Peavey Invective MH Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Peavey Invective MH (12 Seiten) in der Kategorie Gitarrenverstärker. Dieser Bedienungsanleitung war für 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/12
Peavey® Invective® MH
20W Tube Guitar Amplier
www.peavey.com
Operating
Manual
invective. MH
INPUT
CLEAN LEAD MASTER
TSIâ„¢ T2T1 EL84
ON ON
POWERSTANDBY
LOW HIGH PRE GAIN LOW MID HIGH POST GAIN RESONANCE PRESENCE
0 10
1 9
2 8
3 7
456
0 10
1 9
2 8
3 7
456
0 10
1 9
2 8
3 7
456
0 10
1 9
2 8
3 7
456
0 10
1 9
2 8
3 7
456
0 10
1 9
2 8
3 7
456
0 10
1 9
8
3 7
456
0 10
1 9
2
3 7
456
0 10
1 9
2 8
3 7
456
0 10
1 9
2 8
3 7
456
GAIN
FCC/ICES Compliancy Statement
This device complies with Part 15 of the FCC rules and Industry Canada license exempt RSS Standard(s). Operation is -
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, that may cause undesired operation.
Le présent appareil est conforme aux CNR d’lndustrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes: (1) I’appareil ne doit pas produire de
brouillage, et (2) I’utilisateur de I’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
Warning: Changes or modifications to the equipment not approved by Peavey Electronics Corp. can void the
user’s authority to use the equipment.
Note – This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, , uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures.
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
Peavey® Invective® MH
Congratulations on the purchase of your new Invective MH tube guitar amplifier from Peavey! Although small, this amp has an all-
tube preamp and power amp to authentically produce the much loved tones of the Invective 120-- albeit at lower power levels. The
major advantage is the sheer size and weight (or lack thereof).
Before you begin playing through your amplifier, it is very important to ensure that the product has the proper AC line voltage
supplied. This is shown on the voltage selector switch near the IEC inlet on the rear panel of the unit. Refer to the rear panel diagram
in this manual to locate the particular feature next to its number.
Please read this guide carefully to ensure your personal safety as well as the safety of your amplifier. A careful reading of this manual
will also ensure you get the best out of your amplifier, by fully understanding its many features.
FEATURES:
• 2x EL84 power tubes and 3x 12AX7/ECC83 preamp tubes
• Clean Channel with Low and High EQ.
• Lead Channel with 3 band EQ.
• Footswitchable Tight on Lead channel.
• Footswitchable Gate and Boost on Lead Channel.
• Footswitchable buffered effects Loop
• Tube Status Indication (T.S.I.) circuit
• Impedance switch for 16 or 8 ohm cabinets
• MSDI™ Output with XLR and ground lift switch
• USB Output
• Speaker defeat switch
• Headphone output
• Attenuator switch for 20 watts, 5 watts or 1 watt output power
• Master Resonance and Presence.
ENGLISH
VENTILATION: For proper ventilation, allow 24" clearance from the nearest combustible surface.
All vents should have a minimum of 2" of free air space so air can flow thru the unit freely for proper cooling.


Produktspezifikationen

Marke: Peavey
Kategorie: Gitarrenverstärker
Modell: Invective MH

Brauchst du Hilfe?

Wenn Sie Hilfe mit Peavey Invective MH benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Gitarrenverstärker Peavey

Bedienungsanleitung Gitarrenverstärker

Neueste Bedienungsanleitung für -Kategorien-