Soundskins SSK-CIVIC4DR Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Soundskins SSK-CIVIC4DR (3 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/3
Sedan Door Kit Instructions
1. Start by locating the fastening hardware on the door
panel, take the appropriate screw driver and remove.
2. Once all the screws are removed you can take off the
door panel gently watching that you don’t break any
of the clips or mounting hardware.
3. Pull the panel away slowly and unplug any electrical
connections.
Soundskins USA
13452 Alondra Blvd, Cerritos, Ca 90703
Phone: 562.689.5151
Email: info@soundskinsglobal.com
www.SoundSkinsGlobal.com
5. When the surface is dry and clean, locate the
piece of the kit with the label on the back that coincides
with the door you’re working on. Make sure it lines up and
is correct before you pull the white cover paper off. After
you confirm the right piece, pull off the white paper and
start placing the material at the top and work your way
down. Most important is that the material is pushed down
completey and that no air is trapped. Use a razor blade
point or household needle to release air. Repeat these
steps for all door panels.
4. Now you are ready to prep the metal surface
using a microfiber cloth, Acetone (use a breathing mask),
and wipe away any moisture, oil, debris or etc. Then let air
dry for an appropriate time. The point is to get the surface
clean to ensure material glue contact.
6. Now you are ready to place the door panel back on your
door. All necessary openings will be available after you
have applied the Soundskins material. Secure door panel
with all screws and you are now ready to hit the road.
ENJOY!
Recommended Installation Instructions
A. Prepping the Surface
After removing interior door panels you are ready to clean the metal areas that will be insulated. If the metal
has “new” look without imperfections then take a microfiber cloth and wipe away any dust and debris. If the metal
is showing signs of age like rust then we recommend using Acetone with a breathing mask to wipe off debris and
loose particles. A shop vacuum might be needed to remove loose debris on the floorboard.
B. Installing Panels
Now that you have a clean surface you are ready to start applying the sheets. We recommend a roller to release
air pockets that might be lingering from trapped air. You want to make sure that you have rolled those out to the
edge and all the material has a good seal to the metal surface. Make sure all pieces are installed and inspected
before reinstalling the interior.
1) Driver Front Door Panel 3) Passenger Front Door Panel
2) Driver Rear Door Panel 4) Passenger Rear Door Panel
4 Piece Custom Cut PRO KIT
2016-2021
1
2
3
4


Produktspezifikationen

Marke: Soundskins
Kategorie: Nicht kategorisiert
Modell: SSK-CIVIC4DR

Brauchst du Hilfe?

Wenn Sie Hilfe mit Soundskins SSK-CIVIC4DR benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Soundskins

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-