Scansonic S12 Active Sub Bedienungsanleitung

Scansonic Lautsprecher S12 Active Sub

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Scansonic S12 Active Sub (11 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war für 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/11
H I F I L O U D S P E A K E R S S12
02
06
08
OWNER’S MANUAL
TROUBLESHOOTING
LIMITED WARRANTY
S12
H I F I L O U D S P E A K E R S
S12
Introduction
Thank you for choosing Scansonic loudspeakers, we hope they
will bring you many years of enjoyment.
Please read this manual fully before unpacking and installing
the product.
Carton contents
During production and packing we have carefully checked and
inspected this subwoofer.
After unpacking please check for any damage from transport.
We recommend that you keep the original cartonbox and
packing material for any future shipping.
In the cartonbox you will find:
1 Input cable, RCA phono type
Loudspeaker installation
The subwoofer requires connection to the mains power supply,
so for your safety it is important that you read both this manual
and the amplifier manual before connecting.
Subwoofer positioning
Variations in placement of your loudspeakers can produce
dramatic differences in the way music sounds. No listening
rooms are the same and therefore we encourage you to spend
some time experimenting with which placements work best in
your listening room. Position of subwoofers are however less
critical compared with full-range loudspeakers because the low
frequencies reproduced by a subwoofer are difficult to locate
in the room. Trust your ears and be willing to experiment freely.
You can start with our basic recommendations.
To begin with, the subwoofer should be positioned between the
TV and one of your front loudspeakers. Fig. 1 - 3.
Connecting your subwoofer
We recommend that you read the manual of your amplifier or
AV-receiver carefully before connecting your subwoofer.
First switch off amplifier and all equipment when connecting
your subwoofer.
Connect the subwoofer input IN (5) and your amplifiers SUB out
with the enclosed RCA phono cable.
Connect the subwoofer net cable (3) to the mains voltage ,
and push the POWER ON/OFF button (1) to ON position, the
indicator lamp POWER LED (6) will now glow green and the
subwoofer is active and ready to be used. Fig. 4.
The Scansonic S12 subwoofer has a built-in AUTO STANDBY
function and after approximately 5 minuttes without any input
signal the subwoofer will automatically switch off, and the
indicator lamp POWER LED (6) will glow red. When an input
signal is detected the subwoofer will become active and the
indicator lamp POWER LED (6) will glow green.
Setting volume, frequency, bass extension and phase
The volume, frequency, bass extension and phase (controls
8, 9, 10 and 11) can be adjusted on the rearpannel, and we
recommend that you adjust the setting of these controls to
your liking – try with different music and films. If you want more
detailed informations on these control functions, we invite you to
visit our homepage www.scansonic.dk.
Running-in period
We recommend a running-in time of your new Scansonic S12
subwoofer of approximately 15-20 hours at normal listening
level before you decide on the final positioning and controls
settings of the subwoofer . During the running-in time the drive
units will settle in and perform as intended.
Care and cleaning
We don’t recommend use of any solvents or cleaners on
Scansonic S12 lacquered cabinets, the cabinet surface usually
only requires dusting or cleaning with a soft cloth (do not use
water).
The grille fabric may be cleaned with a normal clothes brush or
vacuumed carefully with the grille detached from the cabinet.
Avoid touching the woofer drive unit, and do not use the
subwoofer as a coffee or drinks table (risk of water being spilled
into the subwoofer).
Disconnect the subwoofer from the mains supply if taken out of
use for a longer period.
Environmental information
Scansonic S12 subwoofer comply with international directives
on the Restriction of Hazardous Substances (RoHS) in
electrical and electronic equipment and the disposal of Waste
Electrical and Electronic Equipment (WEEE) - the crossed bin
symbol indicates compliance and that the products must be
appropriately recycled or processed in accordance with these
directives.
Owner ’s manual
H I F I L O U D S P E A K E R S
S12
sub
sub
sub
fig. 1 surround 5.1 fig. 2 surround 6.1 fig. 3 surround 7.1

Produktspezifikationen

Marke: Scansonic
Kategorie: Lautsprecher
Modell: S12 Active Sub

Brauchst du Hilfe?

Wenn Sie Hilfe mit Scansonic S12 Active Sub benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Lautsprecher Scansonic

Scansonic

Scansonic S5 BTL Active Bedienungsanleitung

22 August 2024
Scansonic

Scansonic S6 Bedienungsanleitung

18 August 2024
Scansonic

Scansonic S8 Active Sub Bedienungsanleitung

17 August 2024
Scansonic

Scansonic Q1000 Bedienungsanleitung

17 August 2024
Scansonic

Scansonic S12 Active Sub Bedienungsanleitung

17 August 2024
Scansonic

Scansonic S5 Active Bedienungsanleitung

14 August 2024
Scansonic

Scansonic S5 BT Active Bedienungsanleitung

10 August 2024
Scansonic

Scansonic M7 Bedienungsanleitung

8 August 2024
Scansonic

Scansonic S4 Bedienungsanleitung

1 August 2024

Bedienungsanleitung Lautsprecher

Neueste Bedienungsanleitung für -Kategorien-

Sonance

Sonance Visual Performance VP65 SST Bedienungsanleitung

16 Oktober 2024
Bowers And Wilkins

Bowers And Wilkins CWM664 Bedienungsanleitung

16 Oktober 2024
Focal

Focal Chorus 826 V Bedienungsanleitung

16 Oktober 2024
KEF

KEF Ci200ER Bedienungsanleitung

16 Oktober 2024
Steren

Steren SPK-1100BL Bedienungsanleitung

16 Oktober 2024
Aiwa

Aiwa SP-A100 Bedienungsanleitung

16 Oktober 2024
Trust

Trust GXT 628 Bedienungsanleitung

15 Oktober 2024
Pyle

Pyle PBMSPG6 Bedienungsanleitung

15 Oktober 2024
Marshall

Marshall Tufton Bedienungsanleitung

15 Oktober 2024
Sunstech

Sunstech SPUBT780 Bedienungsanleitung

15 Oktober 2024