RCBS Partner Press Bedienungsanleitung

RCBS Nicht kategorisiert Partner Press

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für RCBS Partner Press (16 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/16
PARTNER
PRESS
P R O D U C T I N S T R U C T I O N S
IMPORTANT
Before using the RCBS , read this instruction manual carefully to fully learn how to Partner Press
safely operate the scale. Failure to properly operate the scale can result in severe personal injury
and/or equipment damage. If you have read these instructions and still do not understand some
operation, call us at 1-800-533-5000 and a technician will assist you.
This instruction manual contains specific safety and operating information. It should be considered a
permanent part of your reloading equipment and remain with the equipment at all times for easy
reference.
SAFETY
Reloading is an enjoyable and rewarding hobby that can be conducted safely. But, as with any
hobby, carelessness or negligence can make reloading hazardous. This product has been designed
from the beginning with the user’s safety in mind. When reloading, safety rules must be followed. By
observing these rules, the chance of a hazardous occurrence causing personal injury or property
damage is minimized.
GENERAL
Use all equipment as the manufacturer recommends. Study the instructions carefully and become
thoroughly familiar with the operation of the product. If you do not have written instructions, request
a copy from the equipment manufacturer.
Don’t take short cuts. Attempting to bypass established procedures is an invitation to an accident.
Observe “good housekeeping” in the reloading area. Keep tools and components neat, clean and
orderly. Promptly and completely clean up primer and powder spills.
Reload only when you can give your undivided attention. Do not reload when fatigued or ill, or
under the influence of medications or alcohol. Develop a reloading routine to avoid mistakes which
may prove hazardous. Don’t rush - load at a leisurely pace.
Always wear adequate eye protection to protect your eyes from flying particles. You assume
unnecessary risk when reloading without wearing safety glasses.
LOADING DATA
Use only laboratory tested reloading data. We highly recommend the SPEER Reloading Manual.
OBSERVE ALL WARNINGS ABOUT THE USE OF MAXIMUM LISTED LOADS.
PRIMERS AND POWDER
Store primers and powder beyond the reach of children and away from heat, dampness, open
flames and electrical equipment. Avoid areas where static electricity is evident.
Do not use primers of unknown identity. Scrap unknown primers in accordance with applicable
regulations.
Keep primers in the original factory container until ready to use. Return unused primer to the same
factory packaging for safety and to preserve their identity. Primer packaging is designed to provide
safe storage.
DO NOT store primers in bulk. The blast of just a few hundred primers is sufficient to cause
serious injury to anyone nearby.
DO NOT force primers. Use care in handling primers.
DO NOT have more than one can of powder on the bench at one time. Powder cans should be
stored away from the bench to avoid picking up the wrong one.
DO NOT use any powder unless its identity is positively known. The only positive
identification is the manufacturer’s label on the original canister. Discard all mixed powders    
and those of uncertain identity.
If you use a powder measure, replace the lids on both the powder hopper and powder can
after the powder hopper has been filled.
When using a powder measure, settle the powder in the powder hopper before charging any
cases. Throw and check the weight of at least ten charges. This will assure you that the correct
powder charge is being thrown.
When you finish a reloading session, pour any remaining powder back into its original factory
container. This will preserve the identity and shelf life of the powder.
DO NOT smoke while reloading.
RECORD KEEPING
Keep complete records of reloads. Apply a descriptive label to each box showing the date
produced, and the primer, powder and bullet used. Labels for this purpose are packed with
SPEER bullets. Never attempt to guess at the identity of your ammunition.
INTRODUCTION
The Partner Press was specifically designed for the beginning reloader. With the Partner you can
reload your favorite rifle and pistol ammo – from the magnums down to .17 caliber. Because of the
patented RCBS compound leverage system and block “O” frame you can easily full-length size
cases with less effort than other presses need to neck size. The standard / -14 top thread allows the
use of many RCBS accessories.
The primer arm on the Partner Press is equipped with interchangeable primer plugs and sleeves
for seating large and small primers. The primer arm swings out of the way when not in use.
RELOADING DIE
HANDLE
PRIMER ARM
SHELL HOLDER


Produktspezifikationen

Marke: RCBS
Kategorie: Nicht kategorisiert
Modell: Partner Press

Brauchst du Hilfe?

Wenn Sie Hilfe mit RCBS Partner Press benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert RCBS

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-