Stanley FMC770 Bedienungsanleitung

Stanley Radio FMC770

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Stanley FMC770 (35 Seiten) in der Kategorie Radio. Dieser Bedienungsanleitung war für 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/35
www.stanley.eu FMC770
3
ENGLISH
(Original instructions)
2
Intended use
Your Stanley Fat Max FMC770 Radio has been designed for
Listening to Radio Transmissions. This appliance is intended
for professional and private, non professional users.
Safety instructions
General safety warnings
@Warning! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions listed below may result in
injury.
u Read all of this manual carefully before using the
appliance.
u The intended use is described in this manual. The use of
any accessory or attachment or the performance of any
operation with this appliance other than those
recommended in this instruction manual may present a
risk of personal injury.
u Retain this manual for future reference.
Using your appliance
u Always take care when using the appliance.
u The appliance is not to be used as a toy.
u Use in a dry location only. do not allow the appliance to
become wet.
u Do not immerse the appliance in water.
u Do not open body casing. There are no user serviceable
parts inside.
u Do not operate the appliance in explosive atmospheres,
such as in the presence of ammable liquids, gases or
dust.
u To reduce the risk of damage to plugs and cords never
pull the cable to remove the plug from a socket outlet.
u The ventilation should not be impeded by covering the
ventilation openings with items, such as newspapers,
table-cloths, curtains, etc.;
u No naked ame sources, such as lighted candles, should
be placed on the apparatus;
u Attention should be drawn to the environmental aspects of
battery disposal;
u The use of apparatus in tropical and/or moderate climates.
After use
u When not in use, the appliance should be stored in a dry
place.
u Children should not have access to stored appliances.
u When the appliance is stored or transported in a vehicle it
should be placed in the boot or restrained to prevent
movement following sudden changes in speed/direction.
Inspection and repairs
u Before use, check the appliance for damaged or defective
parts. Check for breakage of parts, damage to switches
and any other conditions that may affect its operation.
u Do not use the appliance if any part is damaged or
defective.
u Have any damaged or defective parts repaired or replaced
by an authorized repair agent.
u Never attempt to remove or replace any parts other than
those specied in this manual.
Safety of others
u This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
This product contains a coin/button cell battery.
@Warning! Keep out of reach of children.
Swallowing can lead to chemical burns,
perforation of soft tissue and death. Severe
burns can occur within 2 hours of ingestion.
Seek medical attention immediately.
u Children must be supervised to ensure that they do not
play with the appliance.
Residual risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
u Injuries caused by touching any rotating/moving parts.
u Injuries caused when changing any parts, blades or
accessories.
u Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods ensure you take regular
breaks.
u Impairment of hearing.
u Health hazards caused by breathing dust developed when
using your tool (example:- working with wood, especially
oak, beech and MDF).
Labels on appliance
The following warning symbols are found on the appliance
along with the date code:
To reduce the risk of injury, the user must read
the instruction manual.
EQ
18
765432
9 10
11 12 13 14
15
4
ENGLISH (Original instructions)
5
ENGLISH
(Original instructions)
Additional safety instructions for batteries and
chargers
Batteries (not supplied)
u Never attempt to open for any reason.
u Do not expose the battery to water.
u Do not store in locations where the temperature may
exceed 40 °C.
Warning! batteries (battery pack or batteries installed) shall
not be exposed to excessive heat such as sunshine, re or the
like.
u Charge only at ambient temperatures between 10 °C and
40 °C.
u When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
u Do not damage/deform the battery pack either by puncture
or impact, as this may create a risk of injury and re.
u Do not charge damaged batteries.
u Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries Carefully wipe the
liquid off using a cloth. Avoid skin contact.
u In case of skin or eye contact, follow the instructions
below.
Warning! The battery uid may cause personal injury or
damage to property. In case of skin contact, immediately rinse
with water. If redness, pain or irritation occurs seek medical
attention. In case of eye contact, rinse immediately with clean
water and seek medical attention.
Caution! Danger of explosion if battery is incorrectly replaced.
Replace only with the Stanley FatMax battery.
Adapter
u Your adapter has been designed for a specic voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the adapter unit with a
regular mains plug.
u Have defective cords replaced immediately.
u Do not expose the adapter to water.
u Do not open the adapter.
u Do not probe the adapter.
u The adapter must be placed in a well ventilated area when
being used.
Electrical safety
#Your adapter is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the adapter
unit with a regular mains plug.
Symbols on Adapter
Short circuit proof safety isolating transformer.
