Kelvinator KI130CF2 Bedienungsanleitung

Kelvinator Gefrierschrank KI130CF2

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kelvinator KI130CF2 (8 Seiten) in der Kategorie Gefrierschrank. Dieser Bedienungsanleitung war für 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/8
Instruction Manual
Chest Freezer
MODEL: KI130CF2
INSTALLATION INSTRUCTIONS
Before Using Your Freezer
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
Storage Basket
Divider
Instruction Manual
Plastic Scraper
Before connecting the freezer to the power source, let it stand upright for approximately 2 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Freezer
This appliance is designed to be free standing only, and should not be recessed or built-in.
Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.
Allow 15 cm of space between the back and sides of the freezer, which allows the proper air circulation.
Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the freezer not to perform properly.
Avoid locating the freezer in moist areas.
Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before placing
food in the freezer compartment.
OPERATING YOUR FREEZER
Temperature Control
Your freezer has one control for regulating the temperature. The temperature control is located on the
lower right hand corner.
The first time you turn the unit on, switch on the Fast Freeze switch and run for at least 2 hours before
putting frozen foods inside. This will ensure the cabinet is thoroughly chilled before food is put in.
rn off the Fast Freeze switch. Tu
The range of the temperature control is from position" 1" the warmest to "6" the coldest. Adjust the
temperature control to the setting that best suits your needs. The setting of “4” should be appropriate for
home or office freezer use.
To turn the freezer off, turn the temperature control to "OFF".
NOTE:
Turning the temperature control to "OFF " position stops the cooling cycle but does not shut off the
power to the freezer.
If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before restarting the unit.
If you attempt to restart before this time delay, the freezer will not start.
Large amounts of food will lower the cooling efficiency of the appliance.
If you choose to change the thermostat setting, adjust thermostat control by one numerical increment at
a time. Allow several hours for temperature to stabilize between adjustments.
The Fast Freeze Switch
The light glows while the Fast Freeze switch is in the „ON‟ position.
The switch overrides the thermostat and will make the compressor operate continuously, lowering the
cabinet temperature still further than the thermostat setting.
This switch is used to freeze unfrozen food in appreciable quantities.
When loading the freezer, freeze only three pounds of fresh food per cubic feet of freezer space at one
time.
Distribute packages to be frozen evenly throughout the freezer.
It is not necessary to adjust the thermostat setting when using the Fast Freeze switch.
Defrosting Your Freezer
When? For the most efficient operation and minimum energy consumption, defrost the freezer when
the frost on the freezer walls is excessive or 5 to 10 mm thick.
Choose a time when the stock of frozen food is low.
CAUTION
Do not use boiling water because it may damage the plastic parts. In addition, never use a sharp or
metallic instrument to remove frost as it may damage the cooling coils and will void the warranty.
We recommend using the plastic scraper provided with your unit.
Remove the frozen food from the freezer and place it in a cooler to protect the food.
Turn the thermostat knob to “OFF”.
Unplug the freezer. The Power Supply light should be off (green light out).
During defrosting, the ice melts into the cabinet.
Remove the drain plug on the inside floor of the freezer by pulling straight out.
Place a shallow pan outside drain outlet. The defrost water will drain out.
Check the pan occasionally so the water does not overflow.
Clean the interior of the freezer.
Replace the plug on the inside floor.
Reset the thermostat to desired setting.
Allow the cabinet to cool for one hour.
Switch on the Fast Freeze for a minimum of 2 hours.
Return food to the freezer.
HELPFUL HINT:
Defrosting usually takes a few hours. Leaving the door open will help speed the process. Also,
pouring warm water (not boiling) on the ice/frost will help speed melting. If you must use a scraper-
please use caution - it is very easy to damage the freezer compartment and void your warranty.
The Freezer Compartment
This compartment is designed for the long-term storage of frozen food. Storage time is up to three
months.
The storage life of frozen foods varies and the recommended storage time should not be exceeded.
The instructions regarding the care of frozen foods should be followed when defrosting the freezer.
Pre-packed commercially frozen food should be stored in accordance with the frozen foods
manufacturer‟s instructions for a three star frozen food storage compartment or home freezer.
Place frozen food into the freezer as quickly as possible after purchase. If there are instructions on the
packet, carefully follow these instructions regarding storage times.
The freezer door is susceptible to breaking due to excessive ice build up. Be sure to defrost when the
ice reaches 5 to 10 mm thick.

Produktspezifikationen

Marke: Kelvinator
Kategorie: Gefrierschrank
Modell: KI130CF2

Brauchst du Hilfe?

Wenn Sie Hilfe mit Kelvinator KI130CF2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Gefrierschrank Kelvinator

Kelvinator

Kelvinator MUFF17VLQW Bedienungsanleitung

30 August 2024
Kelvinator

Kelvinator CO KUF 251 Bedienungsanleitung

30 August 2024
Kelvinator

Kelvinator MUFD19V9QS Bedienungsanleitung

30 August 2024
Kelvinator

Kelvinator KTB2802WB Bedienungsanleitung

30 August 2024
Kelvinator

Kelvinator K310CF Bedienungsanleitung

30 August 2024
Kelvinator

Kelvinator CP KW 030 V Bedienungsanleitung

30 August 2024
Kelvinator

Kelvinator CO KVI 28 B Bedienungsanleitung

30 August 2024
Kelvinator

Kelvinator MUFF21VLRT Bedienungsanleitung

30 August 2024
Kelvinator

Kelvinator KI130CF2 Bedienungsanleitung

30 August 2024
Kelvinator

Kelvinator KI305UF Bedienungsanleitung

30 August 2024

Bedienungsanleitung Gefrierschrank

Neueste Bedienungsanleitung für -Kategorien-

Freggia

Freggia LUF246W Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia LUF193X Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia LUF193W Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia LUF246X Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia LC21 Bedienungsanleitung

16 Oktober 2024
Royal Catering

Royal Catering RCFZ-459-1 Bedienungsanleitung

15 Oktober 2024
Hisense

Hisense HRCF501 Bedienungsanleitung

15 Oktober 2024
Royal Catering

Royal Catering RCGK-BC96 Bedienungsanleitung

15 Oktober 2024
Royal Catering

Royal Catering RCFZ-W88L Bedienungsanleitung

15 Oktober 2024
Royal Catering

Royal Catering RCGK-BC30 Bedienungsanleitung

15 Oktober 2024