Khyam Perpignan 6 Bedienungsanleitung

Khyam Zelt Perpignan 6

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Khyam Perpignan 6 (5 Seiten) in der Kategorie Zelt. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/5
1
ERECTION INSTRUCTIONS
FOR PERPIGNAN 6 & 8
BEFORE USE
PLEASE TAKE TIME TO READ AND UNDERSTAND THE ERECTION INSTRUCTIONS.
FAILURE TO ERECT THE TENT IN ACCORDANCE WITH THE INSTRUCTIONS MAY
RESULT IN DAMAGE TO BOTH FABRIC AND POLE SYSTEMS. SUCH DAMAGE
CANNOT BE COVERED BY THE WARRANTY.
WARNING!!
DO NOT PUSH TENT PEGS IN BY HAND, ALL TENT PEGS SHOULD BE DRIVEN HOME
USING A WOODEN OR RUBBER FACED MALLET OR SIMILAR TOOL.
TO ENSURE MAXIMUM POSSIBLE WATERPROOFING THE MAIN FLY SHEET SEAMS
HAVE BEEN TAPED. SHOULD THE TAPE BE DAMAGED AND PEEL AWAY YOU CAN
EFFECT A REPAIR BY USING SEAM SEALER AROUND THE PROBLEM AREA.
WE ALSO RECOMMEND THAT SEEM SEALER IS APPLIED TO UNTAPED SEEMS TO
PREVENT LEAKAGE.
IT IS IMPORTANT THAT YOU DO NOT ALLOW SEAM SEALER TO CONTAMINATE THE
TEETH OF ANY ZIPS AS THIS WILL PREVENT THE ZIP FROM FUNCTIONING CORRECTLY.
IF YOU DO USE SEAM SEALER IT IS BEST APPLIED WHEN THE TENT IS DRY. PICK A DRY
WARM DAY TO CARRY OUT ANY SEALING AND PLEASE ALLOW 48 HOURS FOR THE
SEALANT TO CURE PRIOR TO RE-PACKAGING THE TENT.
FAILURE TO ALLOW THE SEALANT TO DRY FULLY PRIOR TO PACKING THE TENT UP
WILL STICK THE FABRIC TOGETHER POSSIBLY CAUSING IRREPARABLE DAMAGE.
DURING USE
TENTS CONTAINING A HIGH PROPORTION OF SYNTHETIC MATERIALS ARE SOMETIMES
AFFECTED BY CONDENSATION, THIS SHOULD NOT BE CONFUSED WITH LEAKAGE AND
CAN USUALLY BE CURED BY ENSURING THAT ADEQUATE VENTILATION IS
AVAILABLE BY LEAVING DOORWAYS SLIGHTLY UNZIPPED WHEREVER POSSIBLE.
DO NOT PITCH UNDER TREES, MAKE USE OF NATURAL WIND BREAKS LIKE HEDGES
OR WALLS, FACE THE TENT DOOR AWAY FROM THE PREVAILING WIND. USE TWO
HANDS WHEN OPENING AND CLOSING ZIPS, THIS WILL HELP PREVENT PREMATURE
ZIP FAILURE.
READ AND UNDERSTAND THE FIRE PRECAUTIONS INFORMATION ATTACHED TO THE
INSIDE OF THE TENT.
CARE OF YOUR TENT WARNING!!
TENT FABRICS CAN BE WEAKENED BY PROLONGED EXPOSURE TO SUNLIGHT, UNDER
NORMAL HOLIDAY USE YOUR TENT WILL GIVE YOU LONG SERVICE BUT ERECTION
FOR EXTENDED PERIODS IN STRONG SUNLIGHT WILL CAUSE DETERIORATION.
IF YOU ARE LIKELY TO USE YOUR TENT FOR PROLONGED PERIODS IT WOULD BE WISE
TO USE A SITE WHICH IS AS SHADED AS POSSIBLE.
TENTS ARE BEST STORED OPENED OUT, IF THIS IS NOT POSSIBLE AIR FULLY AND
ENSURE IT IS TOTALLY DRY BEFORE PACKING IT AWAY AT THE END OF YOUR
HOLIDAY.
STORE YOUR TENT IN A WELL VENTILATED DRY PLACE. LOOK AFTER YOUR TENT
AND IT WILL LOOK AFTER YOU.
HAVE ANY DAMAGE TO YOUR TENT REPAIRED AT FIRST OPPORTUNITY.
2
FAILURES IN FIBERGLASS POLES NORMALLY OCCUR THROUGH INCORRECT USE,
MAKE SURE THE POLE SECTIONS ARE FULLY INSERTED INTO THEIR ADJOINING
