Soundsphere SS-Q-6 Bedienungsanleitung

Soundsphere Lautsprecher SS-Q-6

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Soundsphere SS-Q-6 (3 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/3
SS-110 Page, SS-110B & SS-Q-6
OWNER’S MANUAL
© 2021 MSE Audio. Rev. 02.25.2021
360º of the Best Sound Around™
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com
Please read the following instructions carefully before installing
your Soundsphere® speaker. If you have any questions
regarding installation that are not answered in the following
directions, please contact your local sound contractor or the
Soundsphere®/MSE Audio® technical support team.
Max Power:
110B: 30 Watts RMS
Q6: 30 Watts RMS
110 Page: 60 Watts RMS
HK Hanging Kit
Hang Mounting from Above
The hanging kit is attached when ordered with the speaker from
the factory. If ordered separately, attach as shown in Diagram 1.
a) Hold the main hook above so the wires and 3 hooks will
be straight as they are clipped on the speaker.
b) Insert the spring clips into the bracket holes as shown.
Attach the top clip to the mounting point making sure that
the clips and cable are not twisted.
MBS Mounting Bracket
Preparing the Speaker
The speaker is prepared for use with the MBS mounting bracket
when both are ordered together from the factory. If ordered
separately, prepare the speaker as shown in orDiagram 2
Diagram 3 Diagram 4and .
a) Begin by removing the plastic ashing from the hole in the
reector rim so that the screw can be inserted from the
outside. Flashing can be removed with a 1/4” drill bit
(Diagram 2), or it can easily be punched through using a
hammer ( ). If using a 1/4” drill bit; be careful not Diagram 3
to remove any material other than the ashing, or the
speaker will not install correctly.
b) Place the stop nut in the pocket as shown in Diagram 4.
Start screw through outside hole, through stop nut
contained in the pocket, and slightly beyond the interior
hole (Diagram 5).
HK
SPRING CLIPS
Diagram 1
Diagram 2
STRIKE FIRMLY
REFLECTOR KNOCK OUT
FLASHING
Diagram 3
Diagram 4
Diagram 5
Installing the Speaker
The steel bracket is pre-fastened to the ceiling or wall, then the
speaker is placed on the bracket and secured in the following
steps ( ):Diagram 6, Diagram 7
a) Fasten the bracket in the desired location, making
sure that it is properly and safely mounted.
b) Slide the side of the reector opposite the screw over
one end of the installed bracket.
c) While holding the screw side against the surface, tighten
the screw until the speaker is resting rmly in position.
Suspended Ceiling T-Bar Mounting
Two Caddy Twist Clips and Twist Nuts are provided for connecting
to suspended ceiling T-bars. Please refer to the enclosedCaddy
Clip T-bar mounting instructions for more details ( ).Diagram 6
a) Place the clips about 8 3/4” apart on the T-bar. Check
to be sure they have snapped on the bar correctly.
b) Slide them into nal position to t through the holes in
the mounting bracket. Tighten the thumb nuts securely.
c) Secure the speaker per , “Installing thesteps b and c
Speaker”.
TWIST CLIP T-BAR MOUNTING
BRACKET
CEILING
SCREW IN
REFLECTOR
Diagram 6 Diagram 7
SS-110 Page, SS-110B & SS-Q-6
OWNER’S MANUAL
© 2021 MSE Audio. Rev. 02.25.2021
360º of the Best Sound Around™
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com
TX-30 Transformer Installation Instructions
The TX-30 is designed for use with the Model 110B or Q-6
loudspeakers. Power taps are provided for 100V, 70V, and 25V
systems:
25V 70V 100V
White 30 Watts --- ---
Orange 15 Watts --- ---
Yellow 7.5 Watts --- ---
Brown 3.8 Watts 30 Watts ---
Blue 1.9 Watts 15 Watts 30 Watts
Violet 0.9 Watts 7.5 Watts 15 Watts
Green 0.5 Watts 3.8 Watts 7.5 Watts
Black Common Common Common
Remember to clip and insulate unused input wires; shorting any
input wire to another will reduce the volume level and place an
unexpected load on the power amplier.
When ordered with the Model 110B or Q-6, the TX-30 is mounted
to the back of the reector and the loudspeaker driver connec-
tions are made at the factory.
Use either black wire for input common or driver (-) connections.
Notes:
- Red or Red with White stripe is 4 ohm tap.
- The total tap wattages should not exceed the amplier’s
capability.
Other System
Model 110B
or
Model Q-6
Loudspeakers
AMPLIFIER (+)
AMPLIFIER (-)
SOUNDSPHERE MODEL 110B OR MODEL
Q-6 LOUDSPEAKERS
RED (+)
RED (+)
BLACK (-)
TX-30 USE EITHER
BLACK WIRE
SELECTED INPUT TAP
COLOR (FROM TABLE)
TX-60 Transformer Installation Instructions
The TX-60 is designed for use with the Model 110 Page
loudspeaker. Power taps are provided for 70V and 100V systems:
70V 100V
Orange 60 Watts ---
Yellow 30 Watts 60 Watts
White 15 Watts 30 Watts
Green Common Common
OTHER SYSTEM
LOUDSPEAKERS
AMPLIFIER (+)
AMPLIFIER (-)
RED (+)
RED (+)
BLACK (-)
TX-60 GREEN WIRE IS
INPUT COMMON
SELECTED INPUT TAP
COLOR (FROM TABLE)
BLACK (-)
Remember to clip and insulate unused input wires; shorting any
input wire to another will reduce the volume level and place an
unexpected load on the power amplier.
Notes:
- Red or Red with White stripe is 4 ohm tap.
- The total tap wattages should not exceed the amplier’s
capability.
SS-110 Page, SS-110B & SS-Q-6
OWNER’S MANUAL
© 2021 MSE Audio. Rev. 02.25.2021
360º of the Best Sound Around™
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com
Warranty
Soundsphere loudspeakers carry a 5 year limited warranty and a 3 year limited warranty on all electrical components. See warranty
sheet for details and limitations.
Replacement Parts
110B 6.5” Dual cone, wide range, 30 Watt Order Model Number FR-6
Q-6 6.5” 30 Watt full range coaxial loudspeaker driver with crossover Order Model Number CX-6
110 Page 6.5” high output, voice-only, 60 Watt Order Model Number ITP-6
Other Information
Wire runs between the amplier(s) and loudspeaker(s) must be of the appropriate gauge to insure the full audio performance capa-
bilities of the Soundsphere loudspeakers. This applies to all loudspeaker impedances (4 or 8 Ohms) or audio line voltages (50, 70.7
or 100 Volts). For more information, please see the ‘Downloads” section at www.soundsphere.com, or call our Customer Service
at 913.663.5600.
Always check local requirements for overhead suspension of loudspeakers.
WARNING
Be sure to securely tighten all hardware before hanging the loudspeaker. Wire rope (steel cable), cable clamps with
saddles and thimbles of suitable size and strength are the recommended materials for overhead suspensions. All
loudspeakers should be redudantly safety wired to structural members of the building with an approved safety wire
system or other agency certied materials.
IMPORTANT: Always check local safety codes before installing any overhead loudspeaker system and for periodic
inspection and maintenance of the installation.

