Make Noise DPO Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Make Noise DPO (17 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 25 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/17
DPO
Limited WARRANTY:
Make Noise warrants this product to be free of defects in materials or construction for a period of one year
from the date of .purchase (proof of purchase/invoice required)
Malfunction resulting from wrong power supply voltages, backwards power cable connection, abuse of the
product or any other causes determined by Make Noise to be the fault of the user are not covered by this
warranty, and normal service rates will apply.
During the warranty period, any defective products will be repaired or replaced, at the option of Make Noise,
on a return-to-Make Noise basis, with the customer paying the transit cost to Make Noise.
Please contact Make Noise for Return To Manufacturer Authorization.
Make Noise implies and accepts no responsibility for harm to person or apparatus caused through
operation of this product.
Please contact with any questions, needs & comments... otherwise go technical@makenoisemusic.com
MAKE NOISE.
http://www.makenoisemusic.com
THANK YOU
Beta Analyst: Surachai
Test Subjects: Rob Lowe, Joseph Raglani
Spiritual Advisor: Richard Devine
Special Thanx to Don Buchla for his original and inspirational 259 and Music Easel.
Installation:
The Make Noise DPO is an electronic signal generator requiring 70mA of +/-12V of regulated power and
properly formatted distribution receptacle to operate. It is designed to be used within the euro format
modular synthesizer system.
Go to http://www.doepfer.de/a100_man/a100t_e.htm for the details of this format.
To install, find 28HP of space in your euro-rack synthesizer system, confirm proper installation of included
power cable on backside of module (see picture below), plug the 16 pin end power cable into the euro-rack
style power distribution board, minding the polarity so that the RED stripe on the cable is oriented to the
NEGATIVE 12 volt supply line. This is USUALLY at the bottom.
Please refer to your case manufacturers’ specifications for location of the negative supply.
Proper installation of included power cable on module.
Please note the RED BAND.


Produktspezifikationen

Marke: Make Noise
Kategorie: Nicht kategorisiert
Modell: DPO

Brauchst du Hilfe?

Wenn Sie Hilfe mit Make Noise DPO benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Make Noise

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-