Music Hall Classic Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Music Hall Classic (11 Seiten) in der Kategorie Plattenspieler. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/11
music hall
classic
INSTRUCTION MANUAL
music hall
http://www.musichallaudio.com
2
1. Read these instructions carefully.
2. Keep these instructions for later reference.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use the device near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Always ensure a sufficient ventilation. Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including ampliers) that
produce or radiate heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades, one being
wider than the other. A grounding- type plug has two blades and a third grounding prong. The wide blade or the third
prong is provided for your safety. If the provided plug does not t into your outlet, consult an electrician for replacement of
the obsolete outlet.
10. Protect the power cord from being walked on or pinched or otherwise damaged, particularly at plugs, convenience
receptacles, and the point where they exit from the device.
11. Only use attachments/accessories that have been specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket or table specied by the manufacturer, or sold along with the device.
When a cart is used, use caution when moving the cart/device combination to avoid injury from tip-over.
13. Unplug this device during lightning storms or when not being used for longer periods of time.
14. Refer all servicing to qualied service personnel only. Servicing is required when the device has been damaged in any
way, such as: Power-supply cord or plug has been damaged, liquid has been spilled or entered the device, the device has
been exposed to rain or moisture, or objects have fallen into the device, the device does not work normally, or it has been
dropped.
15. Please keep the unit in a good ventilation environment at any time.
WARNING!/ AVERTISSEMENT!
To reduce the risk of re or an electrical shock, do not expose this device to rain or moisture. The device must not be exposed to
dripping or splashing water. Furthermore no objects lled with liquids, such as vases, shall be placed on the device.
An de réduire les risques d'incendie ou de choc électrique, n'exposez pas cet appareil à la pluie et à l'humidité. L'appareil ne doit pas être
expo au ruissellement ni à la projecon d'eau et aucun objet contenant un liquide, tel qu'un vase, ne doit être podessu s.
CAUTION: In order to reduce the risk of an electrical shock, do not remove any cover. There are no
user-serviceable parts inside the device. Refer servicing to qualied service personnel only.
ATTENTION : Pour réduire le risque de choc électrique, ne déposez aucun capot. L'appareil ne conent aucun
composantparable par l'ulisateur. Toute réparaon doit être conée à un centre de services qualié.
Caution Marking and rating plate was located at rear enclosure of the apparatus.
Averssement La plaque signalétique est située a l'arrière de l'appareil.
When the mains plug or appliance coupler is used as disconnect device, it shall remain readily operable.
lorsque la prise du RESEAU D'ALIMENTATION sur l'appareil est ulisée comme appareil de déconnexion, cet appareil doit demeurer aisément
accessible.
The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains,
etc. Minimum distances 10cm around the apparatus for suicient ventilation. ;
Il convient que l'aéraon ne soit pas gênée par l'obstrucon des ouvertures d'aéraon par des objets tels que journaux, nappes, rideaux,
etc.;Distance minimale 10cm autour de l'appareil pour une aéraon susante.
No naked ame sources, such as lighted candles, should be placed on the apparatus;
il convient de ne pas placer sur l'appareil de sources de ammes nues, telles que des bougies allues.
Use the apparatus only in moderate climate. a
N'uliser l 'appareil que des climat modéré. dans
The lightning ash with the arrowhead symbol within the equilateral triangle is intended to alert the user to the presence of
un- constitute a risk of insulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to
an electrical shock.
Le symbole de l'éclair terminé par une flèche sit à l'intérieur d'un triangle équilatéral avertit l'utilisateur de la présence de tension
dangereuse non isolée dans l'appareil, dont l’amplitude peut constuer un risque de choc électrique.
The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and
maintenance (servicing) instructions in the literature accompanying this appliance.
Le symbole du point d’exclamaon dans un triangle équilatéral vise à averr l’ulisateur de la présence, dans la documentaon
accompagnant cet appareil, d’importantes instrucons de fonconnement et d’entreen.
IMPORTANT SAFETY INSTRUCTIONS
3
Some assembly is required before you can begin to use your new unit.
Please follow the assembly instruction below before attempting to use your new turntable.
Do not connect your turntable to a power outlet with the AC adaptor until you are nished with assembly.
Do not remove the twist tie for clamping the tone arm until assembly is completed.
PRECAUTIONS ON PLACEMENT:
1. Do not place the unit in a location where it will be exposed to direct sunlight or near any type of heating appliance.
2. Do not place the unit in a location where there is high humidity or a lot of dust.
3. Cartridge may pick up slight sound pressure or vibrations of nearby speakers. For best results, do not install this unit
too close to speakers.
4. Install this unit on a horizontal surface that is stable and vibration free.
5. The rubber feet have been specially designed to isolate the unit from excess vibration. The feet may also be used to
stabilize the main body horizontally.
ASSEMBLY
1. Remove the main unit with the packing from the box and remove the packing.
2. Set the turntable platter onto the center spindle.
VERY IMPORTANT!!
Do not forget to attach rubber belt to motor for correct operation. After placing the
Turntable Platter onto the turntable through the Center Spindle, move one of the large
windows on the Platter to top right corner. Attach rubber belt around motor. (Rubber belt is
already attached to the underside of the Turntable Platter.)
3. Set the platter mat on the platter.
4. Installation of cartridge:
When installing a cartridge, refer to the operating instructions of that cartridge.
During installation, attach the stylus protector to guard the stylus tip from damage.
(a) Connect the lead wires to the cartridge terminals. The terminals of most cartridges are color-coded.
Connect each lead wire to the terminal of the same color.
White (L+) Left channel+
Blue (L- Left channel- )
Red (R+) Right channel+
Green (R-) Right channel-
(b) Install the cartridge to the headshell and tighten it with screws provided with the cartridge.
5. Insert the headshell with pre-mounted cartridge into the front end of the tone arm, and then turn the lock nut
counterclockwise with the headshell rmly held horizontally.
6. Slide counterweight on the tone arm. Twist it lightly and it will screw onto the rear shaft of the tone arm. Advancing
the counterweight to the white line will give you an eective tracking force of 2.0g and allow you to skip step #7.
7. Adjustment of horizontal “zero balance and stylus pressure:
(a) Remove the stylus protector from the headshell, do not touch the stylus tip during the adjustment.
(b) Set the cueing lever to the lowered position.
(c) Release the tone arm clamp and lift the tone arm from the arm rest to free it.
(d) Rotate the counterweight until the tone arm is approximately balanced horizontally (oats freely).
(e) Refasten the tone arm with the tone arm clamp.
(f) Hold the counterweight stationary with one hand and rotate only the stylus-pressure ring to bring the number "0"
of the ring into alignment with the center line on the tone arm rear shaft.
(g) Rotate the counterweight including the stylus-pressure ring counterclockwise until the scale shows the value
corresponding to the pressure of the stylus used. Should you use a separate Stylus, please follow the correct
tracking force as specied by the manufacturer’s instructions. The tracking force for the included cartridge is 2.0
grams.
8. Set the anti-skating control knob to the same value as the stylus pressure.
9. Install the dust cover to the main unit’s dust cover hinges.
SETUP and ASSEMBLY
NOTE:


Produktspezifikationen

Marke: Music Hall
Kategorie: Plattenspieler
Modell: Classic

Brauchst du Hilfe?

Wenn Sie Hilfe mit Music Hall Classic benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Plattenspieler Music Hall

Bedienungsanleitung Plattenspieler

Neueste Bedienungsanleitung für -Kategorien-