PetSafe YardMax PIG00-15958 Bedienungsanleitung

PetSafe Nicht kategorisiert YardMax PIG00-15958

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für PetSafe YardMax PIG00-15958 (20 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/20

Please read this entire Product Manual before beginning

PIG00-15958

YardMax® Cordless

In-Ground Fence™

Product Manual

petsafe.com+1 (800) 732-26772

Welcome

You and your pet were made for each other. Our aim is to help you have the best companionship and the most memorable moments together. Your

new YardMax® Cordless In-Ground Fence

™

system is designed to give your pet maximum freedom while keeping him safe.

We know that safe pets make happy owners. Before getting started, please have your utilities marked, and take a moment to read through the

important safety information. If you have any questions, please don’t hesitate to contact us.

Hereinafter Radio Systems Corporation, Radio Systems PetSafe Europe Ltd., Radio Systems Australia Pty Ltd. and any other affiliate or brand of Radio

Systems Corporation may be referred to collectively as “We” or “Us.”

Important Safety Information

Explanation of attention words and symbols used in this Product Manual:

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to

avoid possible injury or death.

WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION, used with the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in minor or

moderate injury.

CAUTION, used without the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in harm to

your pet.

NOTICE is used to address practices not related to personal injury.

• Not for use with aggressive pets. Do not use this product if your pet is prone to aggressive behavior. Aggressive pets can

cause severe injury or death to their owners and others. If you are not sure that this product is right for your pet, please talk to

your veterinarian or a certified trainer.

• Before you begin installing the boundary wire, turn off the transmitter.

• Underground cables can carry high voltage. Have all underground cables marked before you dig to bury your wire. In most

areas this is a free service. Avoid these cables when you dig.

• Do not install, connect or remove your system during a lightning storm. If the storm is close enough for you to hear thunder, it is

close enough to create hazardous surges.

• To avoid risk of severe injury, follow all safety instructions for your power tools. Be sure to always wear your safety goggles.

• The battery should be charged in areas with temperatures ranging from 32°F to 113°F / 0°C to 45°C. Recharging the

battery outside of this temperature range can cause the battery to overheat, explode or catch fire.

• Wire on top of the ground may be a trip hazard. Be careful when placing wires and testing the system.

• This system is NOT a solid barrier. It is designed to act as a deterrent to remind pets to remain within the established boundary

by use of static correction. It is important that you reinforce training with your pet on a regular basis. Since the tolerance level

to static correction varies from pet to pet, Radio Systems Corporation CANNOT guarantee that the system will, in all cases,

keep a pet within the established boundary. Not all pets can be trained to avoid crossing the boundary! Therefore, if you

have reason to believe that your pet may pose a danger to others or harm himself if he is not kept from crossing the boundary,

you should NOT rely solely upon this system to confine your pet. Radio Systems Corporation shall NOT be liable for any

property damage, economic loss or any consequential damages sustained as a result of any animal crossing the boundary.

Proper fit of the receiver collar is important. A receiver collar w

skin damage, ranging from redness to pressure ulcers. This con

• Avoid leaving the receiver collar on your pet for more

• When possible reposition the collar on your pet’s neck eve

• Check the fit to prevent excessive pressure; follow the instru

• Regularly recheck the fit to prevent excessive pressure; follo

• You may need to trim the hair in the area of the contact po

or infection.

• Never connect a leash to a collar with contact points. It wi

• When using a separate collar for a leash, do not put press

• Wash your pet’s neck area and the contact points of the re

• Examine the contact area daily for signs of a rash or a sore

• If a rash or sore is found, discontinue use of the receiver co

• If the condition persists beyond 48 hours, see your veterina

• For additional information on bed sores and pressure necr

• Proper training of your pet is essential to successfully using

system without direct supervision of your pet.

• The receiver collar should not be on your pet when the sys

• Do not change the transmitter setting from Traditional mod

collar will still contain your pet.

• If the receiver collar fails the ReadyTest

® startup, the receive

• Always remove your pet’s receiver collar before performin

unintended corrections.

• The boundary width of the system must be tested wheneve

corrections to your pet.

• Avoid damage to the insulation of the boundary wire durin

to early failure of the boundary.

• To conserve your batteries, when unused for long periods

• You should expect hundreds of recharge cycles from your

Charging too often can reduce battery life.

• Charge your receiver collar when the receiver indicator lig

• When mowing or trimming your grass, use care not to cut t

• To prevent an unintended correction, after the boundary fla

receiver collar back to level 1, which is tone only.

petsafe.com+1 (800) 732-26774

Understand the Transmitter

Power Button

Press and hold the power button down firmly for 5 seconds to turn on the

transmitter. To turn off the transmitter, press and hold the power button

down for 5 seconds.

