Kingston HyperX Savage Bedienungsanleitung
Kingston
Blitzlicht
HyperX Savage
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kingston HyperX Savage (2 Seiten) in der Kategorie Blitzlicht. Dieser Bedienungsanleitung war für 13 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/2
DESCRIPTION
Document No. 480 04/22/15 Page 17113-001.B00
SPECIFICATIONS
*Power will vary depending on the SDRAM used.
HX316C9SR/4
4GB (4GB 512M x 64-Bit)
DDR3-1600 CL9 240-Pin DIMM
Continued >>
kingston.com/hyperx
FEATURES
HyperX HX316C9SR/4 is a 512M x 64-bit (4GB) DDR3-1600
CL9 SDRAM (Synchronous DRAM) 1Rx8, memory module,
based on eight 512M x 8-bit FBGA components per module.
Each module supports Intel® XMP (Extreme Memory
Profiles). Each module has been tested to run at DDR3-1600
at a low latency timing of 9-9-9 at 1.5V. The SPDs are
programmed to JEDEC standard latency DDR3-1600
timing of 11-11-11 at 1.5V. Each 240-pin DIMM uses gold
contact fingers. The JEDEC standard electrical and
mechanical specifications are as follows:
• JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal banks
• Programmable CAS latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write (either on the fly using A12 or
MRS)
• Bi-directional Differential Data Strobe
• Internal (self) calibration: Internal self calibration through ZQ
pin (RZQ: 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°Cº
• Asynchronous Reset
• Height 1.311” (33.30mm), w/heatsink, single sided component
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
11 cycles
48.125ns(min.)
260ns(min.)
35ns(min.)
TBD W*
94 V - 0
0o C to +85o C
-55o C to +100o C
XMP TIMING PARAMETERS
•JEDEC: DDR3-1600 CL11-11-11 @1.5V
•XMP Profile #1: DDR3-1600 CL9-9-9 @1.5V
Document No. 4807113-001.B00 Page 2
continued HyperX
FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX
kingston.com/hyperx
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the
published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than
the published speed. Overclocking or modifying your system timing may result in damage to computer components.
MODULE DIMENSIONS
MODULE WITH HEAT SPREADER
7.9 mm
133.35 mm
33.3 mm
• Height 1.311” (33.30mm), w/heatsink, single sided component
Produktspezifikationen
| Marke: | Kingston |
| Kategorie: | Blitzlicht |
| Modell: | HyperX Savage |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Kingston HyperX Savage benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Blitzlicht Kingston
21 August 2024
21 August 2024
Bedienungsanleitung Blitzlicht
- Blitzlicht Corsair
- Blitzlicht Gigabyte
- Blitzlicht Philips
- Blitzlicht Sony
- Blitzlicht Panasonic
- Blitzlicht Toshiba
- Blitzlicht Western Digital
- Blitzlicht Pentax
- Blitzlicht SanDisk
- Blitzlicht Transcend
- Blitzlicht Advantech
- Blitzlicht Silicon Power
- Blitzlicht Kingston Technology
- Blitzlicht Goodram
- Blitzlicht Cactus
Neueste Bedienungsanleitung für -Kategorien-
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024