Randall RG3003H Bedienungsanleitung
Randall
Verstärker
RG3003H
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Randall RG3003H (2 Seiten) in der Kategorie Verstärker. Dieser Bedienungsanleitung war für 22 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/2
A M P L IFIE R S
RM50/RM80
M O D U L A R T U B E C O M B O S
O W N E R S M A N U A L
RANDALL RG3003H
300 Watts @ 4 Ω
3 Channels with Gain and Level
Integrated Noise Gate with Threshold
EQ with Bass,Mid,Treble,Presence
Bass EQ Boost
Mid EQ Scoop
Switchable Serial effects loop
XLR Output with Ground Lift
RF1503 Footswitch switches all three
Channels and Loop
Randall Warranty!
Randall Amplifiers, a Division of U.S. Music Corporation warrants the product
you have purchased to be free of defects in materials and workmanship in normal
use for a period of two (2) years from the date of original purchase. This warranty
shall run to the original purchaser when purchased from an Authorized Randall
Dealer. The manufacturer warrants speakers for a period of (1) years. The
manufacturer warrants tubes for a period of (90) days. Defective parts found
during the applicable warranty period with proof of purchase will be replaced or
repaired without charge if the complete product is returned to US Music Corp or
any Authorized Randall Service Center within the U.S.A. Randall reserves the
right to use materials readily available at the time of the repair. All Warranty
service requires Proof of Purchase (sales receipt) to be presented at time of service
request. Any repair or service performed by any person of entity other than an
Authorized Service Center is not covered by this limited warranty. The customer
pays transportation to and from Randall factory service or any Randall Authorized
Service Center. Rental stock is warranted for (1) year from date of invoice to the
Authorized dealer. Warranty on rental units is not transferable.!
What is covered against manufacturing defects!
Parts and Labor to correct any defect in materials used and any defect attributable
to workmanship.!
What is not covered:!
Shipping Damage. Report damage upon receipt of item to the carrier (i.e. UPS).
Freight carrier must be notified upon receipt of items to insure freight damage
claim resolution. Shipping damage not filed with carriers within (48) hrs upon
receipt will not be covered under warranty. Report any shipping damage within
(48) hrs of receipt to the Randall Customer Service Dept at 1-800-877-6863, ext.
5120. Keep all original documents and packing materials to insure freight damage
claim resolution. Merchandise that has been modified after original shipment from
the Randall factory. Products whose serial numbers have been altered or removed.
Exterior normal wear and tear damage to the finish due to misuse, operation
outside the specified ratings, neglect or accident. Warranty claims by anyone other
than the original purchaser. Randall is not responsible for any items left in
protective covers or cases, (We strongly advise that all personal items such as
chords, cables, tuners, etc… be removed!) freight charges to and from the factory
or an Authorized service center on customer owned goods, any and all charges
incurred from priority service requests (Rush Service) or priority shipping for
replacement parts. Any and all charges if no problem is found.!
Return Authorization!
All items being returned for any reason must have a Return Authorization number.
This RA# must be placed on the outside of the carton of the item being returned or
the carton will be refused upon delivery. Please call the customer service
department at 1-800-877-6863, ext. 5120, for the return authorization number.
Dealer stock items will be returned to the dealer freight prepaid.!
An Authorized Warranty Service Center must perform any and all field warranty
service work. Customer will not pay for parts and/or labor provided the problem
found is within warranty guidelines. Proof of purchase must be provided at the
time of service request. Transportation charges to and from the Authorized
Warranty Service Center are the responsibility of the customer. Rush service
charges and special freight charges for required parts are not covered under
warranty and are also the responsibility of the customer. If a unit is not easily
transported to an authorized service center, the customer is responsible for
technician travel charges. Any charges for labor or processing when no problem is
found are also not covered under warranty. Any charges incurred for work
performed by an unauthorized service center are the responsibility of the customer. !
Warranty terms may very per country, check warranty terms
with local Distributor or at point of purchase.
For detailed product videos please visit our
website at :www.randallamplification.com
OPERATION
MANUAL
RG3003H
A M P L IFIE R S
RM50/RM80
M O D U L A R T U B E C O M B O S
O W N E R S M A N U A L
1. 1/4” Guitar Input.
2. Channel selector switch toggles between 3 channels (footswitchable).
3. Channel 1 gain controls amount of pre amp drive to channel 1.
4. Bright switch adds Hi-Frequency EQ “Sparkle” to Channel 1.
5. Channel 1 volume controls the amount of Channel 1 signal being sent to the master volume
output.
6. Channel 2 gain controls amount of pre amp overdrive to channel 2 - this will control the amount of
“distortion”.
7. Channel 2 volume controls the amount of Channel 2 signal being sent to the master volume
output.
8. Channel 3 gain controls amount of preamp overdrive to channel 3 - this will control the amount of
“searing distortion”.
9. Channel 3 volume controls the amount of Channel 3 signal being sent to the master volume
output.
10. The Bass knob controls the amount of low frequency equalization for the entire signal.
11. The BASS BOOST will enhance low EQ - Warning: use of boost with the Bass knob turned up can
cause speaker damage.