FERULES AND DO NOT OVER STRESS THE POLE BEYOND IT’S DESIGNED CURVE. ZIPS
SHOULD BE TREATED WITH CARE TO PREVENT PREMATURE FAILURE AND THE TENT
SHOULD BE KEPT CLEAN AND DRY AFTER USE.
INSURANCE
WE HIGHLY RECOMMEND THAT YOUR TENT BE INSURED AGAINST THEFT AND STORM
OR ACCIDENTAL DAMAGE. STORM OR ACCIDENTAL DAMAGE IS NOT COVERED BY
THE WARRANTY.
CHECK YOUR EQUIPMENT BEFORE GOING AWAY WITH YOUR TENT. ENSURE THAT
YOU ARE FAMILIAR WITH THE PITCHING OF THE TENT AND THAT ALL PARTS ARE
PRESENT.
YOU SHOULD FAMILIARIZE YOURSELF WITH THE TENT, INCLUDING ANY
LIMITATIONS THAT IT MAY HAVE FOR YOUR PARTICULAR USE.
DOME TENTS ARE PORTABLE STRUCTURES WHICH UNDER MOST CIRCUMSTANCES
WILL PROVIDE COMFORTABLE SHELTER AGAINST THE ELEMENTS. THERE ARE
HOWEVER EXTREMES OF WEATHER FOR WHICH ALLOWANCES SHOULD BE MADE.
DO NOT BLAME THE TENT !
ERECTING YOUR TENT
……PLEASE NOTE THIS IS A VERY LARGE FAMILY TUNNEL AND WE STRONGLY
RECOMMEND IT IS ERECTED BY A MINIMUM OF TWO ADULTS.
1: REMOVE THE CONTENTS OF THE CARRY BAGS AND IDENTIFY ALL THE COMPONENT
PARTS.
• INNER TENTS
• FLYSHEET WITH SEWN IN GROUNDSHEET.
• POLE BAG AND CONTENTS
• PEG BAG AND CONTENTS
2: SELECT A SITE THAT IS CLEAR OF ANY SHARP OBJECTS, STICKS AND STONES E.T.C
3: IN THE POLE BAG, SHOULD BE :-
5 X LONG PRECURVED STEEL ROOF POLES. PLEASE NOTE THE PRECURVED ROOF
POLES HAVE SPECIALLY SHAPED JOINTS TO ENSURE THEY ARE CONNECTED
TOGETHER CORRECTLY. WHEN ASSEMBLED THE ROOF POLE SHOULD FORM A GENTLE
CURVE. DO NOT FORCE THE JOINTS TOGETHER IF THEY ARE TIGHT. CHECK THAT THE
TWO JOINT SECTIONS ARE THE CORRECT WAY AROUND AND RETRY.
10 X METAL LONG POLE UPRIGHTS ( CONSISTING OF 3 SECTIONS EACH) ONCE
ASSEMBLED EACH MAIN UPRIGHT POLE WILL HAVE AN ANGLE SECTION AT THE TOP
AND A PLASTIC BUNG INSERT AT THE BASE WITH A SMALL HOLE IN THE BUNG FOR
THE RING AND PIN ON THE FLYSHEET.
A SET OF UPRIGHT CANOPY POLES, EACH CONSITING OF 3 POLE SECTIONS LINKED BY
POLES SPRINGS.
ALL POLES WITH THE EXCEPTION OF THE CANOPY POLES, WILL BE MARKED WITH A
COLOURED STICKER. THIS WILL CORRESPOND TO A COLOURED TRIM ON THE EDGE OF
THE SLEEVE THAT THE POLE IS INTENDED TO FIT THROUGH. IT IS BEST TO START AT
ONE END OF THE FLYSHEET AND WORK TOWARDS THE OPPOSITE END OF THE TENT,
SO IT MAY BE USEFUL TO INDENTIFY POLE AND SLEEVE COLOURS AND POSITION THE
POLES ALONG SIDE THE TENT IN THE CORRECT ORDER.
3
4: UNFOLD THE FLYSHEET WITH SEWN IN GROUNDSHEET AND SPREAD OUT ON THE
FLOOR SO YOU ARE ABLE TO SEE THE FIVE SLEEVE SECTIONS OF THE ROOF. LOCATE
A DOOR SECTION ON EACH SIDE AND OPEN THE ZIPS FULLY. THIS WILL ALLOW AIR
TO FLOW INTO THE TENT LATER WHEN YOU ARE ERECTING IT MAKING THIS PROCESS
EASIER.
5/ LOCATE ONE OF THE PRECURVED STEEL ROOF POLES, CHECK THE COLOUR CODING
AND THAT YOU ARE INSERTING IT INTO THE CORRECT POLE SLEEVE.
STARTING AT ONE END OF THE TENT THREAD THE POLES THROUGH THE FIRST
