SRS DS360 Bedienungsanleitung

SRS Generator DS360

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für SRS DS360 (140 Seiten) in der Kategorie Generator. Dieser Bedienungsanleitung war für 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/140
DS360 Ultra Low Distortion Function Generator Revision 2.9 (09/2021)
Operating Manual and
Programming Reference
Model DS360
Ultra Low Distortion
Function Generator
1290-D Reamwood Avenue
Sunnyvale, CA 94089 U.S.A.
Phone: (408) 744-9040, Fax: (408) 744-9049
email: info@thinkSRS.com • www.thinkSRS.com
Copyright © 1999, 2007, 2008, 2011, 2012, 2013, 2016, 2018, 2020, 2021 by SRS
All Rights Reserved
Certification
Stanford Research Systems certifies that this product met its published specifications at the time
of shipment. Stanford Research Systems further certifies that its calibration measurements are
traceable to the United States National Institute of Standards and Technology (NIST).
Warranty
This Stanford Research Systems product is warranted against defects in materials and
workmanship for a period of one (1) year from the date of shipment.
Service
For warranty service or repair, this product must be returned to a Stanford Research Systems
authorized service facility. Contact Stanford Research Systems or an authorized representative
before returning this product for repair.
Information in this document is subject to change without notice.
Copyright © Stanford Research Systems, Inc.,
1999, 2007, 2008, 2011, 2012, 2013, 2016, 2018, 2020, 2021
All rights reserved.
Stanford Research Systems, Inc.
1290-D Reamwood Avenue
Sunnyvale, California 94089
Printed in USA
i
DS360 Ultra Low Distortion Function Generator
Safety and Preparation for Use
WARNING!
Dangerous voltages, capable of causing injury or death, are
present in this instrument. Use extreme caution whenever the
instrument is cover is removed. Do not remove the cover while
the unit is plugged in to a live outlet.
Caution
This instrument may be damaged if operated with the LINE VOLTAGE SELECTOR set
for the wrong AC line voltage, or if the wrong fuse is installed.
Line Voltage Selection
The DS360 operates from a 100, 120, 220 or 240 Vrms AC power source having a line
frequency of 50 or 60 Hz. Before connecting the power cord to a power source, verify
that the LINE VOLTAGE SELECTOR, located in the rear panel fuse holder, is set so
that the correct AC input voltage is visible.
Conversion to other AC input voltages requires a change in the fuse holder voltage card
position and fuse value. Disconnect the power cord, open the fuse holder cover door and
rotate the fuse-pull lever to remove the fuse. Remove the small printed circuit board and
select the appropriate operating voltage by orienting the printed circuit board so that the
desired voltage is visible when pushed firmly into its slot. Rotate the fuse-pull lever back
into its normal position and insert the correct fuse into the fuse holder.
Line Fuse
Verify that the correct fuse is installed before connecting the line cord. For 100/120
VAC, use two ½ Amp fuses and for 220/240 VAC use two ¼ Amp fuses.
Line Cord
The DS360 has a detachable, three-wire power cord for connection to the power source
and to a protective ground. The exposed metal parts of the instrument are connected to
the outlet ground to protect against electrical shock. Always use an outlet which has a
properly connected protective ground.
Power Switch
The power switch is located on the front panel of the unit, in the lower right hand corner.
Turn on the unit by pressing the switch in.
Fan
The fan in the DS360 is required to maintain proper operation. Do not block the vents in
the chassis or the unit may not operate properly.

Produktspezifikationen

Marke: SRS
Kategorie: Generator
Modell: DS360

Brauchst du Hilfe?

Wenn Sie Hilfe mit SRS DS360 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Generator SRS

SRS

SRS DS335 Bedienungsanleitung

11 August 2023
SRS

SRS DS360 Bedienungsanleitung

11 August 2023

Bedienungsanleitung Generator

Neueste Bedienungsanleitung für -Kategorien-

Fuxtec

Fuxtec FX-IG13 Bedienungsanleitung

13 Oktober 2024
DeWalt

DeWalt DXGNR4000 Bedienungsanleitung

10 Oktober 2024
Parkside

Parkside PSE 2800 B2 Bedienungsanleitung

3 Oktober 2024
Honda

Honda EB3000c Bedienungsanleitung

30 September 2024
Hyundai

Hyundai DHY8000SELR Bedienungsanleitung

29 September 2024
Sun Joe

Sun Joe PPG400 Bedienungsanleitung

29 September 2024
ThermaSol

ThermaSol TFXA-390 Bedienungsanleitung

26 September 2024
ThermaSol

ThermaSol TFXM-390 Bedienungsanleitung

26 September 2024
DeWalt

DeWalt DXGN4500 Bedienungsanleitung

24 September 2024
DeWalt

DeWalt DXGN7200 Bedienungsanleitung

24 September 2024