Lezyne Power Drive XL Bedienungsanleitung

Lezyne Fahrradlampe Power Drive XL

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Lezyne Power Drive XL (1 Seiten) in der Kategorie Fahrradlampe. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/1
Lezyne LED User e - V1-R1Guid
Thank you for choo ng Lezyne LED Lights. Our LED lights are cordless, self-contained units with hig p ered LEDs si h- ow
and rechargeable/replaceable Lithium Ion batteries. Lezyne LED ghts are hig performance sporting lights intended Li h-
for rious outdoor activities. Always use care when operati . va ng
Adventures in the dark are inherently dange us activities, we strongly advise you to take caution at night. Lezyne LED ro
Lights w l greatly improve your visib ity, but there are st l many dangers. Lezyne recommends for every night adventure il il il
- Wear protective gear
- Dress with highly v ible clothingis
- Use a RED rear-facing tail light
- Tr el with proper tools and tire repairav
MOUNTING)
CHARGING)
The following a essories are included with your Lezyne LED ght:cc Li
thumb screw (1)
Cover
USB ni-B PortMi
25.4 mm clamp (1) 31.8mm clamp (1)
Mini-B USB c rging cable (1)ha
*Super Drive & P e r Driveow * ni Drive OnlyMi
top ate (1)pl
Please
READ THIS ENTIRE NUALMA
bef e ope tion in order to sure p per use and care of y r new or ra en ro ou
yourself about lighting laws in the country of intended use.
In the United States, Lezyne LED ghts carry a two (2) year warranty from the ori nal p chase date to the ori nal Li gi ur gi
owner (proof of p chase is q red). This warranty covers materials and manufacturing defects on the LED light hou ng, ur re ui si
electronics, LED, and the mounting bracket suppli . Lezyne tteries carry a 6 nth warranty against any m ufacturined Ba mo an g
defects. Issues not covered by the warranty include rmal wear and ar, improper installation, attempting to access no te
electronics, modifying electronics, damage or failure due to acc ent, misuse, abuse, and neglect. id
Please register our LED Light at w.lezyne.com/reg.html. Contact our l al dealer or visit w.lezyne.com for y ww y oc ww
com ete warranty information and contact information regarding warranty issues. pl
Fo idr warranty issues outs e of the United States, ease contact the distributor/retailer for pl
your country or region directly.
Lezyne LED ghts are meant to be ope ted in tempe tures between -15 C and 45 C (5 F and 113 F). Lezyne LED Li ra ra Ëš Ëš Ëš Ëš
Lights should only be ope ted in supplied mounting brack . ra et
DO NOT
D NOTO look directly into the light beam, or shine in another person’s eyes.
Lezyne LED ghts are water r istant under normal c ditions, but are NOT waterproof. Li es on
DO NOT S MERGE UB
UN R WATERDE
. If m sture gets ins e the body, remove the rear cap and battery, open the USB plug and air-out oi id
until com etely dry. pl
NEv ER ATTEMpT TO REMOv E THE f R T LENS AND ELECTRONICS.ON D ng so w l void your warranty. oi il
If rep cing the battery only use LIR 18650 2 p PROTECTED (part # 4712805977314) or LIR 123A 2 p la Am Am
PROTECTED (part # 4712805977321) dep ing on your model. Make certain the ) P itive terminal is end (+ os
18650 battery. See r instruct ns on inst ling the battery. CHARGING fo io al
A r inder that Lezyne LED Lights are high-powered s rting lights and should only be operated in the em po
Lezyne A Inc./Lezyne Co., Ltd. does not accept any ab ity for injuries or other damages re l ng from the use of US li il su ti
this product in any circumstances.
The following instruction m ual covers the operation and care of the Super Drive, Power Drive, and Mini Drive Lezyne an
LED ght systems. Identify your light model below for further information regarding batteries and mode settings.Li
SUPER DR EIV
- 450 max Lumens
P ER DR EOW IV
- 300 max Lumens
MINI DR EIV
- 150 max Lumens
1. Remove light body from mounting bracket top plate.
2. Remove thumbscrew from mounting bracket top plate and discard packa .ging
3. Select the correct bar cl p for your handlebar ameter.am di
Ass bled with top ateem pl
and umb screw.th
Press ta b d now
to release ghtli
Tighten umbth
screw to secur e
4. Sl e the cl p over your bars with the bolt le facing forward, place the top mount on the cl p and insert id am ho am
thumbscrew from ttom.bo
5. Tighten thumbscrew until snug; cl p should not rotate on the bars. am D NO OvERTIGHTEN.O T
