Sonance Garden SGS Subwoofer Bedienungsanleitung

Sonance Lautsprecher Garden SGS Subwoofer

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung fĂŒr Sonance Garden SGS Subwoofer (9 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war fĂŒr 13 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/9
SONANCE GARDEN SERIES
SGS SYSTEM
I N ST R U C T I O N M A N UA L
TABLE OF CONTENTS
Design and Features 2
Introduction 2
Box Contents 2
Speaker Layout Planning 2
Types of Wire 3
Speaker Installation 3
Connecting the Speakers 3
Recommended Tools 5
Speaker Wire Connection 5
Subwoofer Wire Connection 6
Specications  7
Warranty 8
SGS SAT
Satellite Speaker
Speaker Layout Planning
The SONANCE SGS SYSTEM is designed to deliver a seamless,
evenly dispersed sound eld in an ‘open air’ environment. A daisy
chain of multiple satellite speakers and a subwoofer should be
strategically placed to create even, balanced coverage, minimizing
‘hot spots’ and ‘cold spots’ around the outdoor entertainment area
(see Figure 1).
The satellite speakers should be placed from 8 to 10 feet
(2.4 - 3 meters) apart for best coverage. To achieve the best
balance between the satellites and subwoofer, the subwoofer
should be placed as close to the center of the satellites as possible.
Subwoofer Bottom Amp Plate
Figure 2 shows the controls and connections located on the
subwoofer bottom amp plate.
Box Contents
SONANCE SGS SYSTEM box contains:
(8) Satellite speakers with vertical pivoting knuckle
(8) Removeable speaker stakes with 1/2”
NPS threading
(1) In-Ground subwoofer
Introduction
Thank you for purchasing the SONANCE GARDEN SERIES SGS
SYSTEM. When properly installed, this system will provide you with
years of outdoor entertainment pleasure. To get the most out of
your new system, please read this manual thoroughly before you
begin installation.
SGS SUB
In-Ground Subwoofer
Figure 1: Wiring Diagram
If more bass is required, placing the subwoofer near a wall or other
solid structure will greatly reinforce the low bass frequencies.
In some cases you may want to place the subwoofer closer to your
primary listening position or add a second Sonance Garden Series
subwoofer.
The satellites in the SONANCE SGS SYSTEM individually present
a 30 ohm load to the amplier. When 4 of them are connected
on each amplier channel in parallel, the load to the amplier is
approximately 7.5 ohms. The satellites and subwoofer both feature
internal crossovers so the subwoofers impedance is not combined
with the satellites. The overall load presented to your amplier by
the SONANCE SGS SYSTEM will be around 7.5 ohms nominal.


Produktspezifikationen

Marke: Sonance
Kategorie: Lautsprecher
Modell: Garden SGS Subwoofer

Brauchst du Hilfe?

Wenn Sie Hilfe mit Sonance Garden SGS Subwoofer benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Lautsprecher Sonance

Bedienungsanleitung Lautsprecher

Neueste Bedienungsanleitung fĂŒr -Kategorien-