12. The Middle knob controls the mid-frequency equalization for the entire signal.
13. The MID SCOOP will decrease middle EQ similar to a “smiley face” setting on a graphic EQ.
14. The Treble knob will control the amount of High frequency equalization for the entire signal.
15. The Presence knob controls the uppermost High EQ frequencies above the Treble EQ shelf.
16. NOISE GATE BYPASS removes the noise suppression circuit from the signal path.
17. THRESHOLD controls the Noise Reduction function. After setting your preferred gain and tone
settings, play your guitar very softly and turn up the threshold until it begins to eliminate the
softest notes then turn it slightly under that “threshold”.
!
Congratulations on the purchase of your new RANDALL Amplifier! We at Randall Amplification appreciate that you chose the RG3003H Amplifier and wish you
years of great tone and enjoyable playing time. Please review the safety instructions below and be aware that the documentation provided in this manual references
120volt USA versions of the models covered. Note that the POWER listed on the back of the unit should be for your countries’ power standard.
!
18. The MASTER VOLUME controls the amps volume going to whatever speaker cabinet is
connected.
19. The PHONES output allows for headphones to be plugged in - Note: speaker out is
muted during headphone operation.
20. STEREO MEDIA INPUT allows for 1/8” media source such as MP3 player to be inserted
into signal to play along.
21. The POWER switch turns the amplifier on and off.
22. AC Inlet this jack is for the power cable supplied for your regions power - plug this cable
in and the other side to the source.
23. SPEAKER OUTPUT #1 is parallel with Speaker output #2 and utilizes standard 1/4” with
MINIMUM 4 OHMS LOAD FOR BOTH OUTPUTS #1 & #2 -(this means maximum
2-8ohm cabs combined for both speaker outputs).
24. SPEAKER OUTPUT #2 is parallel with Speaker output #1 and utilizes standard 1/4” with
MINIMUM 4 OHMS LOAD FOR BOTH OUTPUTS #1 & #2 -(this means maximum
2-8ohm cabs combined for both speaker outputs).
25. XLR Line Out provides “mic cable” output to carry amp output signal to PA, mixing
console or recording device.
26. GND LIFT - lifts the ground or “Earth” of the XLR OUT to avoid noise/hum when
interfacing external gear via XLR.
27. EFFECTS LOOP RETURN - plug 1/4” guitar cable from the output from Effects pedal or
device here.
28. EFFECTS LOOP SEND - plug 1/4” guitar cable to the input of Effects pedal or device
here.
29. FOOTSWITCH - 7 PIN DIN connector of included 4 button RF1503 footswitch inserts
here to operate.
Produktspezifikationen
Marke: | Randall |
Kategorie: | Verstärker |
Modell: | RG3003H |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Randall RG3003H benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Verstärker Randall
3 August 2024
Bedienungsanleitung Verstärker
- Verstärker Nedis
- Verstärker Sony
- Verstärker Yamaha
- Verstärker Alecto
- Verstärker MarQuant
- Verstärker Kenwood
- Verstärker Pyle
- Verstärker Auna
- Verstärker Beyerdynamic
- Verstärker Denon
- Verstärker Pioneer
- Verstärker Geemarc
- Verstärker JBL
- Verstärker Onkyo
- Verstärker Technics
- Verstärker Hifonics
- Verstärker Novero
- Verstärker Fenton
- Verstärker Rotel
- Verstärker Harman Kardon
- Verstärker Marshall
- Verstärker Naim
- Verstärker Power Dynamics
- Verstärker Samson
- Verstärker Skytec
- Verstärker Tangent
- Verstärker Vonyx
- Verstärker NAD
- Verstärker Fender
- Verstärker Behringer
- Verstärker Marantz
- Verstärker Arcam
- Verstärker Crown
- Verstärker Ecler
- Verstärker Luxman
- Verstärker Monacor
- Verstärker Sansui
- Verstärker TEAC
- Verstärker Thorens
- Verstärker Classé
- Verstärker Sherwood
- Verstärker Humantechnik
- Verstärker Bluetech
- Verstärker Skytronic
- Verstärker Reloop
- Verstärker Eden
- Verstärker American Audio
- Verstärker Anthem
- Verstärker HQ Power
- Verstärker Ibiza Sound
- Verstärker McIntosh
- Verstärker Hartke
- Verstärker DAP Audio
- Verstärker Elektra
- Verstärker Engl
- Verstärker Iriver
- Verstärker Koda
- Verstärker Konig Electronic
- Verstärker MaxGear
- Verstärker Meridian
- Verstärker Peavy
- Verstärker Quadral
- Verstärker Stagg
- Verstärker UPC
- Verstärker Velodyne
- Verstärker IFi Audio
- Verstärker Amplicom
- Verstärker Ampeg
- Verstärker Citronic
- Verstärker Advance Acoustic
- Verstärker Mark Levinson
- Verstärker AB International
- Verstärker Alto Professional
- Verstärker Audica
- Verstärker Bellman
Neueste Bedienungsanleitung für -Kategorien-
15 Oktober 2024
15 Oktober 2024
12 Oktober 2024
9 Oktober 2024
22 September 2024
19 September 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024