Pioneer DVH-340UB Bedienungsanleitung
Pioneer
Multimedia
DVH-340UB
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Pioneer DVH-340UB (40 Seiten) in der Kategorie Multimedia. Dieser Bedienungsanleitung war für 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/40
Installation Manual
Manuel d installation’
Manuale d installazione’
Manual de instalación
Installationsanleitung
Installatiehandleiding
DVD RDS RECEIVER
AUTORADIO DVD RDS
SINTO LETTORE DVD CON RDS
RADIO RDS CON DVD
DVD-RDS-EMPFÄNGER
DVD RDS-ONTVANGER
DVH-340UB
English NederlandsDeutschEspañolItalianoFrançais
WARNING
!To avoid the risk of accident and the potential
violation of applicable laws, no viewing of
front seat video should ever occur while the
vehicle is being driven. Also, rear displays
should not be in a location where they are
visibly distracting to the driver.
!In some countries or states the viewing of im-
ages on a display inside a vehicle even by
persons other than the driver may be illegal.
Where such regulations apply, they must be
obeyed and this unit s DVD features should’
not be used.
CAUTION
!PIONEER does not recommend that you in-
stall or service your display unit yourself. In-
stalling or servicing the product may expose
you to risk of electric shock or other hazards.
Refer all installation and servicing of your
display unit to authorized Pioneer service
personnel.
!Secure all wiring with cable clamps or elec-
trical tape. Do not allow any bare wiring to re-
main exposed.
!Do not drill a hole into the engine compart-
ment to connect the yellow cable of the dis-
play unit to the vehicle battery. Engine
vibration may eventually cause the insulation
to fail at the point where the wire passes
from the passenger compartment into the
engine compartment. Take extra care in se-
curing the wire at this point.
!It is extremely dangerous to allow the display
lead to become wound around the steering
column or shift lever. Be sure to install the
display in such a way that it will not obstruct
driving.
!Make sure that wires will not interfere with
moving parts of the vehicle, such as the shift
lever, parking brake or seat sliding mecha-
nism.
!Do not shorten any cables. If you do, the pro-
tection circuit may fail to work properly.
Important
!When installing this unit in a vehicle without
an ACC (accessory) position on the ignition
switch, failure to connect the red cable to the
terminal that detects operation of the ignition
key may result in battery drain.
O
N
S
T
A
R
T
O
F
F
ACC position No ACC position
!Use of this unit in conditions other than the
following could result in fire or malfunction.
—Vehicles with a 12-volt battery and negative
grounding.
—Speakers with 50 W (output value) and 4 Wto
8W(impedance value).
!To prevent a short-circuit, overheating or mal-
function, be sure to follow the directions
below.
—Disconnect the negative terminal of the bat-
tery before installation.
—Secure the wiring with cable clamps or adhe-
sive tape. Wrap adhesive tape around wiring
that comes into contact with metal parts to
protect the wiring.
—Place all cables away from moving parts,
such as the shift lever and seat rails.
—Place all cables away from hot places, such
as near the heater outlet.
—Do not connect the yellow cable to the battery
by passing it through the hole to the engine
compartment.
—Cover any disconnected cable connectors
with insulating tape.
—Do not shorten any cables.
—Never cut the insulation of the power cable of
this unit in order to share the power with
other devices. The current capacity of the
cable is limited.
—Use a fuse of the rating prescribed.
—Never wire the negative speaker cable directly
to ground.
—Never band together negative cables of multi-
ple speakers.
!When this unit is on, control signals are sent
through the blue/white cable. Connect this
cable to the system remote control of an ex-
ternal power amp or the vehicle s auto-anten-’
na relay control terminal (max. 300 mA
12 V DC). If the vehicle is equipped with a
glass antenna, connect it to the antenna
booster power supply terminal.
!Never connect the blue/white cable to the
power terminal of an external power amp.
Also, never connect it to the power terminal
of the auto antenna. Doing so may result in
battery drain or a malfunction.
