Jensen J12W Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Jensen J12W (10 Seiten) in der Kategorie Subwoofer. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/10
J12W
OWNER’S MANUAL
WATTS
1200
12-inch SUBWOOFER
J12W
2
Before you get started
Thank you for purchasing the J12W 12" subwoofer. Although
JENSEN has attempted to make sure all of the information
contained within this manual is accurate, please be aware that any
part of it is subject to change without notice.
The following instructions should be used a general
guideline only. If you are unsure about performing
any of the procedures listed below, please consult a
professional car audio installation center.
Before installation, please follow these guidelines:
1. Be sure to carefully read and understand the instructions before
attempting to install this product.
2. For safety, disconnect the negative terminal from the battery
prior to beginning the installation.
3. Use the highest quality connectors for a reliable installation and
to minimize signal or power loss.
4. Use caution before you drill or cut! Be careful not to cut or drill
into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines
or electrical wiring when working on any vehicle.
5. Never run speaker wires underneath your vehicle. Running
speaker wires inside the vehicle provides the best protection
from exhaust heat and environmental elements.
6. Avoid running wires over, near, or through sharp edged surfaces.
Use rubber grommets to protect any wires routed through metal.
7. When running the speaker cable from the amplifier, avoid
running it near sources of high current (i.e. wiring harnesses,
battery cables).
3
J12W
Installation Guidelines
To achieve the best possible sound from this subwoofer enclosure,
Dual recommends acquiring the services of a professional car
audio installation center.
If you feel confident in your ability to install this product
without the assistance of a professional, please read this
section thoroughly. We have provided a number of placement
recommendations and installation tips to assist you. Keep in mind
these are provided as a guideline and you may find that other
placements specific to your vehicle may provide better results.
• Make sure all moving parts and factory electrical wires are out of
the way and will no interfere after installation.
• Ensure the wire is of sufficient length to avoid pulling or
stretching. This is even more important if the wires will be run
under or through the factory interior.
• Use electrical tape and wire ties to ensure all wires are properly
secured.
• Avoid installing speakers or electronics where they can be
subject to moisture.
• Ensure the speaker wires are connected using correct polarity.
The positive polarity is marked by a (+) sign. Incorrectly connected
subwoofers will result in limited bass output.
• Speaker wire should be isolated from the vehicle’s electrical
system to avoid noise being picked up by the amplifiers.
• We recommend using 14 gauge or larger sized speaker wire
to ensure your subwoofer receives the full power output of your
amplifier.
• Remember to listen responsibly and respect your ears. Being
exposed to sounds over 125dB for even short periods of time can
create permanent hearing loss!


Produktspezifikationen

Marke: Jensen
Kategorie: Subwoofer
Modell: J12W

Brauchst du Hilfe?

Wenn Sie Hilfe mit Jensen J12W benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Subwoofer Jensen

Bedienungsanleitung Subwoofer

Neueste Bedienungsanleitung für -Kategorien-