6. Sl e the LED light into top mount from the front and push until body clicks in place.id
7. To remove LED light, press the release tab and pull light forward. Take caution as light body may be warm.
8. Adjust the pitch and yaw of your light so the terrain in front of you is fully illuminat .ed
9. After adjusting horizontal yaw position, check to make sure thumbscrew is properly tighten .ed
1. Locate the power button on top of the light.
2. Press and ld the button for one and a half (1.5) seconds to turn the light on, then release.ho
3. Continue to press the button to cycle th ugh modes. ro
brighten, then release the button.
With a fully charged Lezyne battery our Lezyne LED ght w l h e a roximately the following run mes and light y Li il av pp ti
output at the below mode settings: (Lumens=lm)
Low battery warning: Your Lezyne LED ght is equipped with a battery monitor that alerts you when the battery is low. Li
discharg . It is recommended that you fully charge your light before the next use. ed
Thermal protection circuit: Lezyne LED ghts are protected by a thermal detection system. If the operating temperature Li
change the light back to the previous mode setti . ng
USB cable. ALWAYS use your supplied USB cable to charge your light.
To charge your light:
S r D ve power D ve Min D veupe ri ri i ri
4 4 3
It is acce able to plug our USB cable into a USB wall outlet charger ou may already h e, but this w l not change pt y y av il
char ng times. The Lezyne electronics w l regulate the incoming voltage for proper char .gi il ging
Leaving the LED ght unit pl ed into a power so ce l ger than the req red charge time is ok, it w l not damage Li ugg ur on ui il
the electronics.
When storing your Lezyne LED Light for l g periods of time it is su ested that you charge it every 60 days to keep the on gg
than 4 months, remove the battery from the light. Before your next use fully charge the battery.
In order to ensure proper function of your light:
- If your lens is dirty, use a soft/d p cloth to wipe dirt away. am
- Do not use harsh materials or chemicals to clean as these may scratch the lens surface.
- Never use a se or hig pressure washer to clean your light. ho h-
- When storing the LED ght, charge the battery every 60 days. See Li CHARGING.
Now that ou know everything there is to know about our Lezyne LED ght, charge it up and go for an adventure in y y Li
the dark! If you h e any questions regarding your product ease v it w.lezyne.com for contact information. Thank av pl is ww
you for your Lezyne LED ght p chase.Li ur
- International wall char ng kit (1-LED-C RGE-V104)gi HA
- LIR 650 Battery (1-LED-BAT- 650-V104)18 18
- LIR123A Battery (1-LED-BAT-LIR123A-V104)
- Handle Bar Mounting Kit for 25.4mm and 31.8mm bars (1-LED-HBMOUNT-V104)
Front Lens
Cap
Horizontal Yaw Adjustment
2. Locate and open the USB rubber plug.
3. Insert the small end of the supplied USB cable into the light hou .sing
4. Plug the opposite end of the USB cable into your computer’s USB port OR a USB wall outlet charger. (USB wall
outlet charger sold separately)
Please try another USB port that is a powered so ce.ur
7. Charge for recommended amount of time (see chart below).
9. Remove the USB cable and reinsert rubber protective cover securely (It is important to note that the USB
protective cover is com etely sealed).pl
Char ng times ry according to battery size. Please see char ng table for your model of light. Lezyne LED ghts use gi va gi Li
time of your light.
Spare batteries: If you choose to carry extra batteries it is ok to change the batteries at any p nt during use. Please note oi
that only Lezyne branded LIR 18650 2 Amp PROTECTED batteries may be used with Lezyne LED ghts. Lezyne batteries Li
h e a protected batter y circuit. When insta ing the battery ease note the direction of the (+) pola ty. av ll pl ri
25.4 mm clamp31.8mm clamp
25. m4m
S r D ve power D ve Min D veupe ri ri i ri
High 450 lm / 1.5hr 300 lm / 2hr 150 lm / 1hr
Med 2.5h r r 1.5h r3h
Low 4hr 5.5hr r3h
Flash 1 5hr 6hr 4hr
Flash 2 X X 4.5h r


Produktspezifikationen

Marke: Lezyne
Kategorie: Fahrradlampe
Modell: Power Drive XL

Brauchst du Hilfe?

Wenn Sie Hilfe mit Lezyne Power Drive XL benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Fahrradlampe Lezyne

Bedienungsanleitung Fahrradlampe

Neueste Bedienungsanleitung für -Kategorien-