Sagem RM50 Bedienungsanleitung

Sagem Radio RM50

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Sagem RM50 (120 Seiten) in der Kategorie Radio. Dieser Bedienungsanleitung war fĂĽr 8 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/120
WELCOME
Dear customer:
Thank you for purchasing a Sagemcom WiFi IP Radio; we appreciate your trust in us.
This product was manufactured with the upmost care, should you encounter any difficulties during its use, we recommend that you
refer to this user guide. You can also find information on the following site:
http://support.sagemcom.com
The new material is guaranteed (parts and labour) by Sagemcom under the conditions and according to procedures defined on the
site www.sagemcom.com heading support.
The Sagemcom site ( assistance section) also provides information on how your IP Radio works and how to www.sagemcom.com
solve any problems you may encounter. You can also contact our assistance service by E-mail. If the problem persists, you should
contact our call centre (see the table below). They will offer an expert appraisal of your material remotely to determine the cause as
well as the type of repair required.
For your comfort and safety, please read carefully the paragraphs below on safety recommendations and instructions.
Internet Radio RM50 - Quick Start Guide
253300735A
Quick Start Guide Internet Radio RM50
- 2 -
RECOMMENDATIONS AND SAFETY INSTRUCTIONS
Do not install your IP Radio in a humid room (bathroom, laundry, kitchen, etc.), or within 1.50mof a tap or water source, or outside. Your IP Radio should be used at an
ambient temperature of between 15 °C and 35 °C for optimum sound results.
Do not set up your IP Radio in a dusty environment as dust deposits might adversely affect the sound quality.
Avoid objects or liquids getting into the unit.
Unplug the power lead if the unit will not be used for a long period.
Do not handle your AC cord with wet hands. If liquid spills on your product, unplug immediately and contact your dealer for cleaning instructions.
Only the power supply provided with the IP Radio should be used. Connect this to the mains in accordance with the installation instructions in this user guide and the information
on the identification label affixed to the power supply (voltage, current, mains frequency). As a precaution, in case of danger, the mains adapters act as a disconnecting
mechanism for the 230 V power supply. They should be placed near the device and should be easily accessible.
Do not attempt to use force to plug a connector into the audio jack. If the connector cannot be plugged into the jack easily, the connector is incompatible.
Do not attempt to remove any screws or open the unit. No user serviceable parts are inside.
The length of the USB cables used on this product shall not exceed 3m.
This terminal was designed for private use inside a building (CPE customer premises equipment) in the European Free Trade association (EFTA). It has been tested in
accordance with the technical provisions for radio equipment (EN 300328).
The radio frequency bands authorized for Wireless transmission depend on national regulations. The installation of this terminal operating in the 2.4 GHz band is covered by the
European recommendation ERC 70-03.
Before use, make sure that the gateway with which you establish a wireless connection from your terminal is set up in accordance with this regulation and with the national
regulations where it is used.
Sagemcom no liability if the regulations in force on the installation site are not complied with.
Some sensitive medical equipment and safety equipment may be affected by the radio-frequency transmissions of your radio. In all cases, we ask that you respect the safety
recommendations.
The device shall not permanently be installed or used closer than 20 cm from the human body.
The CE marking certifies that the product meets the essential requirements of Directive 1999/5/CE of the European Parliament and of the Council pertaining to microwave radio
equipment and telecommunication terminal equipment, for the safety and health of users, for electromagnetic interference. Furthermore, it efficiently uses the frequency
spectrum attributed to ground and spatial communication to prevent damaging interference.
The declaration of compliance may be looked up on the www.sagemcom.com site or can be obtained from the following address:
Sagemcom - Customer relations department
250, route de l'Empereur - 92848 Rueil-Malmaison – FRANCE
Internet Radio RM50 Quick Start Guide
- 3 -
1. Display Screen Displays contents on the screen.
2. PRESETS [1] Press and hold to display a list of available FM stations.
[2] Press to activate auto/manual scan.
3. MODE Displays the Mode menu.
4. VOL. Enables volume control on the Wheel.
5. MENU Displays the submenu.
6. STATIONS [1]Press to displays the Favorite List
[2]Press and hold to add/remove stations to/from the Favorite List.
7. Navigation Wheel [1] In playback screen, rotate to increase/decrease the volume. Press to mute the audio
volume.
[2] Navigate in the menu list. Press to enter or confirm the highlighted item in the menu list.
8. C [1] Act as the BACK/CANCEL button in all display screens.
[2] Act as the STOP button in the playback screen.
9. INFO [1] While listening to an IP Radio music source, press to switch the display the music
information.
[2] While listening to the IP Radio, press and hold to set “auto tune”, which allows you to set a
tuned station to play again at a certain time.
10. S R S (SMART RANDOM SWITCH) - Switch randomly to a new station.
11. S R T (SMART RANDOM THEME) - Displays a list of all existing themes defined by Internet Radio.
Front Panel
1
23 4 56
7
8
9
10
11
12 12
11
12. Speakers Provides music sound output.
1. POWER [1] Press to shut off the music source currently playing and put the device into the Standby
mode.
[2] Press and hold to put the device in the Power off mode.
2. USB Port Connection to USB devices.
3. 5V DC Power Jack Plug in the power adaptor.
4. Audio Line Out Jack
Left/Right Plug in external speakers.
Rear Panel
5V DC
R AUDIO L
1
2 3 4 5
5. Headset Jack Plug in an external headset. Speakers do not function while headset is plugged in.


Produktspezifikationen

Marke: Sagem
Kategorie: Radio
Modell: RM50
Anzahl der Farben des Displays: Monochrom
Eingebaute Lautsprecher: Ja
Kopfhörer-Anschluss: 3,5 mm
Produktfarbe: Schwarz
Ăśbertragungstechnik: Kabellos
Radiotyp: Internet
Anzahl eingebauter Lautsprecher: 2
Anzahl USB 2.0 AnschlĂĽsse: 1
Lautstärkeregler: Drehregler
Farbe der Hintergrundbeleuchtung: WeiĂź
Adapter-Typ: AC/DC

Brauchst du Hilfe?

Wenn Sie Hilfe mit Sagem RM50 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Radio Sagem

Bedienungsanleitung Radio

Neueste Bedienungsanleitung fĂĽr -Kategorien-