause personal injury and property damage if not properly supervised. If rolling the charging station down a

ramp is required, use extreme caution. Do not attempt to use ramps that have a slope grade greater than 12%.

M6 M6

Installing Casters

The CSHANDLEKIT contains two swivel/locking casters and two swivel-

only casters. For optimal safety, mount the caster brackets so both

locking casters are located at the rear of charging station.

Note: Hole sizes may vary by charging station model. Use the appropriate M5

or M6 hardware to secure the casters to the charging station.

Installing Handle

Attach a handle bracket to the unit with the included hardware A.

Then slide the handle bar into the mounted bracket B. Complete the

installation by sliding the second handle bracket onto the open end

of the handle bar C and attaching it to the unit with the included

hardware D.

Note: Hole sizes may vary by charging station model. Use the appropriate M5

or M6 hardware to secure the handle brackets to the charging station.

Installing Cord Manager

Note: Leave at a least a 5 mm space between the Cord Manager and screw head. Do not completely tighten screws until the Cord Manager is secured onto the

mounting holes located on the top or bottom of the charging station’s rear door.