Kicker 46HDBL69 Bedienungsanleitung

Kicker Hi-Fi-Anlage 46HDBL69

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kicker 46HDBL69 (13 Seiten) in der Kategorie Hi-Fi-Anlage. Dieser Bedienungsanleitung war für 18 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/13
1. Remove the factory lids, latch, and hinge
assembly.
2. Install the factory latch and hinge assembly to
your new KICKER lids using the factory screws.
3. Install the speakers by rotating the speaker
from the back side of lid, through the opening of
the lid, positioning the speaker to line up with the
holes. Install the two front screws through the
speaker into the lid.
HDBL | HDBL69
HDBLVB | HDBLVB69
Motorcycle Lid Kit Installation Guide for Harley Davidson®
Motorcycles 2014–Present
Important: Over-tightening mounting fasteners may result in damage to your motorcycle. Please refer to your service manual for proper procedures and torque
specifi cations. KICKER is not responsible for damage resulting from improper installation techniques. This kit may not be compatible with some aftermarket
head units. KICKER cannot be held responsible for any damage to painted surfaces during removal or addition of KICKER parts.
4. Place the bracket on the back side of the speaker. Install a bolt through the bracket and speaker from the back side, then
position the speaker nut on top and tighten. Using the factory screw, attach the outside of the bracket to the lid.
5. install the factory latch lever using the factory screw and supplied rubber grommet.
6. Install the supplied grilles to the lids using the
supplied screws.
7. If have installed the KICKER Front Kit, locate the
4-pin connector under the seat of the motorcycle.
Connect the included wiring harness to the 4-pin
plug under the seat of the motorcycle. Connect
the portion of the harness that will connect the lid
speakers to the front amp, and route the left and
right 2-pin connectors to a location adjacent to the
bag attachment area of the motorcycle.
46HDBL-D-20200303
8. Drill a hole in each bag as pictured and install the supplied rubber gromets.
9. Using the included zip tie mounts and zip ties, route each wire as show in
the pictures below to secure the bag harness.
10. Install the lids to the bags.
11. Connect the speaker wires to the speaker (the terminals are sized for
the correct terminal), route the wire to the opposite side of the speaker and
secure it with a zip tie to the square hole in the tab at the base of the magnet
to ensure the wire does not get caught on any gear in the bag.
Note: If not already fl ashed for rear speakers, it will now be necessary to fl ash the motorcycle for 4-speaker set up using the
KICKER fl ash programmer of the Techno Research Centurion. Follow instructions for Flash Programmer to complete this task.
Set the gain to optimize sound quality and enjoy!


Produktspezifikationen

Marke: Kicker
Kategorie: Hi-Fi-Anlage
Modell: 46HDBL69

Brauchst du Hilfe?

Wenn Sie Hilfe mit Kicker 46HDBL69 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Hi-Fi-Anlage Kicker

Bedienungsanleitung Hi-Fi-Anlage

Neueste Bedienungsanleitung für -Kategorien-