Tach-It KL-100 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Tach-It KL-100 (4 Seiten) in der Kategorie Etikettendrucker. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
INSTRUCTION
MANUAL FOR
TACH-IT MODEL KL-100 and KL-150
PRESSURE SENSITIVE
LABEL DISPENSER
Ben Clements and Sons, Inc. / Clements Industries, Inc.
50 Ruta Court, South Hackensack, New Jersey 07606 USA
Tel: 201-440-5500 or 800-222-5540 Fax: 201-440-1455
Email: sales@tach-it.com Web: www.tach-it.com
Tach-It is a registered trademark of Ben Clements and Sons, Inc. Clements Industries, Inc. May 2012
SECTION 1 – CAUTIONS
1) BEFORE OPERATING THE MACHINE, READ THE COMPLETE OPERATOR’S MANUAL.
2) NEVER HAVE THE POWER ON THIS MACHINE PLUGGED INTO THE POWER SOURCE
WHEN ANY OF THE COVERS OF THIS MACHINE HAVE BEEN REMOVED. THIS
MACHINE HAS A HIGH VOLTAGE INPUT, AND ELECTRICAL SHOCKS ARE
POSSIBLE IF PLUGGED IN AND THE COVERS ARE REMOVED.
3) NEVER ATTEMPT TO MOVE THIS MACHINE BY THE ARM THAT HOLDS THE ROLL OF
LABELS OR THE REWIND ARM.
4) INSTALL AND OPERATE THIS MACHINE ONLY ON A FLAT, LEVEL, AND DRY SUR
FACE.
5) USE ONLY THE SPECIFIED ELECTRICAL POWER INPUT WITH THIS MACHINE.
6) ALWAYS KEEP HANDS, CLOTHING, JEWELRY, AND HAIR AWAY FROM ALL MOVING
PARTS OF THIS MACHINE.
7) DO NOT OPERATE THIS MACHINE WITHOUT THE COVERS PROPERLY INSTALLED, OR
IF ANY OF THE GUARDS HAVE BEEN REMOVED.
8) KEEP THIS MACHINE CLEAN AND DRY AT ALL TIMES.
9) SERVICE ON THIS MACHINE SHOULD ONLY BE PERFORMED BY FACTORY TRAINED
AUTHORIZED SERVICE PERSONNEL.
10) NEVER USE THIS MACHINE FOR OTHER THAN ITS INTENDED APPLICATION. USE
OF THE MACHINE ON UNINTENDED APPLICATIONS CAN CAUSE HARM TO THE
OPERATOR AND THE MACHINE. PLEASE CONTACT THE MANUFACTURER IF
THERE IS ANY QUESTION AS TO WHETHER THIS MACHINE CAN BE USED FOR A
PARTICULAR APPLICATION
SECTION 2 – SPECIFICATIONS
KL-100 KL-150
LABEL SIZE MAXIMUM 4.25” WIDE X 12” LONG 6” WIDE X 12” LONG
MINIMUM 3/8” WIDE X 5/8” LONG 3/8” WIDE X 5/8” LONG
LABEL ROLL MAXIMUM 10” O.D. 10” O.D.
SPEED 25 FT PER MINUTE 25 FT PER MINUTE
POWER 110 VOLT A.C. 110 VOLT A.C.
DIMENSIONS LENGTH = 10” LENGTH = 10”
WIDTH = 11” WIDTH = 13”
HEIGHT = 8” HEIGHT = 8”
WEIGHT = 12 LBS WEIGHT = 13 LBS
LABEL LENGTH
ADJUSTMENT KNOB
PHOTO-SENSOR
ON/OFF
SWITCH
CONTROL BOX
RE-WINDER
ARM
RE-WINDER
HOLD-DOWN BAR
FOR LABEL WEB
FIGURE 1
HOLD-DOWN
BARS AND
LABEL
SEPARATING
PLATE
ROLL GUIDE OUTSID
ROLL GUIDE INSIDE
LABEL
ROLL
COUNTER


Produktspezifikationen

Marke: Tach-It
Kategorie: Etikettendrucker
Modell: KL-100

Brauchst du Hilfe?

Wenn Sie Hilfe mit Tach-It KL-100 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Etikettendrucker Tach-It

Bedienungsanleitung Etikettendrucker

Neueste Bedienungsanleitung für -Kategorien-