Peavey VSX 26e Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Peavey VSX 26e (21 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/21
www.peavey.com
VSXâ„¢ 26e and VSXâ„¢ 48e
Digital Loudspeaker
Processors
Operating
Manual
2
FCC/ICES Compliancy Statement
This device complies with Part 15 of the FCC rules and Industry Canada license exempt RSS Standard(s). Operation is -
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, that may cause undesired operation.
Le présent appareil est conforme aux CNR d’lndustrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes: (1) I’appareil ne doit pas produire de
brouillage, et (2) I’utilisateur de I’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
Warning: Changes or modifications to the equipment not approved by Peavey Electronics Corp. can void the
user’s authority to use the equipment.
Note – This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, , uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures.
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
3
VSXâ„¢ 26e and VSXâ„¢ 48e
Digital Loudspeaker Processors
The VSXe processors are DSP-based, loudspeaker management systems that boast a 96kHz sample rate and a floating point DSP processor for
quiet accurate filter response. The crossover filters are fully adjustable and any input can be routed to any output. The VSX® Editor Program for PC
allows complete remote setup and operation via the front panel USB port or by the rear panel Ethernet network connection. Files can also be saved
and loaded using this interface software.
This manual covers both the VSX 26e and VSX 48e DSP processors. The units are essentially identical except for the number of inputs and outputs.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment.
ENGLISH
Features
• Balanced Inputs: VSX 26e 2, VSX 48e 4
• Balanced Outputs: VSX 26e 6, VSX 48e 8
• 96 kHz Sample rate
• 24 bit Delta-Sigma A/D and D/A converters
• Dynamic range input to output greater than 109 dB (A-weighted) or 107 dB (unweighted)
• Every input features Gain, Mute, HP and LP filters, 8 bands of PEQ, polarity and Delay (680 mS),
• Every output features: 9 bands of PEQ, gain, compressor/limiter, polarity, Delay (680 mS), mute, and crossover/band-pass filters
• EQ filter types include: PEQ, Low-Shelf, Hi-Shelf, Low-Pass, High-Pass, All-Pass1 and All-Pass2.
• Crossover/Band-pass filters feature Butterworth, Bessel or Linkwitz-Riley alignments from 1st order (6 dB/Oct) to 8th order (48 dB/Oct).
• Signal generator (sine, white noise, pink noise).
• Channels can be linked for simplified stereo operation.
• 5 segment LED meters on each input
• 5 segment LED meters with limit indication on each output
• 2 XLR balanced inputs and 6 XLR balanced outputs VSXe 26
• 4 XLR balanced inputs and 8 XLR balanced outputs VSXe 48
• Maximum input and output level +20 dBu, XLR balanced inputs and outputs.
• Frequency response 20 Hz to 20 kHz +0, -1 dB
• THD+N < 0.01% at 1 kHz.
• Security lock
• USB B port for setup and control
• Ethernet port for setup and control.
• Dimensions (HxWxD) 1.75" x 19" x 8" / 45mm x 480mm x 20.5mm
• Weight 5.2 lbs /2.88 kg
• PC Editor Programs allow complete remote setup and operation via USB or Ethernet.
NOTE: The VSX processors can be setup and operated both from the front panel and from the VSX Editor running on a PC. The
PC can be connected to the VSX via USB or Ethernet.


Produktspezifikationen

Marke: Peavey
Kategorie: Nicht kategorisiert
Modell: VSX 26e

Brauchst du Hilfe?

Wenn Sie Hilfe mit Peavey VSX 26e benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Peavey

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-