Thule Jogging Brake Kit Bedienungsanleitung

Thule Kinderwagen Jogging Brake Kit

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung fĂŒr Thule Jogging Brake Kit (4 Seiten) in der Kategorie Kinderwagen. Dieser Bedienungsanleitung war fĂŒr 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
Thule Jogging Brake Kit
Instructions
B
51100902
251100902 - B
1. The Brake Kit is pre-assembled for use on single Thule
Chariot child carriers, however, if you will be using the
Brake Kit on a double Thule Chariot child carrier, you
will need to adjust the Jogging Brake Kit into its large/
wider size. To do this, remove the four bolts (using a
10mm wrench and a Phillips screwdriver) that secure
the four rails to the square tube.
2. For the Thule Chariot Corsaire, move the rails
outwards and re-install the bolts through the middle
two holes on each of the four rails. For the Thule
Chariot Cheetah 2, and the Thule Chariot Cougar
2 move the rails outwards, and re-install the bolts
through the outside two holes on each of the four
rails. Ensure that each bolt has two washers, which
are placed on the top and the bottom of the square
tube and sandwiched between the square tube and
the rails.
3. Remove the front wheel of the carrier (or install the
two wheel arms, but not the wheel).
4. While facing the front of your carrier, pivot both
quick release levers into the open position and
orient the main body of the Brake Kit so that the
levers and the brake calipers are on the bottom
pointing towards you.
5. Install the main body of the Brake Kit onto the wheel
arms by rst sliding one end of the Brake onto one
of the wheel arms followed by the other. Notice: do
not tighten the quick release levers yet.
6. Assemble the brake cable onto / through the carrier.
Refer to Figure #1a or #1b. Run the cables up the
right hand side of the carrier.
These instructions contain many WARNINGS. Read and
understand all of the Warnings. Failure to assemble
and use this accessory correctly may lead to serious
personal injury to your passenger.
GENERAL WARNING
‱ Use wrist safety strap at all times.
‱ Always use seat belts.
‱ Always use parking brake when jogging stroller is
stationary.
‱ Never in-line skate with the Jogging Kit. A serious
accident could occur resulting in serious injury or death.
Initial Assembly Time: About 5 minutes.
Tools Required: a 10mm wrench, Phillips screwdriver
and a 5mm Allen Key.
Read instructions carefully before assembly.
The brake cable does not need to be disassembled
for assembly.
Any reference to orientation (left or right) is from the
trailer passenger's point of view, while in the carrier.
Figure 1a
Figure 1b
Thule Chariot Corsaire or
Thule Chariot Captain
Thule Chariot Cougar or
Thule Chariot Cheetah
Pass cable through
sleeve to back of trailer
insert cable
through sleeve
Insert cable into sleeve
cable passes under
hollow axle
insert cable
through webbing
51100902 - B 3
7. Place the brake lever on the centre of the handlebar
so that the lever points to the left. Insert the
aluminum shim between the brake lever mounting
clamp and the handlebar tube as shown in Figure 2.
Close the brake lever mounting clamp around the
handlebar (and shim) and tighten using a 5mm
Allen Key.
8. Re-attach the front wheel and adjust the main body
of the Brake Kit so that the centre bolt of the brake
calipers line up with the centre of the wheel. Ensure
that the main body of the Brake Kit is parallel to the
front of the carrier with approximately 1 to 1.5 cm
between the wheel and the square tube.
9. Pivot both quick release levers into the closed
position. This should securely fasten the main body
to the wheel arms. If it is not securely fastened,
open the quick release levers and slightly tighten
the nut on the opposite side of the quick release
levers until secure when the levers are closed.
10. Adjust the brake pads on the brake calipers so
that they fully contact the rim of the wheel when the
brake lever is actuated.
11. Adjust the cable tension and the alignment of the
brake calipers so that the brake pads are close to
but do not contact the rim of the wheel when the
brake lever is not actuated. To make minor cable
tension adjustments, rotate the barrel adjuster
nut, which is located at the point where the brake
housing connects to the brake calipers. If larger
adjustments are necessary, re-tension the brake
cable (using the 10mm) at the point where the cable
is fastened to the brake calipers.
WARNING
Ensure that the brake works effectively before
loading children and using.
Figure 2: Brake Installation
Reference Diagram
NOTICE
The brake cable will periodically require tightening
due to cable stretch.
Handlebar
Aluminum Shim
Brake Lever
Brake Lever
Square Tube
Close clamp
around handlebar
Barrel Adjuster Nut
Brake Cable
Quick Release Levers
Cable Housing
Rails
Brake Calipers
Brake
Pads


Produktspezifikationen

Marke: Thule
Kategorie: Kinderwagen
Modell: Jogging Brake Kit

Brauchst du Hilfe?

Wenn Sie Hilfe mit Thule Jogging Brake Kit benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Kinderwagen Thule

Bedienungsanleitung Kinderwagen

Neueste Bedienungsanleitung fĂŒr -Kategorien-