Tommy Hilfiger 1790783 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Tommy Hilfiger 1790783 (3 Seiten) in der Kategorie Armbanduhr. Dieser Bedienungsanleitung war fĂĽr 23 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/3
1
OPERATING INSTRUCTIONS
TOMMY HILFIGER ANALOG/DIGITAL CHRONOGRAPH WATCH-
1/100 OF A SECOND with alarm function
This Tommy Hilfiger analog/digital chronograph features center-mounted analog hour, minute and
seconds hands; a two-window/12-digit LCD (liquid crystal display) with daily alarm/hourly chime/snooze
function, 1/100 chronograph with split-time function, 12/24-hour time format selection, and EL backlight.
Using the buttons
Press button to activate EL backlight for 3 seconds in any mode. A
Press button to move between/select modes. B
Buttons and C D are used to adjust settings and operate the chronograph.
NOTE: Press and release a button repeatedly to advance displayed information in single increments;
press and hold button down to advance information in a display rapidly.
To set analog time:
1. Pull crown out to position 2. T
2. Turn crown in either direction to set hands to desired time. T
3. Push crown back in to position 1, flush against case. T
DIGITAL MODES
There are four modes of digital operation: Real Time, Chronograph, Alarm and Time Setting.
To select/change mode:
Use push-button B to select/enter desired mode. Each time button is pushed, the mode will change in B
this sequence: –> Real Time (seconds not flashing) –> –>Chronograph –>B B B B –> Alarm –> –>
Time Setting (seconds flash) –> B –> Real Time (seconds not flashing).
NOTE: Watch will automatically revert to Real Time mode following a minute of inactivity in any other
mode.
A
EL backlight
B
Mode (select/change)
C
Stopwatch (set/stop/reset)
D
Stopwatch (start/stop/ad)
T
Crown (-1 -2)
2
REAL TIME
Upper digital window displays alpha Weekday/numeric Month/Date (ex: TH 6-23); lower digital window
displays numeric Hour/Minute/Seconds (ex: 11:54:17).
CHRONOGRAPH
The chronograph function on your watch can be used to time an event up to 23 hours, 59 minutes and
59.99 seconds in duration.
To operate the chronograph:
1. Press button B until you enter Chronograph mode: “ST” appears in upper left display; “00 00 00”
appears in lower digital display.
2. Press button D to start timing.
3. Press button D again to stop/restart/stop the chronograph as many times as desired to measure the
total accumulated time for a single event.
3. When chronograph is stopped at end of timing, press button to reset counter to zero. C
To take a split time:
1. With chronograph running, press button to take a split time – i.e., read an intermediate time during C
an ongoing event.
2. Press button C again to take a second split time.
3. Repeat step 2 to take any additional split times, as desired.
4. Press button D to exit the split count and stop counting.
5. Press button C to display all counts.
6. Press button C again to reset counter to zero.
DAILY ALARM
The beeper Alarm function on your watch can be set to sound once a day at a programmed time
(Alarm) and/or to beep twice on the hour (Chime).
To activate the alarm:
1. Press button B until you enter Alarm mode: “AL” appears in upper left display; current alarm time
setting appears in lower digital display.
2. Press button D to activate/deactivate Alarm and/or Chime.
NOTE: When Alarm is activated, a small sound wave symbol (show symbol) appears in upper right
corner of lower display; and when Chime is activated, a small bell symbol (show symbol) appears beside
it in upper right side of lower display.
To set alarm:
1. Press button B until you enter Alarm mode.
2. Press button C to select Hour or Minute setting; field for selected setting will flash.
3. Press button D to adjust setting to time desired.
4. Press button C to confirm setting: field stops flashing.
5. Repeat steps 3 and 4 to adjust remaining Hour or Minute setting, if desired.
6. Press button B to return to Real Time mode.
3
To use snooze feature:
When Alarm sounds, press button C or to stop the beeping; then press button to D B
activate/deactivate the snooze function. When snooze feature is turned on, the Alarm will sound again 5
minutes later, then stop beeping automatically after 20 seconds.
TIME SETTING
In addition to Hour, Minute and Seconds, the digital time function on this model also includes a calendar
display with Weekday, Month and Date.
To set digital time:
1. Press button B until you enter Time Setting mode: Seconds in lower digital display will start to flash.
2. Press button C one or more times to select item(s) to be set in the following sequence: Hour –>
Minute –> Month –> Date –> Day of week –> Seconds. Item currently selected will flash.
4. Press button D to adjust the flashing item.
NOTES: When setting the “Hour”: “H” in display indicates 24-hour format; “A” or “P” indicates 12-
hour format. Continue pressing button D to cycle through time in 24-hour format to reach 12-hour
display format.
When setting the “Seconds”: Pressing button when displayed Seconds range from 30 to 59 will resets D
Seconds to 00 and add 1 to the displayed Minutes. If Seconds are in 00 to 29 range when is pressed, D
they will reset to 00, but Minutes will not change.
6. Press button B to exit Time Setting mode.
BACKLIGHT
Press button to activate EL backlight for 3 seconds from any mode. A


Produktspezifikationen

Marke: Tommy Hilfiger
Kategorie: Armbanduhr
Modell: 1790783

Brauchst du Hilfe?

Wenn Sie Hilfe mit Tommy Hilfiger 1790783 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Armbanduhr Tommy Hilfiger

Bedienungsanleitung Armbanduhr

Neueste Bedienungsanleitung fĂĽr -Kategorien-