SMPS
The charger is intended for indoor use only.
Features
This appliance includes some or all of the following features.
1. Volume buttons
2. Power button
3. Mode button
4. Preset Toggle button
5. Set Preset button
6. Equalizer/Clock button
7. Bluetooth® button
8. Tune/Seek buttons
9. LCD display
10. Antenna
11. AC adapter port
12. 18v battery port
13. Auxillary port
14. Coin cell battery door
15. AC adapter
Use
remove plastic tab from the coin battery by pulling.
Operating the Radio
Your radio is equipped with memory capacity in order to store
the time and your selected preset channels. When the radio is
in the OFF position, this memory capacity is powered by one
coin cell battery that is included with the radio.
To Replace Coin Cell Battery
Warning! Do not ingest the battery, chemical Burn Hazard.
This product contains a coin/button cell battery. If the coin/
button cell battery is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using
the product and keep it away from children.
If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical attention.
Warning! Danger of explosion if battery is incorrectly
replaced. When replacing battery, replace it with the same or
equivalent type CR2032. Observe correct polarity (+ and –)
when replacing batteries. Do not store or carry batteries so
that metal objects can contact exposed battery terminals.
Warning! To reduce the risk of serious personal injury, turn
tool off and disconnect radio from power source before
installing/changing battery.
u Remove the screw from the coin cell battery door (14).
Remove the door from the radio.
u Install the coin cell battery so that the writing on the
battery faces out away from the radio.
u Replace the battery door and tighten screw.
Note: To reset the LCD display (9), clock and pre-sets,
remove the coin cell battery and reinstall. Follow this
procedure if the screen seems to lock in place.
Power/Volume Adjustment
To operate as a corded product
Insert the AC adapter (15) into the AC adapter port (11), then
plug the adapter into an appropriate AC power outlet or
generator.
To operate as a cordless product
Insert a fully charged 18v Stanley FatMax battery (not
included) into the battery port (12). Be sure battery is fully
seated.
Switching on and off
u To switch the radio on, press the power button (2).
u To switch the radio off, press the power button again (2).
u Press the top volume button (1) to increase the volume. To
decrease the volume, press the bottom volume button.
Note: If the battery is attached to the radio and the AC adapter
is plugged in at the same time, the radio will run off the
adapter and not drain the battery. Having both attached
simultaneously will not charge the battery.
Mode Function
To choose one of the mode functions (FM, AM, AUX, or
Bluetooth®) push the mode button (3) until the desired
function is displayed on the LCD screen. For example, if the
radio is on FM, push the mode button two times to change to
AUX.
Tune or Seek Function
Tune
Press the top tune/seek button (8) to quickly move the tuner
up the frequency band. To move the tuner down the frequency
band, press the bottom tune/seek button.
Seek
Press and hold the top tune/seek button (8), then release to
quickly scan up the frequency band to the next available
station. Press and continue to hold the button to seek directly
to a desired station. Press and hold the bottom tune/seek
button (8), the release to quickly seek down the frequency
band.
Program the Clock
The clock can be programmed with the power on or off.
u Press and hold the equalizer/clock button (6) until the hour
numbers of the digital time ashe on the LCD display (9),
then release the equalizer/clock button.
u Press the tune/scan buttons (8) up or down to set the
hour.
u When the correct hour is set, press the equalizer/clock
button once so the minute numbers ash.
u Press the tune/scan buttons up or down to set the
minutes.
u If you do not press a button within 5 seconds, the clock
programming feature will automatically return to the
previous setting.
u The Clock is set once the numbers stop ashing.
Program the Presets
6 FM and 6 AM radio stations may be independently set. After
programming the buttons, pressing the “1-6” preset toggle
button (4) will instantly change the frequency to the preset
station.
Program the Channels
u Turn power on (2).
u Press the mode button (3) until the desired mode is
selected (AM or FM).
u Tune the radio to the desired station (see Tune or Scan
Function).
u Press and hold the set/preset button (5). The “Mem” icon
will ash in the LCD display (9).
u Press the “1-6” preset toggle button (4) to scroll through
the 6 presets.
u Once it displays the desired preset number, press the set/
preset button.
u Repeat steps 3 through 6 to set the other memory buttons.
Equalizer Button
Set bass and treble
u Press the equalizer/clock button (6) once. The base
equalizer will appear on the LCD display (9).
u Press the up and down volume buttons (1) to set the
desired bass level.
u Press the equalizer/clock button a second time to get to
the treble equalizer.
u Press the up and down volume buttons to set the desired
treble level.
u Press the equalizer/clock button a third time to exit.


Produktspezifikationen

Marke: Stanley
Kategorie: Radio
Modell: FMC770

Brauchst du Hilfe?

Wenn Sie Hilfe mit Stanley FMC770 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Radio Stanley

Bedienungsanleitung Radio

Neueste Bedienungsanleitung für -Kategorien-