Induro GHB2C Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Induro GHB2C (1 Seiten) in der Kategorie Stativ. Dieser Bedienungsanleitung war für 23 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/1
GH-SERIES GIMBAL HEAD
OPERATING INSTRUCTIONS
Thank you for making Induro your choice for
professional photographic gear. Your Induro gear
is manufactured to provide years of dependable
service. In order to obtain optimum satisfaction
and performance we suggest that you carefully
read these instructions and provide them to
anyone who may also use your Induro gear.
OPERATION (FIGURE 4)
The GH-Series Gimbal Heads are
professional devices and once adjusted for
typical operation only require two controls.
Slightly loosen both the Tilt Knob and Pan
Knob. Then aim the camera at the subject
and tighten both Knobs to lock.
If you’re photographing and following action,
you may keep both Knobs loose and take
advantage of the stability offered by the
Gimbal Head. Lock the Knobs when you
are finished or are not firmly holding the
Camera/Lens.
FOR OPTIMUM RESULTS: Adjust the balance
and Camera/Lens positioning with the weight
capacity, temperature and conditions under
which the Gimbal Head will be used.
NOTE: Do not over tighten any Locking
Knobs or try to move the Camera/Lens once
tightened as this could damage the Gimbal
Head locking mechanism.
USER NOTICE
cDo not exceed the maximum specified load
capacity (see specifications on the package
label or visit www.Induro.com).
cAlways ensure that all Ballhead locks are
tightly engaged before mounting any gear.
cDo not use any Ballhead below
temperatures of −4°F or above +158°F
(−20°C / +70°C).
cAlways clean and dry any Ballhead after
it has been exposed to wet, dusty, sandy
or salty conditions. Your Ballhead is not
recommended for use in salt water. If
required, clean Ballhead using a mild soap
solution applied with a soft cloth, rinse
with fresh water and dry with soft towel.
Remove any dust, dirt or sand from all
locks and all moving parts.
cDo not leave any Ballhead in the sun
for prolonged periods and avoid high
temperature exposure.
cAvoid leaving any Tripod or Monopod
unattended in areas where people could
trip over the gear and get hurt.
cRemove camera, lens, and all gear from
any Tripod or Monopod when transporting.
cFor your safety, don’t let your Induro
gear come in contact with any electrical
power source.
Specifications and design are subject to change without notice.
All tradenames, logos, and brand references are the respective trademarks of their owners.
INDURO Camera Support Gear | 75 Virginia Road, North White Plains, NY 10603 | T 914-347-3300 | F 914-347-3309 | info@indurogear.com | indurogear.com
Produktspezifikationen
| Marke: | Induro |
| Kategorie: | Stativ |
| Modell: | GHB2C |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Induro GHB2C benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Stativ Induro
15 Mai 2023
15 Mai 2023
15 Mai 2023
Bedienungsanleitung Stativ
- Stativ Hama
- Stativ Sony
- Stativ Panasonic
- Stativ Laserliner
- Stativ Bresser
- Stativ Ryobi
- Stativ Garmin
- Stativ DJI
- Stativ Rollei
- Stativ Davis
- Stativ Joby
- Stativ Manfrotto
- Stativ Sachtler
- Stativ Zhiyun
- Stativ 3 Legged Thing
- Stativ Proaim
- Stativ Gitzo
- Stativ Miller
- Stativ Magnus
- Stativ Konig & Meyer
- Stativ Benro
- Stativ Slik
- Stativ Oben
- Stativ Vinten
- Stativ Gravity
- Stativ Block & Block
- Stativ Barska
- Stativ Ultimate Support
- Stativ FeiYu-Tech
- Stativ Sirui
- Stativ FeiyuTech
- Stativ On Air
- Stativ Moza
Neueste Bedienungsanleitung für -Kategorien-
17 April 2024
12 April 2024
7 April 2024
4 April 2024
3 April 2024
1 April 2024
24 März 2024
19 März 2024
16 März 2024
16 März 2024