Kicker CX300.4 Bedienungsanleitung

Kicker Autoradio CX300.4

Lesen Sie kostenlos die šŸ“– deutsche Bedienungsanleitung fĆ¼r Kicker CX300.4 (32 Seiten) in der Kategorie Autoradio. Dieser Bedienungsanleitung war fĆ¼r 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/32
Ownerā€™s Manual |
Manual del Propietario |
Benutzerhandbuch |
Manuel dā€™utilisation |
CX Amplifiers
2012 CX 4 Channel Amps Rev F indd 1
2
CX.4-SERIES AMPLIFIERS
OWNERā€™S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER ampliļ¬ er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4ā€ (10cm) of open
ventilation for the ampliļ¬ er. If possible, mount the ampliļ¬ er in the climate-controlled passenger compartment. Drill
four holes using a 7/64ā€ (3mm) bit and use the supplied #8 screws to mount the ampliļ¬ er.
The KICKER CX Ampliļ¬ ers are capable of space-saving vertical mounting. Use a 2.5mm hex key (Allen wrench)
to loosen the endpanel, remove the existing brackets, then insert and tighten the double-slotted brackets to the
ampliļ¬ er as illustrated on the next page.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Serial Number:
Model: CX300.4
RMS Power
@ 14.4V, 4 stereo, 1% THD+Nļ— ļ‚£
@ 14.4V, 2 stereo, 1% THD+Nļ— ļ‚£
@ 14.4V, 4 bridged, 1% THD+Nļ— ļ‚£
40W x 4
75W x 4
150W x 2
Length | in. [mm] 12-7/16 [320]
Height | in. [mm] 2-3/8 [60]
Width | in. [mm] 7-3/16 [180]
Frequency Response Ā± 1dB 10Hzā€“20KHz
Signal-to-noise Ratio >95dB, A-weighted, re: rated power
Input Sensitivity Low Level: 125mVā€“5V
High Level: 250mVā€“10V
Electronic Crossover Selectable: HI, LO or OFF; Variable 50ā€“200Hz @ 12dB/Octave
Bass Boost Variable 0ā€“12dB @ 40Hz
Pro Tip: To get the best performance from your new KICKER Ampliļ¬ er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
MODEL: CX300.4
2012 CX 4 Channel Amps Rev F indd 2
3
Wiring: Disconnect the vehicleā€™s battery to avoid an electrical short. Then, connect the ground wire to the
ampliļ¬ er. Make the ground wire short, 24ā€ (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicleā€™s chassis. Adding an additional ground wire of this same gauge (or larger) between the
batteryā€™s negative post and the vehicle chassis is recommended.
The CX ampliļ¬ er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereoā€™s source unit. A high-level signal can be run from the source unitā€™s speaker outputs to the
stereo RCA input on the end panel of the ampliļ¬ er using the KICKER ZISL as shown (make sure you set the CX
ampliļ¬ erā€™s input level switch to ā€œHIā€). Alternatively, the signal can be delivered to the ampliļ¬ er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the ampliļ¬ er to ā€œLOā€. Keep the
audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring,
cross it at a 90 degree angle.
source unit
high-level speaker
outputs
to ampliļ¬ er
shield
+
ā€“
core conductor KICKER ZISL
source unit high-level
speaker outputs
OR to ampliļ¬ er
double-slotted
bracket
hex screws
ampliļ¬ er side panel
VERTICAL MOUNTING
Install a fuse within 18ā€ (45cm) of the battery and in-line with the power cable connected to your ampliļ¬ er. If you
ever need to remove the ampliļ¬ er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the ampliļ¬ er--just the opposite as when you installed it.
+
+
ā€“
ā€“
2012 CX 4 Channel Amps Rev F indd 3


Produktspezifikationen

Marke: Kicker
Kategorie: Autoradio
Modell: CX300.4

Brauchst du Hilfe?

Wenn Sie Hilfe mit Kicker CX300.4 benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Autoradio Kicker

Bedienungsanleitung Autoradio

Neueste Bedienungsanleitung fĆ¼r -Kategorien-