Sanus VMCA1 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Sanus VMCA1 (1 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 8 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/1
Assembly Instructions for Model: VMCA1b-01
Thank you for choosing a Sanus Systems VisionMount™ accessory. The Ceiling Plate is designed for ease of installation
with any height of drop ceiling. By using any length of standard NPT 1½” pipe threaded both ends, you can extend the height
capabilities to meet your needs.
WARNING: If you do not understand these directions, or have any doubts about the safety of the installation, please
contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective
parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged
parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. Never use
defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that
is not explicitly speciîšżed by Sanus Systems. Sanus Systems can not be liable for damage or injury caused by incorrect
assembly, or incorrect use. Please contact Sanus Systems before returning products to the point of purchase.
WARNING: Improper installation may result in serious personal injury. When mounting Sanus accessories, the
structural system and mounting method must be capable of supporting îšżve (5) times the combined weight of the
total installation. The maximum weight to be installed on the Ceiling Plate is 500 lbs. [226.8 Kg].
Parts List:
(1) 4” Flat Ceiling Plate CMA-101 (1) 5/16-18 x 3/8” Security Set Screw Socket Set Screw,
(1) 5/16-18 x 3/8” Socket Set Screw (1) 5/32” Hex Wrench
1. Securely install the ceiling plate to the ceiling joist. Bolt hole spacing is shown in Diagram 1. If using only two holes for
mounting, you must use opposing holes.
2. Thread your NPT1-1/2” pipe into the coupler; then, tighten securely.
3. Install and securely tighten the 5/16-18 x 3/8” Socket Set Screw or, if desired, the Security Set Screw.
4. Follow the Ceiling Mount Instruction mating components or mounts.
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 (6901-100144<00>)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Diagram 1
2.00”
4.00”
5.00”
2.00”
4.00”
5.00”
0.69”
1-1/2” NPS
Opposing Holes


Produktspezifikationen

Marke: Sanus
Kategorie: Nicht kategorisiert
Modell: VMCA1

Brauchst du Hilfe?

Wenn Sie Hilfe mit Sanus VMCA1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Sanus

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-