IHome Timebase II iBTW22B Bedienungsanleitung

IHome Radio Timebase II iBTW22B

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für IHome Timebase II iBTW22B (2 Seiten) in der Kategorie Radio. Dieser Bedienungsanleitung war für 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
Model: iBTW22
BLUETOOTH PAIRING
USB
CHARGING
PORT
- When connected to a BT device,
press to make voice commands
DISPLAY ICONS
- Press to answer a call
- Press & hold to end/reject a call
iBTW22IS-042321-A
Printed in China
© 2021 SDI Technologies, Inc.
All rights reserved
For questions, warranty, and additional safety information, please
scan the QR code or visit:
www.ihome.com/help/ibtw22
TIMEBASE
Wireless Charging + Speaker
- Press & hold to enter Bluetooth
pairing mode
- Select ‘iHome TimeBase’ on
your device to connect
- To cancel pairing, press
Bluetooth button again
WARNING
Do not ingest the battery, Chemical Burn Hazard. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can
cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from
children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
The mains plug of power adaptor is used as the disconnect device, it shall remain readily operable.
CAUTION - RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE
INSTRUCTIONS.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions and keep these instructions handy for future reference.
1. Do not use this product near water.
2. Unplug unit and clean only with damp cloth. Stronger cleaning agents, such as Benzene, thinner or similar materials can
damage the surface of the unit.
3. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
4. Heat – This product should be situated away from heat sources such as radiators, heat registers, stoves or other appliances
(including amplifiers) that produce heat.
5. Only use attachments/accessories specified by the manufacturer.
6. Unplug this product during lightning storms or when unused for long periods of time.
7. Damage Requiring Service – This product should be serviced by qualified service personnel when:
- Plug has been damaged.
- Objects have fallen into or liquid has been spilled into the enclosure.
- The unit has been exposed to rain. The unit has been dropped or the enclosure damaged.
- The unit exhibits a marked change in performance or does not operate normally.
8. No naked flame sources, such as lighted candles, should be placed on this product.
9. Attention should be drawn to the environmental aspects of battery disposal. Many electronics retailers now recycle
batteries and other electronic components at no charge. To find a drop-o location near you, visit www.call2recycle.com
10. This product is suitable for use in tropical and/or moderate climates.
WARNING:
- To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
- Do not dispose of batteries in the household trash or fire.
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
ISED Information
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
The device comply with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
L'appareil est conforme aux exigences d'exposition RF ISED, les utilisateurs peuvent obtenir des informations canadiennes sur l'exposition
aux RF et la conformité.
Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
Tout changement ou modification non expressément approuvé par la partie responsable de la conformité peut annuler l'autorité de
l'utilisateur à utiliser l'équipement.
CAN ICES-3 (B) / NMB-3(B), CAN RSS-216 / CNR-216
WIRELESS CHARGING
Supports:
Qi compatible phones (also works with plastic cases up to 3mm thick*)
Apple Air Pods
Place Qi compatible device facing upward on the charging rest. Charging status will be
indicated on the LED located under the iHome badge:
Note: Qi status LED may continue to blink slowly (indicating charging) for iOS devices that are fully charged.
CAUTION: Not all cases are wireless charging compatible. Remove phone’s metal protective case before
charging. Do not place magnetic or metal objects on charger during charging.
* Some larger size phone cases may not be able to charge. Please remove case to charge phone properly.)
SPEAKERPHONE
PLAY/PAUSE
-Press to play/pause audio
ALARM
- Press to Preview
- Press Again to Arm/Disarm
- Press & Hold to Set Alarm
(adjust with +/- and press
alarm to confirm)
TIME SET
Press & Hold to Set Time
Release Time Set Button
when display is flashing
Adjust time using /+ - and
press Time Set to confirm
Repeat Step 3 to set year,
month, and date
1.
2.
3.
4.
WIRELESS CHARGING PAD
SET
- Press to decrease settings
SET
- Press to increase settings
POWER
- Press to turn ON/OFF
SNOOZE/DIMMER
- Press to snooze an alarm
- Press to adjust display brightness
AUTO DIMMING SENSOR
DC JACK
(for power supply)
BOTTOM PANEL
REAR PANEL
DST SWITCH
BACKUP BATTERY COMPARTMENT
By default, the DST Switch is set to Auto and will
automatically adjust the time in March/November
*Remove battery pull tab before use!
Wireless Charging Status
Bluetooth Status
PM Indicator
Alarm Indicator
Low Battery Indicator
for clock accuracy and alarm setting backup
When Low Backup Battery icon appears on the
display, install a new CR2450 battery
time set 5W USB-ADC 9V 3Abluetooth
Device is not charging (reposition device)
Device is charging
Device is fully charged
Rapid blinking icon:
Slow blinking icon:
Solid icon:


Produktspezifikationen

Marke: IHome
Kategorie: Radio
Modell: Timebase II iBTW22B

Brauchst du Hilfe?

Wenn Sie Hilfe mit IHome Timebase II iBTW22B benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Radio IHome

Bedienungsanleitung Radio

Neueste Bedienungsanleitung für -Kategorien-