SLEEVE SECTION RUNNING ACROSS THE ROOF OF YOUR TENT ON THIS END.
ENSURE CARE IS TAKEN DURING THIS PROCEDURE, NOT TO ALLOW THE ENDS OF THE
SHOCKCORDED POLES TO DAMAGE SLEEVES OR FLYSHEET MATERIAL.
TAKE ONE OF THE ASSEMBLED METAL MAIN POLE UPRIGHTS AND CHOOSING ONE
SIDE OF THE ROOF POLE ENGAGE THE FERRELLED END INTO THE OPEN END OF THE
METAL ANGLE BRACKET ON THAT SIDE.
THE BASE OF THE UPRIGHT POLE THEN ENGAGES ONTO THE RING AND PIN FIXTURE.
THIS WILL BE LOCATED AT THE BASE OF THE FLYSHEET,NEAR TO THE SEAM
RUNNING DOWN FROM THE SLEEVE IN WHICH THE POLE IS LOCATED. EACH POLE
RETAINING FIXTURE WILL HAVE A METAL RING WITH ONE OR MORE RETAINING PINS
ATTACHED TO IT ( DEPENDANT UPON MODEL ). THE RETAINING PIN IS DESIGNED TO
SLIDE UP INSIDE THE PLASTIC POLE END BUNG THUS SECURING THE POLE INTO
PLACE.
PLEASE ENSURE THAT THE ROOF SLEEVE IS NOT TRAPPED OR CAUGHT OVER THE
UPPER END OF THE METAL ANGLED POLE. THE UPPER END OF THE METAL ANGLED
POLE SHOULD BE INSERTED FULLY INTO THE ROOF POLE SLEEVE BEFORE
ATTEMPTING TO LOCATE THE LOWER END ONTO THE RING AND PIN.
PLEASE NOTE THAT THE ADJUSTABLE WEBBING STRAPS ATTACHED TO THE RING AND PIN
SHOULD BE SLACKENED OFF BEFORE INSERTING THE PIN INTO THE POLE. AFTER
LOCATING THE PIN, ADJUST THE STRAP WITHOUT OVER TIGHTENING. AGAIN ENSURE THE
ROOF POLE SLEEVE IS NOT CAUGHT OVER THE METAL POLE END BEFORE TIGHTENING
THE ADJUSTABLE STRAP..
RUNNING DOWN THE SEAM, FROM THE SLEEVE, ON EACH SIDE OF THE TENT YOU
WILL NOTICE THREE FLYSHEET TO MAIN POLE WEBBING CLIPS. ALL THESE, SHOULD
SIMPLY BE CLIPPED TO THE METAL MAIN POLES ALLOWING THE FLYSHEET TO TAKE
FULL SHAPE. PLEASE NOTE THAT THESE ARE NOT INTENDED AS GUY POINT FIXINGS
AT THIS POINT YOU CAN LOOSELY BUT SECURELY PEG THE FRONT AND BACK
CENTRAL AND SIDE END GUY POINTS. THIS WILL SUPPORT THE ONE SECTION YOU
HAVE ASSEMBLED IN AN UPRIGHT FASHION. THIS WILL MAKE THE FITTING OF THE
REMAINING 4 POLES A LOT EASIER. PLEASE ENSURE THERE IS ENOUGH SLACK IN THE
GUY ROPES TO ALLOW YOU TO FIT THE REMAINING POLES. PLEASE CHECK THE
TENSION IN THE FRONT AND REAR GUY ROPES ON REGULAR OCCASIONS DURING
FITTING THE REMAINING ROOF AND UPRIGHT POLES.
6: TAKING THE REMAINING METAL MAIN POLE UPRIGHTS AND THE SECOND, THIRD
FORTH AND FIFTH ROOF POLES SEPARATELY REPEAT POINT 5 FOR EACH SET. IT IS
BEST TO START AT ONE END OF THE FLYSHEET AND WORK TOWARDS THE OPPOSITE
END OF THE TENT. CHECK THE TENSION OF THE FRONT AND REAR GUY POINTS AS
THESE MAY NEED TO BE ADJUSTED AS YOU FIT AND POSITION EACH OF THE MAIN
POLES.


Produktspezifikationen

Marke: Khyam
Kategorie: Zelt
Modell: Perpignan 6

Brauchst du Hilfe?

Wenn Sie Hilfe mit Khyam Perpignan 6 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Zelt Khyam

Bedienungsanleitung Zelt

Neueste Bedienungsanleitung für -Kategorien-