NEC DTR-1-1 Bedienungsanleitung

NEC Telefon DTR-1-1

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für NEC DTR-1-1 (2 Seiten) in der Kategorie Telefon. Dieser Bedienungsanleitung war für 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/2
OWNER’S MANUAL Model
DTR-1-1 TEL
Please read before using this equipment.
1. MF/DP switch
Before using your telephone, it must be set in accordance with the dialing method used by your local public
telephone exchange: MF=dual-tone multi-frequency dialing(DTMF),or DP=pulse dialing
2. Volume control for receiver and Speaker
Press ∧ / ∨ buttons to increase/decrease handset receiver volume while on a call. Volume can be increased 3 levels,
decrease 2 levels against the default level.
3. Selecting Ringing Pitch and Ringing Volume
a) Pick up the Handset
b) Press Program button
c) Dial #
d) Dial 0-9 (Refer to the table in the right)
e) Hang up
4. Flash
With certain public telephone exchanges or private
PABXs, the Flash button can be used to activate additional features, e.g. transfer of a call or pick-up of a call.
5. Redial
In the case of busy tone or no answer, you can redial the number. For this purpose, cradle the handset, lift it again
and press the Redial button.
6. Temporary Switchover of the Dialing Mode
After a connection has been set up to use PULSE dialing, switch over to TONE dialing can be made by pressing the * button,
and certain services offered by certain public Telephone exchanges or PABXs, e.g. control of a telephone answering system,
simple data traffic, etc .,can then be utilized by dialing additional digits. The telephone is automatically reset to PULSE dialing
when the handset is cradled.
NEC America, Inc.
4 P1G001000911
OWNER’S MANUAL Model DTR-1-1 TEL
IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons by doing the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub, in
a wet basement, or near a swimming pool.
4. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious
damage to the product.
5. Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect it from
overheating, these openings must not be blocked or covered. The openings should never be blocked by
placing the product on a bed, sofa, rug, or other similar surface. This product should never be placed near
or over a radiator or heat register. This product should not be placed in a built-in installation unless proper
ventilation is provided.
6. Never push objects of any kind into this product through cabinet slots as they may touch dangerous
voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any
kind on the product.
7. To reduce the risk of electric shock, do not disassemble this product. Take it to a qualified serviceman
when service or repair work is required. Opening or removing covers may expose you to dangerous
voltages or other risks. Incorrect reassembly can cause electric shock when the product is subsequently
used.
8. Avoid using a telephone during an electrical storm. There may be a remote risk of electric shock from
lightning.
9. Do not use the telephone to report a gas leak in the vicinity of the leak.
NOTE: The maximum level setting for the Receive Volume Control should only be used by hearing
impaired individuals, otherwise hearing damage may occur. This telephone complies with HAC
(Hearing Aid Compatible) volume control defined by section 68.317 of the FCC Rules and
Regulations, 1996 edition.
Please keep this unit away from equipment that uses radio wave or
microwave, a portable radio, a microwave oven, etc. This type of
equipment may cause improper operation....
SAVE THESE INSTRUCTIONS
1
Ringing Volume
Soft Medium Loud
Slow 1 2 3
Medium 4 5 6
Ringing
Tone
Pitch Fast 7 8 9
Off - 0 -
OWNER’S MANUAL
Model
DTR-1-1 TEL
FCC Part 68 Registration
The equipment complies with Part 68 of the FCC Rules. A label which contains the FCC Registration Number
and ringer equivalence number(REN) for the equipment, country of origin, and model number among other
information is located on the bottom of the equipment. If requested this information should be provided to the
telephone company.
The equipment uses the following USOC jacks: RJ11C
KX -type telephone with message waiting and/or line status indicators may only be connected to host system
and not to the Network.
The REN is used to determine the quality of the device which may be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In
most, but not in all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices
that may be connected to the line, as determined by the total RENs contact the telephone company to
determine the maximum REN for the calling area.
If the equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. If advance notice is not practical, the telephone company
will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the
FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operation, or procedures that could
effect the operation of the equipment. If this happens, the telephone company will provide advance notice in
order for you to make the necessary modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment, please contact your NEC Dealer for repair and/or warranty
information. If the trouble is causing harm to the telephone network, the telephone company may request you to
remove the equipment from the network until the problem is resolved.
NO REPAIRS CAN BE DONE BY THE CUSTOMER.
The equipment is hearing-aid compatible.
CAUTION: The act of monitoring or recording telephone conversations under certain circumstances may
violate federal or state statutes. Consultation with your legal counsel prior to engaging in such practices would
be advisable.
2
OWNER’S MANUAL
Model
DTR-1-1 TEL
FCC Part 15
Complies with the limits for a Class B computing device pursuant to Subpart J of Part 15 of FCC
Rules.
INDUSTRY CANADA (CS-03)
The Load Number of the equipment: N/A
"Notice: The Industry Canada label identifies certified equipment. The certification means that the equipment
meets certain telecommunication network protective operational and safety requirements. Industry Canada
does not guarantee the equipment will operate to the user's satisfaction."
"Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of
local telecommunications company. The equipment must also be installed using an acceptable method of
connection. In some cases, the company's inside wiring associated with a single line individual service may be
extended by means of a certified connector assembly (telephone extension cord). The customer should be
aware that compliance with the above conditions may not prevent degradation of service in some Situations."
"Repairs to certified equipment should be made by an authorized Maintenance facility designated by the
supplier. Any repairs or installations made by the user to this equipment, or equipment malfunctions, may give
the telecommunications company cause to request that the user disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system, if present, are connected together. This protection may
be particularly important in rural areas."
Caution: Users should not attempt to make such connections themselves, but should contact the appropriate
electric inspection authority, or electrician, as appropriate.
SAFETY CONSIDERATIONS:
This equipment complies with Underwriters Laboratories Standard U.L. 1459, Third Edition.
3

Produktspezifikationen

Marke: NEC
Kategorie: Telefon
Modell: DTR-1-1

Brauchst du Hilfe?

Wenn Sie Hilfe mit NEC DTR-1-1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Telefon NEC

NEC

NEC DTR-1-1 Bedienungsanleitung

28 Juli 2024
NEC

NEC G955 Bedienungsanleitung

26 Juli 2024
NEC

NEC I755 Bedienungsanleitung

14 Juli 2024

Bedienungsanleitung Telefon

Neueste Bedienungsanleitung für -Kategorien-

Gigaset

Gigaset SL370 Bedienungsanleitung

15 Oktober 2024
Profoon

Profoon PDX-7020 Bedienungsanleitung

15 Oktober 2024
Profoon

Profoon PDX-100 Bedienungsanleitung

14 Oktober 2024
Uniden

Uniden XS 1415 Bedienungsanleitung

13 Oktober 2024
Uniden

Uniden XDECT 6105BTU Bedienungsanleitung

11 Oktober 2024
OnePlus

OnePlus 9RT 5G Bedienungsanleitung

9 Oktober 2024
Profoon

Profoon PDX-1520 Bedienungsanleitung

7 Oktober 2024
MT Logic

MT Logic TE-5740MTWG Bedienungsanleitung

7 Oktober 2024
D-Link

D-Link DI-102 Bedienungsanleitung

6 Oktober 2024
Belgacom

Belgacom Specifics 100 Bedienungsanleitung

5 Oktober 2024