Mtx Audio X1000D Bedienungsanleitung
Lesen Sie kostenlos die š deutsche Bedienungsanleitung fĆ¼r Mtx Audio X1000D (36 Seiten) in der Kategorie Autoradio. Dieser Bedienungsanleitung war fĆ¼r 8 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/36
Owner's Manual
X1000D
Input/output panel layout
1. RCA input jacks ā These RCA input jacks are for use with source units that have RCA or Line level outputs. A
source unit with a minimum level of 200mV is required for proper operation.
The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering
the system.
2. Speaker level inputs ā This input will allow the ampliļ¬er to operate from source units with speaker-level outputs.
Output speaker leads from the source unit should be tied directly to the wire harness provided with the ampliļ¬er.
**Note: When speaker level inputs are used, a remote turn on wire must used to switch the ampliļ¬er on and
off.**
3. Gain control ā This control is used to match the input sensitivity of the ampliļ¬er to the particular source unit
that you are using. The operating range varies from 200mV gain fully clockwise to 5V input gain fully counter
clockwise.
Introduction
Thank you for choosing an MTX XTHUNDER Ampliļ¬er to power your car audio system. Each MTX XTHUNDER
ampliļ¬er is CEA2006 certiļ¬ed which means you have a 100% guarantee that your ampliļ¬er will deliver every Watt
it is rated at.
Speciļ¬cations
Ratings:
ā¢ CEA2006 certiļ¬ed Power Output : 700 watts RMS at 4 ohm and ā¤ 1% THD+N
ā¢ CEA2006 certiļ¬ed Power Output : 1000 watts RMS at 2 ohm and ā¤ 1% THD+N
ā¢ Signal-to-Noise Ratio (1 watt) : >75dB
ā¢ THD+Noise (Distortion) (1 watt) : ā¤ 1%
ā¢ Frequency Response (-3dB) : 20Hz-200Hz
ā¢ Maximum Input Signal : 5V
ā¢ Maximum Sensitivity : 200mV
ā¢ Dimensions : 315mm x 210mm x 50mm
ā¢ Crossover : Low pass 24dB 40Hz-200Hz
ā¢ Subsonic ļ¬lter : variable 20Hz-50Hz
ā¢ High level input connection
X1000D - ampliļ¬er owner's manual
2
www.mtx.com - www.mtxaudio.eu
4. Input selection switch - This switch, is used to match the ampliļ¬erās input to the source unitās or DSP unitās output.
If your source unit or DSP unit has a mono output you can select: Mono L or Mono R as your input connection,
if your source unit or DSP unit has a stereo output you need to select SUM for input now both RCA inputs of the
ampliļ¬er are active and the stereo signal will be converted into a mono signal by the ampliļ¬er.
5. EBC port - For connecting the included External Bass Control. A remote bass control so the bass can be adjusted
from the driverās seat.
6. Subsonic ļ¬lter control - This control is used to select the desired (high pass) subsonic ļ¬lter frequency. The sub-
sonic ļ¬lter protects the subwoofer(s) against too low frequencies that can dammage the subwoofer(s).
7. Low pass x-over frequency control - This control is used to select the desired low pass x-over frequency. The
frequency can be adjusted between 40Hz and 200Hz.
8. Speaker Terminals ā Be sure to observe speaker polarity through the system. Failing to wire the speakers in
proper phase could result in a loss of bass response and/or poor
overall sound quality.
Caution : The X1000D ampliļ¬er is not recommended for loads below 2 ohms.
9. Fuse - For convenience, all MTX XTHUNDER ampliļ¬ers utilize ATC type fuses. For continued protection in the
event that a fuse blows, replace the fuse only with the same value.
Caution : The power fuse on the amp is for protecting the amp against overdrive. To protect the vehicleās electrical
system, an additional fuse is required within 30cm of the battery on the 12V+ cable.
10. Power Terminal ā This is the main power input for the ampliļ¬er and must be connected directly to the positive
terminal of the car battery for the ampliļ¬er to operate properly. Use caution when running this cable through the
vehicule. Try to avoid running this cable along side the input RCA cables, antenna cabling, or other sensitive equi-
pment as the large amount of current ļ¬owing through this cable can induce noise into your system. It is also very
important to have a tight connection to ensure maximum performance. We recommend to use 10mm2 or larger
power wire with the MTX XTHUNDER X1000D ampliļ¬er.
11. Remote Terminal ā The Ampliļ¬er can be turned on by applying 12 volts to this terminal. Typically this voltage is
supplied by a wire from the source unit marked āremoteā or āelectric antennaā.
12. Ground Terminal ā A good quality ground is required for your Ampliļ¬er to operate at peak performance. A short
length of cable the same gauge as your power cable should be used to attach the ground terminal directly to the
chassis of the vehicle. Always scrape or sand any painted surfaces to expose bare metal where the ground wire
will attach.
