Philips AX3301 Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Philips AX3301 (5 Seiten) in der Kategorie Discmans. Dieser Bedienungsanleitung war für 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/5
AudioAudio
AX3300
AX3301
AX3302
AX3303
AX3304
AX3305
AX3306
Portable CD Player
CLASS 1
LASER PRODUCT
Meet Philips at the Internet
http://www.philips.com
Portable CD Player
English
3140 115 31423
Printed in China
re pea t al l
vo
l
DBB
rep eat all
vol
DBB
rep ea t al l
vol
DBB
p
1
3 #
4
HOLD OFF➟
5
PLAY 2;
6 VOL
!!!
2
2
/
+
/
+
1 .
1 .
1 .
1 .
1 .
1 .
2 .
2 .
2 .
2 .
2 .
2 .
+
-
+
-
POWER SAVE
ESP ON
-
-
-
-
-
PO WER SAV E
ESP ON
repeat all
vol
DBB
+
+
#
@^
!
$
%
&
1
1
3
4
5
0
9
8
6
7
2
QUICK START
Handling instructions
• Recharging already charged or half-charged batteries will shorten their
lifetime. We therefore recommend that you let the rechargeable ECO-PLUS
NiMH battery run till it is completely empty before you recharge it.
• To avoid a short circuit, do not let the battery touch any metal object.
• If the battery becomes empty soon after recharging, then either its contacts
are dirty or it has reached the end of its lifetime.
Mains adapter (supplied or optionally available)
Use only the AY 3170 adapter (4.5 V / 300 mA direct
current, positive pole to the center pin). Any other product
may damage the player.
1 Make sure the local voltage corresponds to the power
adapter’s voltage.
2 Connect the power adapter to the 4.5V DC socket of
the player and to the wall socket.
Note: Always disconnect the adapter when you are not using it.
Environmental information
• All redundant packing material has been omitted. We have done our utmost to
make the packaging easily separable into two mono materials: cardboard (box)
and polyethylene (bags, protective foam sheet).
• Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packing materials, exhausted batteries and old equipment.
English CONTROLS / POWER SUPPLY
C
ontrols ( see figure
1
)
1LINE OUT/p........3.5 mm headphone socket, socket to connect the player to
another audio input of an additional appliance
2∞.......................skips and searches CD tracks backwards
3 9.........................stops CD play, clears a program or switches the player off
4§.......................skips and searches CD tracks forwards
52; ......................switches the player on, starts or pauses CD play
6 PROG...................programs tracks and reviews the program
7MODE .................selects the different playing possibilities: shuffle,
shuffle repeat all, , repeat repeat all and SCAN
8 ............................display
9 DBB.....................switches the bass enhancement on and off. This button also
switches acoustic feedback (the beep) on/off when it is
pressed for more than 2 seconds
0 VOL −
−
−
−
−−/
/
/
/
//+
+
+
+
++ ..............adjusts the volume
! 4.5V DC...............socket for external power supply
@OPEN 2..............opens the CD lid
# ESP ON /
POWER SAVE .......to select between the battery powersave mode and
E S Plectronic kip rotection (ESP). ESP ensures continuous
CD playback regardless of vibrations and shocks
$ OFF......................switches RESUME and HOLD off
RESUME .............stores the last position of a CD track played
HOLD...................locks all buttons
% ............................typeplate
^ ............................battery compartment
& ............................AAA battery door
This set complies with the radio interference requirements of the
European Union.
POWER SUPPLY / GENERAL INFORMATION
Average playing time of batteries under normal conditions
Battery type ESP on Power Save
Alkaline AA 15 hours 20 hours
Alkaline AAA 7 hours 9 hours
Rechargeable ECO-PLUS NiMH battery 3 hours 5 hours
Batteries contain chemical substances, so they should be disposed
of properly.
ECO-PLUS NiMH battery information (for versions supplied with the
rechargeable ECO-PLUS NiMH battery AY 3363)
Recharging works only on players supplied with the rechargeable ECO-PLUS
NiMH battery AY 3363.
Recharging the ECO-PLUS NiMH battery on board
1 Insert the rechargeable ECO-PLUS NiMH battery AY 3363.
2 Connect the mains adapter to the 4.5V DC socket of
the player and then to the wall socket.
y is pulsing.
• Recharging stops after a maximum of 7 hours, or
when you start playback.
3When the battery is fully recharged, FULL appears
in the display.
Notes: – It is normal for the batteries to become warm
during recharging.
– If the batteries become too warm, recharging will be interrupted for
approximately 30 minutes .
– To ensure proper recharging on board, take care that contacts are clean.
– Use only the ECO-PLUS NiMH battery AY 3363.
Batteries (supplied or optionally available)
For convenience, this model is designed with 2 different detachable battery
doors. This allows you to operate the player using 2 choices of battery size.
You can use the following batteries with this CD-player:
• alkaline batteries type AAA (LR03, UM4) or preferablyAA (LR6, UM3)
Philips.
Notes:–
Old and new or different types of batteries should not be combined.
– Remove batteries if they are empty or if the player is not going to be used for
a long time.
Inserting AAA (LR03, UM4) or AY 3363 batteries
1 Open the AAA battery door.
2 Insert AAA batteries as shown onto the back of the
door.
3 Replace the battery-loaded AAA door back onto the
set.
Inserting AA (LR6, UM3) batteries
To double playback time, insert AA batteries into the
battery compartment and use the marked batteryAA
door.