Produktspezifikationen

Marke: Soundsphere
Kategorie: Lautsprecher
Modell: SS-Q-6

Brauchst du Hilfe?

Wenn Sie Hilfe mit Soundsphere SS-Q-6 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Lautsprecher Soundsphere

Soundsphere

Soundsphere SS-Q-8 Bedienungsanleitung

1 September 2024
Soundsphere

Soundsphere SS-Q-12A Bedienungsanleitung

1 September 2024
Soundsphere

Soundsphere SS-Q-6 Bedienungsanleitung

23 März 2024

Bedienungsanleitung Lautsprecher

Neueste Bedienungsanleitung für -Kategorien-

Sonance

Sonance Visual Performance VP65 SST Bedienungsanleitung

16 Oktober 2024
Bowers And Wilkins

Bowers And Wilkins CWM664 Bedienungsanleitung

16 Oktober 2024
Focal

Focal Chorus 826 V Bedienungsanleitung

16 Oktober 2024
KEF

KEF Ci200ER Bedienungsanleitung

16 Oktober 2024
Steren

Steren SPK-1100BL Bedienungsanleitung

16 Oktober 2024
Aiwa

Aiwa SP-A100 Bedienungsanleitung

16 Oktober 2024
Trust

Trust GXT 628 Bedienungsanleitung

15 Oktober 2024
Pyle

Pyle PBMSPG6 Bedienungsanleitung

15 Oktober 2024
Marshall

Marshall Tufton Bedienungsanleitung

15 Oktober 2024
Sunstech

Sunstech SPUBT780 Bedienungsanleitung

15 Oktober 2024