Rupert Neve Designs Portico II Bedienungsanleitung
Rupert Neve Designs
Prozessor
Portico II
Lesen Sie kostenlos die đ deutsche Bedienungsanleitung fĂŒr Rupert Neve Designs Portico II (22 Seiten) in der Kategorie Prozessor. Dieser Bedienungsanleitung war fĂŒr 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/22
1
Operations Manual
By:
Serial #:
2
Portico II Channel User Guide
Thank you for your purchase of a Portico II Channel module.
Everyone at Rupert Neve Designs hope you enjoy using this tool as much as we have enjoyed
designing and building it. The name âPortico IIâ will be used for a series of new ultra-high end
professional products that will share some traits. Please take note of the following list of safety concerns
and power requirements before the use of this or any Portico II Series product.
Safety
Itâs usual to provide a list of âdoâs and donâtsâ under this heading but mostly these amount to
common sense issues. However, here are important safety requirements that must be adheared to:
Heat generated by the Channel module is radiated through the case work and by convection through the
ventilation holes, therefore the holes should not be covered or blocked. To avoid overheating,
Portico II units should not be stacked immediately above or adjacent to other equipment that
gets hot, and one rack space above the unit should be left open for heat ventilation.
Also bear in mind that other equipment may radiate strong hum îelds which could spoil
the performance of your Portico II module.
Protect the power cord from being walked on or pinched, particularly at plugs convenience receptacles
and the point where they exit from the apparatus. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type
plug has two blades and a third grounding prong. The wide blade or the third prong are provided for
your safety. Unplug the module during lightning storms or when unused for long periods of time.
Donât operate your Portico II module in or around water! Electronic equipment and liquids are not
good friends. If any liquid is spilled, such as soda, coffee, alcoholic or other drink, the sugars and
acids will have a very detrimental effect. Sugar crystals act like little rectiîers and can produce
noise (crackles, etc.). SWITCH OFF IMMEDIATELY because once current starts to î
ow the
mixture hardens, can get very hot (burnt toffee!) and cause permanent and costly damage. If it gets
wet and you suspect that good clean water may have gotten in, immediately unplug the unit, and
remove it from the source of water. Please contact support as soon as possible at
support@rupertneve.com for resolution. Clean only with dry cloth.
Donât be tempted to operate a Portico II unit with the cover removed. The cover provides magnetic
screening from hum and R.F. stray îelds.
Power Requirements
Each Portico II unit has a high quality, low noise switching power supply that is further îltered and shunt
regulated for an exceptionally quiet and reliable power source for the audio circuits. The power sup-
ply is considered âuniversalâ in the sense that it will accept 100V through 240V AC and complies with
standard mains voltages around the world. Be absolutely sure to disconnect mains power (remove the
power cable from the IEC power connector at the back panel) before checking the fuse. The fuse is lo-
cated in the IEC power input connector and is accessed by opening the small panel labeled âFUSEâ. The
fuse should always be replaced with the correct value and type. The Portico II power supply requires a
5x20 mm 2.5 amp fast acting ceramic body fuse Bussman type GDA 2.5A or equivalent.
3
The fuse is a protection device intended to prevent additional damage or hazard if the Portico II unit de-
velops a problem. However sometimes a fuse may âpopâ due to a mains surge and need to be replaced
(it probably did protect the Portico II). The symptom of a blown fuse is simply that the unit does not
power up. Disconnect the power cable, try replacing the fuse, re-insert the power cable, push the âPow-
erâ button. If this does not solve the problem or the fuse âpopsâ again there may be a problem with the
Portico II you should contact your dealer or email < > or support@rupertneve.com phone 512-847-3013.
Gain
0-66dB
DI
Detect
Line Trim
+/-6dB
HPF
In
EQ Pre / Post
EQ Compressor
Phase
Reverse
LF In
LMF / HMF
In HF In
GR METER
Comp In
Silk
Silk +
Texture
Mute
Output
METER
Send
Return
LinkSidechain
All EQ
In
From
Sidechain
To
Sidechain
S/C
HPF
HPF
(Auto)
De-ess
HMFLMF HF
LF
Output
+48V
PORTICO II
CHANNEL STRIP
Portico II Channel: Block Diagram
Produktspezifikationen
| Marke: | Rupert Neve Designs |
| Kategorie: | Prozessor |
| Modell: | Portico II |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Rupert Neve Designs Portico II benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Prozessor Rupert Neve Designs
27 September 2024
2 August 2024
22 Juli 2024
15 Februar 2024
8 Oktober 2022
Bedienungsanleitung Prozessor
- Prozessor Asus
- Prozessor HP
- Prozessor Roland
- Prozessor Yamaha
- Prozessor Black And Decker
- Prozessor Pyle
- Prozessor Golden Age Project
- Prozessor Bose
- Prozessor Shure
- Prozessor Zoom
- Prozessor TOA
- Prozessor Lenovo
- Prozessor AMD
- Prozessor Alpine
- Prozessor Lexicon
- Prozessor Fujitsu
- Prozessor TC Helicon
- Prozessor Digitus
- Prozessor DataVideo
- Prozessor Allen & Heath
- Prozessor Arturia
- Prozessor Warm Audio
- Prozessor Bogen
- Prozessor DBX
- Prozessor Hikvision
- Prozessor Radial Engineering
- Prozessor ART
- Prozessor Fredenstein
- Prozessor LD Systems
- Prozessor Summit Audio
- Prozessor Black Lion Audio
- Prozessor Solid State Logic
- Prozessor Chandler
- Prozessor Helix
- Prozessor Phoenix Gold
- Prozessor AMX
- Prozessor Siig
- Prozessor Amiko
- Prozessor Rane
- Prozessor Intel
- Prozessor RGBlink
- Prozessor Smart-AVI
- Prozessor Neutrik
- Prozessor Gefen
- Prozessor Christie
- Prozessor Atlas Sound
- Prozessor Lectrosonics
- Prozessor Eventide
- Prozessor KanexPro
- Prozessor SPL
- Prozessor BZBGear
- Prozessor AudioThing
- Prozessor Metric Halo
- Prozessor Sonifex
- Prozessor Manley
- Prozessor Lindell Audio
- Prozessor BSS Audio
- Prozessor Ashly
- Prozessor Heritage Audio
- Prozessor Matrox
- Prozessor Drawmer
- Prozessor Vivolink
- Prozessor MuxLab
- Prozessor Avenview
- Prozessor Datapath
- Prozessor SEADA
- Prozessor CEDAR
- Prozessor Mathew Lane
- Prozessor Dangerous Music
- Prozessor Empirical Labs
- Prozessor FabFilter
- Prozessor Henry Engineering
- Prozessor MyMix
Neueste Bedienungsanleitung fĂŒr -Kategorien-
2 Oktober 2024
21 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
5 September 2024