• Open the battery compartment and insert either 2
normal or alkaline batteries.
Battery indication
The approximate power level of your batteries is shown in the display.
Battery full
Battery two-thirds full
Battery one-third full
Battery dead or empty. When the batteries are
dead or empty, the symbol flashes, bAtt is
displayed, and the beep tone sounds repeatedly.
-
+
-
+
AA SIZE
LR6 / UM3
4. 5
VD
C
-
-
-
-
-
+
+
LR03/AAA /UM4
AAA (LR03, UM4)
AA (LR6, UM3)
GENERAL INFORMATION
CD player and CD handling
• Do not touch the lens Aof the CD player.
• Do not expose the unit, batteries or CDs to humidity,
rain, sand or excessive heat (caused by heating
equipment or direct sunlight).
• You can clean the CD player with a soft, slightly
dampened, lint-free cloth. Do not use any cleaning
agents as they may have a corrosive effect.
• To clean the CD, wipe it in a straight line from the
center toward the edge using a soft, lint-free cloth. A
cleaning agent may damage the disc! Never write on a CD or attach a sticker
to it.
• The lens may cloud over when the unit is moved suddenly from cold to warm
surroundings. Playing a CD is not possible then. Leave the CD player in a warm
environment until the moisture has evaporated.
• Active mobile phones in the vicinity of the CD player may cause malfunctions.
• Avoid dropping the unit as this may cause damage.
Headphones HE225/HE270
• Connect the supplied headphones to the LINE OUT/p
socket of the player.
Note: LINE OUT/pcan also be used for
connecting this set to your HiFi system.To adjust the
sound and volume, use the controls on the connected
audio equipment and on the CD player.
IMPORTANT!
Hearing safety: Do not play your headphones at a high volume. Hearing experts advise
that continuous use at high volume can permanently damage your hearing.
Traffic safety: Do not use headphones while driving a vehicle. It may create a hazard
and it is illegal in many countries. Even if your headphones are an open-air type
designed to let you hear outside sounds, do not turn up the volume so high that you
cannot hear what is going on around you.
CD PLAY
Playing a CD
This CD-player can play all kinds of Audio Discs such
as CD-Recordables and CD-Rewritables. Do not try to
play a CD-ROM, CDi, VCD, DVD, MP3-CD or computer
CD.
1Push the OPEN 2slider to open the player.
2 Insert an audio CD, printed side up, by pressing the
CD onto the hub.
3 Close the player by pressing the lid down.
4Press 2; to switch the player on and start playback.
yThe current track number and elapsed playing
time are displayed.
• You can pause playback by pressing 2;.
yThe time at which playback was paused starts
flashing.
• You can continue playback by pressing 2; again.
5 Press 9 to stop playback.
yThe total number of tracks and the total playing
time of the CD are displayed.
6 Press 9 again to switch the player off.
• To remove the CD, hold it by its edge and press the
hub gently while lifting the CD.
Note: If there is no activity, the set will automatically
switch off after a while to save energy.
In-car use (connections supplied or optionally available)
Only use the AY 3545 or AY 3548 car voltage converter (4.5 V DC, positive pole to
the centre pin) and the AY 3501 car cassette adapter. Any other product may dam-
age the set.
1 Put the set on a horizontal, vibration-free and
stable surface. Make sure it is in a safe place,
where the set is neither a danger nor an
obstacle to the driver and the passengers.
2 Plug the voltage converter into the
cigarette lighter socket (only for 12 V car
battery, negative grounding), then connect
the wired end with 4.5V DC input socket on the
set.
3 If necessary, clean the cigarette lighter socket to obtain a good electrical
contact.
4Turn down the volume and connect the cassette adapter plug to LINE OUT/p
on the set.
5 Carefully insert the cassette adapter into the car radio’s cassette compartment.
6 Make sure the cord does not hinder your driving.
7Decrease the volume on the set if necessary. Start playback on the set and
adjust the sound with the car radio controls.
• Always remove the voltage converter from the cigarette lighter socket
when the set is not in use.
Note: If your car radio has a LINE IN socket, it is better to use it for the
car radio connection instead of the adapter cassette. Connect the signal
lead to this LINE IN socket and to on the set.LINE OUT/p
4,5 V DC
12 V DC
repe at all
vol
DBB
Playback information
• If a CD-Recordable (CD-R) or a CD-Rewritable (CD-
RW) is not recorded properly, NF dISC is
displayed, indicating that the CD has not been
finalized. In that case, use FINALIZE on your CD
recorder to complete the recording.
• When playing a CD-Rewritable (CD-RW), please note
that it takes 3–15 seconds after pressing 2; for
sound reproduction to start.
• Playback will stop if you open the CD lid.
•While the CD is read, 1 -:- flashes in the display.
Volume and bass
Volume adjustment
• Adjust the volume by using VOL −
−
−
−
−−/
/
/
/
//+
+
+
+
++ on the CD player
or the slider on the headphone cord.
Bass adjustment
• Press DBB to switch the bass enhancement on or
off
y is shown if the bass enhancement is
activated.
vol
Produktspezifikationen
| Marke: | Philips |
| Kategorie: | Discmans |
| Modell: | AX3301 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Philips AX3301 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Discmans Philips
4 Juli 2024
Bedienungsanleitung Discmans
Neueste Bedienungsanleitung für -Kategorien-
14 Oktober 2024
13 Oktober 2024
9 Juli 2024
6 Juli 2024
5 Juli 2024
4 Juli 2024