Tecmate Optimate Lithium Bedienungsanleitung

Tecmate Ladegerät Optimate Lithium

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Tecmate Optimate Lithium (40 Seiten) in der Kategorie Ladegerät. Dieser Bedienungsanleitung war für 17 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/40

Automatic charger for 12.8V LiFePO4 batteries

Chargeur automatique pour batteries 12.8V LiFePO4

Cargador automático para baterías 12.8V LiFePO

Automatische Ladegerät für 12.8V LiFePO

4 Batterien

Automatische lader voor 12.8V LiFePO4 accu’s

Caricabatterie automatico per batterie 12.8V LiFePO

Carregador automático para baterias de 12.8V LiFePO

Automatisk diagnostisk laddare för 12.8V LiFePO

batterier

Automatická diagnostická nabíječka pro 12,8v baterie

LiFePO4

MODEL: TM290 (EU), TM291 (US), TM294 (UK),

TM298 (AU)

AC: 100 – 240V 50-60Hz

0.85A @ 240V / 1.5A @ 100V

DC: 60W 12V 5A ¨

Thermally adjusted

INSTRUCTIONS FOR USE

IMPORTANT: Read completely

before charging

MODE D’EMPLOI

IMPORTANT: à lire avant

d’utiliser l’appareil

MODO DE EMPLEO

IMPORTANTE: a leer antes

de utilizar el aparato

ANWENDUNGSVORSCHRIFTEN

WICHTIG: Vollständig vor der

Benutzung lesen

GEBRUIKSAANWIJZING

BELANGRIJK: Lees volledig

voor gebruik

ISTRUZIONI PER L’USO

IMPORTANTE: da leggere prima

di utilizzare l’apparecchio

INSTRUKTIONER VIKTIGT: läs

följande fullständiga instruk-

tioner för användningen innan

du använder laddaren

INSTRUÇÕES DE UTILIZAÇÃO

IMPORTANTE: Ler antes de

utilizar.

INSTRUKCE PRO POUŽIT.

DŮLEŽIT: Přečtěte si pozorně

před použit.m

Save Charge Maintain Test

1 x 12.8V (4 x 3.2V cells) LiFePO4

Lithium Iron Phosphate

2.5 - 100Ah (charge within 24 hours)

+ -

10 STEPS

TM29x-IN1-170306

OptiMate

maintenance

TEST after

CHARGE

Low Volt

Start (0.5V)

TEST before

charge

Temperature

check

Ultra LOW

VOLT SAVE

LOW VOLT

SAVE /

cellmonitoring

TEST -

cell damage

Cell-balancing

CHARGE

OPTIMIZE

0.5V

13.6V

14.4V

4&5.SAVE 6.TEST 7.CHARGE 8.OPTIMIZE 9.TEST 10. MAINTAIN

1.START 2.TEST 3.TEMP

24-7-365

°C/°F

-20

104

-4

876

TEST > LEDs

TEST

30m - 12h

MAINTAIN

365

CHARGE

24h max

SAVE

15m - 4h

OPTIMIZE

10m - 12h

TEST

10s

34566

LED PANEL

876

90 100%603010%

13.3V 13.6V+ 13.13V13.00V12.80VV

87 7 6

10V

BMS RESET

PROGRAM > LEDs

IMPORTANT SAFETY

INSTRUCTIONS FOR CANADA & USA

THIS PORTION OF THE MANUAL CONTAINS IMPORTANT SAFETY INSTRUCTIONS FOR THE OptiMate

LITHIUM BATTERY CHARGER. IT IS OF THE UTMOST IMPORTANCE THAT EACH TIME, BEFORE

USING THE CHARGER, YOU READ AND EXACTLY FOLLOW THESE INSTRUCTIONS. SAVE THESE

INSTRUCTIONS.

AUTOMATIC CHARGER ONLY FOR 12.8V LIFEPO4 (LITHIUM IRON PHOSPHATE ) BATTERIES.

A rechargeable LIFEPO4 battery should comply with IEC62133*.

DO NOT USE FOR NiCd, NiMH, Lead-Acid or any other type of Li-Ion or

NON-RECHARGEABLE BATTERIES.

*IEC62133 - Safety requirements for portable sealed secondary cells containing alkaline or other

non acid electrolytes and for batteries made from them, for use in portable applications.

1. CAUTION : CLASS II APPLIANCE. DO NOT CONNECT TO GROUND.

2. For indoor use only. Do not expose charger to rain or snow.

3. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock,or injury to persons.

4. To reduce risk of damage to electric plug and cord,pull by plug rather than cord when disconnecting charger.

5. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock.If

extension cord must be used make sure that :

a) pins on plug of extension cord are the same number, size and shape as those of plug on charger.

b) the extension cord is property wired and in good electrical condition,and

c) the conductor wire size is large enough for the AC ampere rating of the charger as specified in the table below.

AC INPUT RATING IN AMPERES

Equal to or greater than But less than

LENGTH OF CORD, FEET

(m)

AWG SIZE OF

CORD

2A 3A 25 (17.6)

50 (15.2)

100 (30.5)

6. Do not operate charger with damaged cord or plug - replace the cord or plug immediately.

7. Do not operate charger if it has received a sharp blow, been dropped,or otherwise damaged in any way; take it to a qualified serviceman.

8. Do not disassemble charger; take it to a qualified serviceman when service or repair is required.

Incorrect reassembly may result in a risk of electric shock or fire.

9. To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance or cleaning.

Turning off controls will not reduce this risk.Clean only with slightly moist,not wet, cloth.Do not use solvents.

10. WARNING - RISK OF EXPLOSIVE GASES.

a) WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. B ATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR

THIS REASON, IT IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE INSTRUCTIONS EACH TIME YOU USE THE CHARGER.

b) To reduce risk of battery explosion,follow these instructions and those published by the battery manufacturer and manufacturer of any equipment you

intend to use in vicinity of the battery. Review cautionary marking on these products and on engine.

11. PERSONAL PRECAUTIONS.

a) Someone should be within range of your voice OR close enough to come to your aid when you work near a battery.

b) Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.

c) Wear complete eye protection and clothing protection. Avoid touching eyes while working near a battery.

d) If battery acid contacts or enters eye, flood eye with cold running water for at least 10 minutes and get medical attention immediately. If battery acid

contacts skin or clothing, wash immediately with soap & water. If acid enters an eye , immediately flood eye with running cold water for at least 10 minutes

& get medical attention immediately.

e) NEVER smoke or allow a spark or flame in vicinity of battery or engine.

f) Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery or other electrical part that may cause

explosion.