Kicker CX300.1 Bedienungsanleitung

Kicker Autoradio CX300.1

Lesen Sie kostenlos die šŸ“– deutsche Bedienungsanleitung fĆ¼r Kicker CX300.1 (28 Seiten) in der Kategorie Autoradio. Dieser Bedienungsanleitung war fĆ¼r 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/28
Ownerā€™s Manual |
Manual del Propietario |
Benutzerhandbuch |
Manuel dā€™utilisation |
CX Amplifiers
2012 CX Mono Amps Rev I.indd 1
2012 CX Mono Amps Rev I.indd 1
2012 CX Mono Amps Rev I.indd 1
2012 CX Mono Amps Rev I.indd 12012 CX Mono Amps Rev I.indd 1 6/22/2012 2:32:04 PM
6/22/2012 2:32:04 PM
6/22/2012 2:32:04 PM
6/22/2012 2:32:04 PM6/22/2012 2:32:04 PM
2
CX.1-SERIES AMPLIFIERS
OWNERā€™S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER ampliļ¬ er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4ā€ (10cm) of open
ventilation for the ampliļ¬ er. If possible, mount the ampliļ¬ er in the climate-controlled passenger compartment. Drill
four holes using a 7/64ā€ (3mm) bit and use the supplied #8 screws to mount the ampliļ¬ er.
The KICKER CX Ampliļ¬ ers are capable of space-saving vertical mounting. Use a 2.5mm hex key (Allen wrench)
to loosen the endpanel, remove the existing brackets, then insert and tighten the double-slotted brackets to the
ampliļ¬ er as illustrated on the next page.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
Model: CX300.1 CX600.1 CX1200.1
RMS Power
@ 14.4V, 4 1% THD+NĪ© mono, ļ‚£
@ 14.4V, 2 mono, 1% THD+NĪ©ļ‚£
150W x 1
300W x 1
300W x 1
600W x 1
600W x 1
1200W x 1
Length | in [mm] 8-1/8 [210] 8-1/8 [210] 12-1/16 [310]
Speciļ¬ cations common to all models:
Height | in [mm] 2-3/8 [60]
Width | in [mm] 7-3/16 [180]
Frequency Response Ā± 1dB 25Hzā€“200Hz
Signal-to-noise Ratio >95dB, A-weighted, re: rated power
Input Sensitivity Low Level: 125mVā€“5V
High Level: 250mVā€“10V
Electronic Crossover Variable Lo-pass 50Hzā€“200Hz, 12dB/octave
Bass Boost Variable 0ā€“12dB @ 40Hz
Subsonic Filter 25Hz, 24dB/octave
Remote Bass Yes [sold separately]
Pro Tip: To get the best performance from your new KICKER Ampliļ¬ er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
MODEL: CX300.1 / CX600.1 / CX1200.1
2012 CX Mono Amps Rev I.indd 2
2012 CX Mono Amps Rev I.indd 2
2012 CX Mono Amps Rev I.indd 2
2012 CX Mono Amps Rev I.indd 22012 CX Mono Amps Rev I.indd 2 6/22/2012 2:32:28 PM
6/22/2012 2:32:28 PM
6/22/2012 2:32:28 PM
6/22/2012 2:32:28 PM6/22/2012 2:32:28 PM
3
Wiring: Disconnect the vehicleā€™s battery to avoid an electrical short. Then, connect the ground wire to the
ampliļ¬ er. Make the ground wire short, 24ā€ (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicleā€™s chassis. Adding an additional ground wire of this same gauge (or larger) between the
batteryā€™s negative post and the vehicle chassis is recommended.
The CX ampliļ¬ er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereoā€™s source unit. A high-level signal can be run from the source unitā€™s speaker outputs to the
stereo RCA input on the end panel of the ampliļ¬ er using the KICKER ZISL as shown (make sure you set the CX
ampliļ¬ erā€™s input level switch to ā€œHIā€). Alternatively, the signal can be delivered to the ampliļ¬ er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the ampliļ¬ er to ā€œLOā€. Either input
method will provide a low-level output signal at the RCA output, which effectively passes the audio signal to
another ampliļ¬ er or component. Keep the audio signal cable away from factory wiring harnesses and other
power wiring. If you need to cross this wiring, cross it at a 90 degree angle.
source unit
high-level speaker
outputs
to ampliļ¬ er
shield
double-slotted
bracket
+
+
+
ā€“ā€“
ā€“
core conductor KICKER ZISL (optional)
source unit high-level
speaker outputs
OR to ampliļ¬ er
VERTICAL MOUNTING
hex screws
ampliļ¬ er side panel
2012 CX Mono Amps Rev I.indd 3
2012 CX Mono Amps Rev I.indd 3
2012 CX Mono Amps Rev I.indd 3
2012 CX Mono Amps Rev I.indd 32012 CX Mono Amps Rev I.indd 3 6/22/2012 2:32:29 PM
6/22/2012 2:32:29 PM
6/22/2012 2:32:29 PM
6/22/2012 2:32:29 PM6/22/2012 2:32:29 PM


Produktspezifikationen

Marke: Kicker
Kategorie: Autoradio
Modell: CX300.1

Brauchst du Hilfe?

Wenn Sie Hilfe mit Kicker CX300.1 benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Autoradio Kicker

Bedienungsanleitung Autoradio

Neueste Bedienungsanleitung fĆ¼r -Kategorien-