!The black cable is ground. Ground cables for
this unit and other equipment (especially,
high-current products such as power amps)
must be wired separately. If they are not, an
accidental detachment may result in a fire or
malfunction.
Connections
2
Section
Connections
En
01
Power cable connection
1*
3*
2*
4*
Note:
Depending on the kind of vehicle, the
function of 2* and 4* may be different. In
this case, be sure to connect 1* to 4*
and 3* to 2*.
Connect leads of the same
color to each other.
Yellow (2*)
Back-up (or
accessory)
Red (4*)
Accessory
(or back-up)
Yellow (1*)
Connect to the constant
12 V supply terminal.
Red (3*)
Connect to terminal controlled
by ignition switch (12 V DC).
ISO connector
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
Speaker leads
White: Front left 
White/black: Front left 
Gray: Front right 
Gray/black: Front right 
Green: Rear left ï€«ï€ ï€«ï€ or subwoofer
Green/black: Rear lef t ï€ªï€ ï€ªor subwoofer
Violet: Rear right   or subwoofer
Violet/black: Rear right ï€ªï€ ï€ªor subwoofer
Blue/white
Connect to system control terminal of the
power amp (max. 300 mA 12 V DC).
Blue/white (6*)
Connect to auto-antenna
relay control terminal
(max. 300 mA 12 V DC).
The pin position of the ISO connector will differ
depends on the type of vehicle. Connect 5* and
6* when Pin 5 is an antenna control type. In
another type of vehicle, never connect 5* and 6*.
Yellow/black
If you use an equipment with Mute function, wire
this lead to the Audio Mute lead on that equipment.
If not, keep the Audio Mute lead free of any
connections.
Black (chassis ground)
Connect to a clean, paint-free metal location.
This product
Fuse (10 A)
Wired remote input
Hard-wired remote control
adapter can be connected
(sold separately).
Antenna jack
Blue/white (5*)
Notes:
à¡®Change the initial setting of this unit (refer to the
Operation Manual). The subwoofer output of this
unit is monaural.
࡮When using a subwoofer of 70 W (2 ), be sure Ω
to connect the subwoofer to the violet and
violet/black leads of this unit. Do not connect
anything to the green and green/black leads.
English
Connections
3
Section
Connections
En
01
Produktspezifikationen
Marke: | Pioneer |
Kategorie: | Multimedia |
Modell: | DVH-340UB |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Pioneer DVH-340UB benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Multimedia Pioneer
19 September 2024
6 Juli 2024
5 Juli 2024
5 Juli 2024
5 Juli 2024
4 Juli 2024
3 Juli 2024
3 Juli 2024
3 Juli 2024
3 Juli 2024
Bedienungsanleitung Multimedia
- Multimedia Panasonic
- Multimedia Maginon
- Multimedia MarQuant
- Multimedia Renkforce
- Multimedia Grundig
- Multimedia Kenwood
- Multimedia Pyle
- Multimedia Mitsubishi
- Multimedia Auna
- Multimedia JVC
- Multimedia Dual
- Multimedia Skoda
- Multimedia XOMAX
- Multimedia Audi
- Multimedia EnVivo
- Multimedia Ford
- Multimedia Volvo
- Multimedia Toyota
- Multimedia Kia
- Multimedia Opel
- Multimedia Audiovox
- Multimedia Zenec
- Multimedia Tokaï
- Multimedia Macrom
- Multimedia Phonocar
- Multimedia Super
- Multimedia Autovision
- Multimedia Mazda
- Multimedia Renault
- Multimedia JL Audio
- Multimedia Eonon
- Multimedia ESX - Car Media Systems
- Multimedia Eurologics
- Multimedia Lanzar
- Multimedia Saab
- Multimedia Sirius XM
- Multimedia Truckmate
- Multimedia VDO Dayton
- Multimedia Bullit
Neueste Bedienungsanleitung für -Kategorien-
23 September 2024
20 September 2024
27 August 2024
27 August 2024
27 August 2024
27 August 2024
27 August 2024
27 August 2024
26 August 2024
26 August 2024