3
Produktspezifikationen
| Marke: | Mtx Audio |
| Kategorie: | Autoradio |
| Modell: | X1000D |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Mtx Audio X1000D benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Autoradio Mtx Audio
16 August 2024
16 August 2024
14 August 2024
14 August 2024
14 August 2024
13 August 2024
13 August 2024
12 August 2024
12 August 2024
11 August 2024
Bedienungsanleitung Autoradio
- Autoradio Clatronic
- Autoradio Sanyo
- Autoradio Manta
- Autoradio Medion
- Autoradio Nedis
- Autoradio Philips
- Autoradio SilverCrest
- Autoradio Sony
- Autoradio Tevion
- Autoradio Panasonic
- Autoradio LG
- Autoradio AEG
- Autoradio Maginon
- Autoradio Technaxx
- Autoradio Denver
- Autoradio ECG
- Autoradio MarQuant
- Autoradio Renkforce
- Autoradio Telefunken
- Autoradio Trevi
- Autoradio Blaupunkt
- Autoradio Grundig
- Autoradio Kenwood
- Autoradio Daewoo
- Autoradio Pyle
- Autoradio Telestar
- Autoradio Aiwa
- Autoradio Auna
- Autoradio Caliber
- Autoradio Lenco
- Autoradio Pioneer
- Autoradio JBL
- Autoradio JVC
- Autoradio KrĆ¼ger And Matz
- Autoradio Muse
- Autoradio Vieta
- Autoradio Hifonics
- Autoradio Akai
- Autoradio Dual
- Autoradio Hyundai
- Autoradio MT Logic
- Autoradio Orava
- Autoradio Orion
- Autoradio Skoda
- Autoradio Varta
- Autoradio Elta
- Autoradio Sencor
- Autoradio Biltema
- Autoradio OneConcept
- Autoradio Mercedes-Benz
- Autoradio Boston Acoustics
- Autoradio Harman Kardon
- Autoradio Magnat
- Autoradio XOMAX
- Autoradio Parrot
- Autoradio Smart
- Autoradio Alpine
- Autoradio Ford
- Autoradio Volkswagen
- Autoradio Volvo
- Autoradio Opel
- Autoradio MB Quart
- Autoradio Overmax
- Autoradio Rockford Fosgate
- Autoradio Crunch
- Autoradio Pure
- Autoradio NextBase
- Autoradio Norauto
- Autoradio AXTON
- Autoradio Clarion
- Autoradio Mac Audio
- Autoradio Conceptronic
- Autoradio Scott
- Autoradio Audiovox
- Autoradio Becker
- Autoradio ESX
- Autoradio Zenec
- Autoradio VDO
- Autoradio SPC
- Autoradio Roadstar
- Autoradio TokaĆÆ
- Autoradio Audison
- Autoradio Macrom
- Autoradio Phonocar
- Autoradio Xblitz
- Autoradio Autovision
- Autoradio Boss
- Autoradio Hertz
- Autoradio Renault
- Autoradio Fiat
- Autoradio Kicker
- Autoradio Jensen
- Autoradio DLS
- Autoradio Eclipse
- Autoradio Eltax
- Autoradio Emphaser
- Autoradio Focal
- Autoradio Fusion
- Autoradio Ground Zero
- Autoradio Helix
- Autoradio Impulse
- Autoradio Lanzar
- Autoradio Naxa
- Autoradio Revo
- Autoradio Rodek
- Autoradio RTO
- Autoradio Sevic
- Autoradio Sirius
- Autoradio Soundstream
- Autoradio Spectron
- Autoradio Stinger
- Autoradio Tamashi
- Autoradio Toxic
- Autoradio Twister
- Autoradio Ultimate
- Autoradio US Blaster
- Autoradio VDO Dayton
- Autoradio Voxx
- Autoradio VW
- Autoradio Watssound
- Autoradio RetroSound
- Autoradio Kunft
- Autoradio Shuttle
- Autoradio Multilaser
- Autoradio Brigmton
- Autoradio Lark
- Autoradio Majestic
- Autoradio SoundMAX
- Autoradio Scion
- Autoradio Raveland
- Autoradio Planet Audio
- Autoradio Adcom
- Autoradio Sendai
- Autoradio Cartronix
- Autoradio Dension
- Autoradio Mystery
Neueste Bedienungsanleitung fĆ¼r -Kategorien-
16 Oktober 2024
16 Oktober 2024
12 Oktober 2024
12 Oktober 2024
8 Oktober 2024
7 Oktober 2024
7 Oktober 2024
6 Oktober 2024
5 Oktober 2024
5 Oktober 2024