Select Button

The select button allows you to edit the 2 transmitter settings. The order of

the selection is as follows:

1. Boundary range

2 ft. to 15 ft. (varies by mode)

2. Boundary mode

(A) or (B)

To Edit the Transmitter Settings:

1. Press the select button. The boundary range setting will start to flash.

2. Use the up and down buttons to change the range.

3. Press the select button again. The mode setting will start to flash.

4. Use the up or down buttons to choose the mode:

(A) – YardMax® or (B) – Traditional

Note: Settings can only be edited while they are flashing

Up and Down Buttons

The up and down buttons are used to change the boundary settings. They

also mute the alarm.

Bluetooth® Icon

Bluetooth®

capability is not yet available, but your transmitter was

built with future updates in mind. Check our website for Bluetooth

technology announcements.

Each time the transmitter is powered on, the Bluetooth

® icon will flash for

3 minutes and then disappear.

Battery Level Icon

The battery icon displays 3 bars with a full charge. Replace the batteries

when the battery icon shows 1 bar or no bars. Typically, battery life lasts

9 to 12 months. If the battery level becomes too low, the lights will flash

red once every few seconds, along with a single alarm tone.

Attention Required Icon

The attention required icon will appear if there is an issue with the system.

A unique alarm will also initially sound. The most common alarms are for

a wire break, wire degradation or if a wire becomes disconnected from

the transmitter. Even after the alarm is muted, the attention required icon

will continue to display until the problem is resolved.

Muting the Alarm

An alarm tone will sound if an issue with the system is detected. The lights

will flash red 1 to 3 times depending on the issue. To mute the alarm, press

any button except the power button. This will mute the alarm; however, the

lights will continue to flash until the problem is resolved. The mute alarm

icon will appear, indicating that you have turned off the alarm.

Refer to the table “Transmitter Alarms” on page 26 for a complete guide

to all the status lights and tones for the transmitter.

In the Box

You May Also Need

• Additional wire and flags (Part # PIG00-13769)

• Additional wire nuts and gel-filled splice capsules

• Drill with Phillips drill bit

• Small Phillips screwdriver

• Staple gun

• Scissors

• Lighter

• Pliers

• Spade shovel or lawn edger

• Wire stripping pliers

• Waterproofing compound (e.g. silicone caulk)

• Non-metallic collar and leash

• PVC pipe or water hose

• Circular saw with masonry blade

• Mounting stake

For help with setup and training, please visit petsafe.com.

After verifyi ng that th e receiver col lar is operating

correctly at the bou ndary, fold each label in half

around the appropri ate boundary wire that connects

into the trans mitter. On e sti cker is for the positive

wire, and the other is for the negative wire. Labeling

the wires is convenient, should they both becom e

disconnected from the uni t.

apply to the (+) wi re +

– –

apply to the (–) wire

Mounting

Screws

Test Light

Tool

50 Boundary FlagsWaterproof Transmitter

500 ft. of Boundary Wire

Wire Nuts

Gel-ﬁlled

Splice Capsules

Receiver Collar with

Short Contact Points

Contact

Point Wrench

Long

Contact Points

Boundary Wire

Labels

Receiver

Charger

(6 ft.)

Pow

Butto

Sele

Butto

Bound

Termi

(

wit

What’s Covered

How It Works ............................................................................................................................................................................................................................................ 6

4 Steps to a Contained Pet ...................................................................................................................................................................................................................... 6

Insert the Transmitter Batteries ................................................................................................................................................................................................................ 6

Charge the Collar .................................................................................................................................................................................................................................... 7

Have Your Utilities Marked ..................................................................................................................................................................................................................... 7

Choose a Location ................................................................................................................................................................................................................................... 7

YardMax

® Mode (A) ...............................................................................................................................................................................................................................8

Traditional Mode (B)................................................................................................................................................................................................................................ 8

Basic Planning Tips................................................................................................................................................................................................................................... 9

Prepare the Collar ..................................................................................................................................................................................................................................13

Connect the Wires .................................................................................................................................................................................................................................13

Mount the Transmitter (optional) .......................................................................................................................................................................................................... 14

Turn on the Transmitter ........................................................................................................................................................................................................................... 14

Test the Fence Direction .........................................................................................................................................................................................................................14

Test the Collar .........................................................................................................................................................................................................................................15

Bury the Boundary Wire .......................................................................................................................................................................................................................17

Place the Boundary Flags .....................................................................................................................................................................................................................18

Fit the Collar ............................................................................................................................................................................................................................................19

Training ....................................................................................................................................................................................................................................................20

Advanced Features ................................................................................................................................................................................................................................22

System Test ..............................................................................................................................................................................................................................................23

Wire Break Location Test .......................................................................................................................................................................................................................24

Receiver Collar Status Indicators ........................................................................................................................................................................................................25

Transmitter Alarms ..................................................................................................................................................................................................................................26

Troubles hoot ing ......................................................................................................................................................................................................................................26

Customer Care International ................................................................................................................................................................................................................28

Terms of Use and Limitation of Liability ...............................................................................................................................................................................................28

Warranty ................................................................................................................................................................................................................................................ 28

Battery Disposal .....................................................................................................................................................................................................................................29

Compliance ............................................................................................................................................................................................................................................29

Layout Grid .............................................................................................................................................................................................................................................30