Rane DA216S Bedienungsanleitung
Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Rane DA216S (6 Seiten) in der Kategorie Splitter. Dieser Bedienungsanleitung war fĂĽr 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/6
DA216S
DISTRIBUTION AMPLIFIER
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
To reduce the risk of electrical shock, do not open the unit. No user
serviceable parts inside. Refer servicing to qualied service personnel.
e symbols shown below are internationally accepted symbols
that warn of potential hazards with electrical products.
is symbol indicates that a dangerous voltage
constituting a risk of electric shock is present
within this unit.
is symbol indicates that there are important
operating and maintenance instructions in the
literature accompanying this unit.
WARNING
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, registers, stoves, or other apparatus (including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A
grounding-type plug has two blades and a third grounding prong. e wide blade or third prong is provided for your safety. If the provided plug
does not t into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord and plug from being walked on or pinched particularly at plugs, convenience receptacles, and the point where it exits from
the apparatus.
11. Only use attachments and accessories specied by Rane.
12. Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply
cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
15. e plug on the power cord is the AC mains disconnect device and must remain readily operable. To completely disconnect this apparatus from
the AC mains, disconnect the power supply cord plug from the AC receptacle.
16. is apparatus shall be connected to a mains socket outlet with a protective earthing connection.
17. When permanently connected, an all-pole mains switch with a contact separation of at least 3 mm in each pole shall be incorporated in the
electrical installation of the building.
18. If rackmounting, provide adequate ventilation. Equipment may be located above or below this apparatus, but some equipment (like large power
ampliers) may cause an unacceptable amount of hum or may generate too much heat and degrade the performance of this apparatus.
19. is apparatus may be installed in an industry standard equipment rack. Use screws through all mounting holes to provide the best support.
WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain or moisture. Apparatus shall not be exposed to dripping
or splashing and no objects lled with liquids, such as vases, shall be placed on the apparatus.
NOTE: is equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
ese limits are designed to provide reasonable protection against harmful interference in a residential installation. is equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modications not expressly approved by Rane Corporation could void the user's authority to operate the equipment.
is Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
WARNING: is product may contain chemicals known to the State of California to cause cancer, or birth defects or other reproductive harm.
Manual-1
DA216S
DISTRIBUTION AMPLIFIER
OPERATORS MANUAL
Quick Start
is section is for those that just can’t wait to get started. is
Distribution Amplier has a powerful feature not found on most
DA’s – Output assignment switches. If your application calls
for a single channel set-up with one Input driving all Outputs,
set all of the switches to the appropriate Input ( ). To mix A or B
both inputs, set them all to . In this mode, both Inputs drive A+B
all Outputs with the Inputs summed. e MASTER LEVEL
controls set the input level. indicators Occasionally blinking OL
are okay. e individual controls set the level OUTPUT LEVEL
for each Output channel.
For a stereo application, decide how the stereo Outputs are to
be assigned and set the assignment switches accordingly. Eight
stereo outputs are possible.
Set the back panel switches for either LINE or MIC Inputs.
When using microphones that require a “phantom” voltage, turn
WEAR PARTS: is product contains no wear parts.
DA216S
DISTRIBUTION
AMPLIFIER
POWER
MASTER LEVELS
1
OUTPUT LEVELS
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
A
B
on the switch, illuminating its rear panel PHANTOM POWER
LED. Because the phantom voltage is applied to both Inputs,
don’t mix phantom powered and non-phantom powered mics in
the same DA216S. Never engage the phantom voltage when using
an unbalanced mic—doing so may damage the mic. If the mic is
too “hot”, press the switch to reduce the gain INPUT GAIN in
by 20 dB. Incidentally, the INPUT PAD switch reduces the gain
40 dB when in the ). When using the LINE position (pressed in
Inputs for line-level, pressing in both the INPUT PAD and the
INPUT GAIN switches provides a nominal gain of 0 dB. An
additional 16 dB of gain is available when both the MASTER
LEVEL and OUTPUT LEVEL controls are turned all the way
up (clockwise).
e internal universal supply allows operation in almost any
part of the world. All that is required in dierent countries is the
correct IEC line cord.
Produktspezifikationen
Marke: | Rane |
Kategorie: | Splitter |
Modell: | DA216S |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Rane DA216S benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Splitter Rane
19 August 2024
13 Dezember 2023
Bedienungsanleitung Splitter
- Splitter Samsung
- Splitter Audio-Technica
- Splitter Manhattan
- Splitter Nedis
- Splitter König
- Splitter Shure
- Splitter Hyundai
- Splitter Scheppach
- Splitter Icy Box
- Splitter Lindy
- Splitter Tripp Lite
- Splitter Marmitek
- Splitter Furuno
- Splitter Black Box
- Splitter ACG
- Splitter Zipper
- Splitter Behringer
- Splitter Monacor
- Splitter Fujitsu
- Splitter D-Link
- Splitter IDEAL
- Splitter Audiovox
- Splitter NewStar
- Splitter Digitus
- Splitter LevelOne
- Splitter APC
- Splitter Akasa
- Splitter IFM
- Splitter Kramer
- Splitter Sun Joe
- Splitter AMX
- Splitter Siig
- Splitter StarTech.com
- Splitter Fun Generation
- Splitter Botex
- Splitter Gefen
- Splitter Aluratek
- Splitter ASSMANN Electronic
- Splitter ATen
- Splitter KanexPro
- Splitter SmartAVI
- Splitter Crestron
- Splitter Magenta
- Splitter Atlona
- Splitter CLUB3D
- Splitter Rolls
- Splitter WyreStorm
- Splitter Key Digital
- Splitter Televes
- Splitter ACT
- Splitter Omnitron Systems
- Splitter Rose Electronics
- Splitter MuxLab
- Splitter C2G
- Splitter Club 3D
- Splitter Klover
- Splitter Comprehensive
Neueste Bedienungsanleitung fĂĽr -Kategorien-
4 Oktober 2024
4 Oktober 2024
2 Oktober 2024
29 September 2024
24 September 2024
23 September 2024
20 September 2024
16 September 2024
11 September 2024
8 September 2024