Nedis SCLU110GY Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Nedis SCLU110GY (57 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/57
SCLU110GY
2018-08-02
2
ENGLISH
Electronic luggage scale
Specifications
1. Room temperature display
2. Zero and tare
3. 0.44" (11.3 mm) LCD display
4. Low battery / overload indicator
5. Capacity: 50 kg / 110 lb
6. Graduation: 50g / 0.1 lb
7. Power: 1x 3V lithium cell (CR2032)
Key illustration
: Switch on/off (press for 2 seconds to switch the device off)
UNIT: Switch between weight and temperature measurements
Weighing
1. Strap the webbing belt through the luggage handle and
secure the hook of the belt onto the triangular ring.
2. Press to switch on the scale before lifting (ensure there
is no tension)
3. When the display shows zero, press UNIT to select the
weight unit.
4. To re-weigh: press Z/T to reset the display to zero.
5. Lift the scale gently. Make sure the scale is horizontal and
balanced. The scale starts weighing the luggage. Wait for
the weight reading to stop and stabilise. The display will
flash the accurate weight 3 times and then lock. The scale
will display the accurate weight for 2 minutes and will then
automatically switch off.
6. When the scale is unable to read the weight of your luggage,
press Z/T to reset the display to zero and try again. The
scale will automatically switch off after 1 minute of inactivity.
Power
The scale is powered by 1x 3 V (CR2032) lithium battery. When
you use the scale for the first time, open the battery case cover
3
on the right end of the scale and remove the battery isolation
sheet before use.
How to Replace the Battery
LCD will display “Lo” when the battery power is low. Replace the
battery as follows:
1. Hold the scale in one hand. Use the thumb and index finger
of your other hand to pull out the battery case from the slot.
2. Push corner A outwards to release the used battery.
3. To insert a new battery, slide one side of the battery beneath
the retainer notches B & C. Press against the other side of
the battery until it clips underneath corner A. Make sure the
battery is inserted according to the polarity instructions.
4. Insert the battery case back into the slot on the scale.
Room temperature
1. Press to switch on the device. Wait until the display
shows zero. Press UNIT to view temperature (in Celsius and
Fahrenheit). Press UNIT again to revert to the normal
weighing mode.
2. When converting to temperature display mode the display
will show: “----”. This means that the scale is testing the
Removable
battery
case / slot
hook
triangular ring
webbing belt notch C
luggage handle Battery case
notch B
notch A


Produktspezifikationen

Marke: Nedis
Kategorie: Nicht kategorisiert
Modell: SCLU110GY

Brauchst du Hilfe?

Wenn Sie Hilfe mit Nedis SCLU110GY benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Nedis

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-