Ignis AWV 810 Bedienungsanleitung

Ignis Waschmaschine AWV 810

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Ignis AWV 810 (17 Seiten) in der Kategorie Waschmaschine. Dieser Bedienungsanleitung war fĂĽr 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/17
CONTENTS
BEFORE USING THE WASHING MACHINE
FIRST WASH CYCLE
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
DESCRIPTION OF THE WASHING MACHINE
PREPARATION OF THE WASHING
DETERGENTS AND ADDITIVES
PROGRAMME SELECTION
CLEANING THE FOREIGN BODY TRAP
DRAINING RESIDUAL WATER
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
TRANSPORT AND HANDLING
INSTALLATION
ELECTRICAL CONNECTION
IFU_Alpha_Sc1-mech_GB.fm Page 1 Wednesday, March 30, 2005 6:52 PM
Black process 45.0° 100.0 LPI
GB 2
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check
a.Cut and remove the shrink-wrap.
b.Remove the top protection and the protective
corners.
c. Remove the bottom protection by tilting and
turning the washing machine on one rear bottom
corner.
d.Open the lid by pressing it slightly down while raising
the handle. Remove the polystyrene cushion.
e.Remove the blue protective film from the panel
(depending on model).
•After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use the
washing machine. Contact After-Sales Service or
your local retailer.
•Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children;
they are potentially dangerous.
2.Remove the transport bracket
•The washing machine is fitted with transport
screws and a transport bracket to prevent
damage during transport. Before using the
washing machine you must remove the
transport bracket (see “Installation/Remove
the transport bracket”).
3.Install the washing machine
•Place the washing machine on a flat and stable
floor surface.
• Adjust the feet to ensure that the machine
is stable and level (see “Installation/Adjust
the feet”).
4.Water supply
•Connect the water supply inlet hose in
accordance with the regulations of your local
water company (see “Installation/Connect the
water inlet hose”).
•Water supply: Cold water only
•Tap: 3/4” threaded hose connection
•Pressure: 100-1000 kPa (1-10 bar).
5.Drain hose
•Connect the drain hose to the siphon or hook it
over the edge of a sink with the “U” bend (see
“Installation/Connect the water drain hose”).
•If the washing machine is connected to a built-in
drainage system, ensure the latter is equipped
with a vent to avoid simultaneous loading and
draining of water (siphoning effect).
6.Electrical connection
•Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and the current
standard safety regulations.
•The technical data (voltage, power and fuses) are
given on the rating plate on the rear of the
washing machine.
•The washing machine must be connected
exclusively by means of a socket with an earth
connection in accordance with current
regulations. The washing machine must be
earthed by law. The manufacturer declines all
liability for damage to persons or property
deriving directly or indirectly from failure to
observe the directions.
•Do not use extension leads or multi sockets.
•Before any maintenance on the washing machine
disconnect it from the mains supply.
•Access to the mains plug or to disconnection
from the mains supply via a double-pole switch
must be ensured at all times following the
installation.
•Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service.
•Mains cable replacement is only to be carried out
by After-Sales Service.
•The washing machine must be connected to an
effective earthing installation, in compliance with
the regulations in force. In particular, washing
machines installed in premises containing a
shower or a bath must be protected by a
differential residual current device of at least 30
mA. Earthing the washing machine is obligatory
under the law. The manufacturer declines all
liability for damage to persons or property
deriving either directly or indirectly from failure
to observe the directions above.
•The washing machine may only be used in the
household for the prescribed uses.
Dimensions:
Width: 400 mm
Height: 900 mm
Depth: 600 mm
IFU_Alpha_Sc1-mech_GB.fm Page 2 Wednesday, March 30, 2005 6:52 PM
Black process 45.0° 100.0 LPI
GB 3
FIRST WASH CYCLE
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
1.Packing
•The packaging materials are 100% recyclable and
bear the recycling symbol . Adhere to local
regulations when disposing of packaging material.
2.Energy saving tips
•Achieve the best use of energy, water, detergent
and time by using the recommended maximum
load size.
•Do not exceed the detergent dosages indicated
in the manufacturer’s instructions.
•The Eco Ball - a special system in the outlet - will
prevent detergent loss from the drum to avoid
detergent loss into the environment.
•Use “Prewash” for heavily soiled laundry only!
Save detergent, time, water and energy
consumption by not selecting “Prewash” for
slight to normally soiled laundry.
•Pretreat stains with stain remover or soak dried
in stains in water before washing to reduce the
necessity of a hot wash program.
•Save energy by using a 60°C instead of a 90°C
wash programme or a 40°C instead of a 60°C
wash programme.
•Save energy and time by selecting a high spin
speed to reduce the water content in laundry
before using a tumble dryer (for machines with
adjustable spin speed).
3.Disposing of packaging and old washing
machines
•This appliance is marked according to the
European directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the
documents accompanying the product, indicates
that this appliance may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the recycling
of electrical and electronic equipment.
Disposal must be carried out in accordance with
local environmental regulations for waste disposal.
For more detailed information about treatment,
recovery and recycling of this product, please
contact your local city office, your household
waste disposal service or the shop where you
purchased the product.
•The washing machine is built from reusable
materials. It must be disposed of in compliance
with current local waste disposal regulations.
•Before scrapping, cut off the power cable so that
the washing machine cannot be connected to the
mains.
•Remove detergent from compartment if you
intend scrapping your washing machine.
4.Child safety
•Children must not be allowed to play with or in
the washing machine.
5.General recommendations
•Do not leave the washing machine connected
when not in use. Turn off the tap.
•Before cleaning or carrying out maintenance
switch off the washing machine and disconnect it
from the mains supply.
•To clean the outside of the washing machine, use
a neutral detergent and a damp cloth.
•Do not use abrasive detergents.
•Do not attempt to force the lid open.
•If necessary, the power cable may be replaced
with an identical one obtained from our After-
Sales Service. The power cable must only be
replaced by a qualified technician.
6.EC Declaration of Conformity
•This washing machine has been designed,
constructed and distributed in compliance with
the safety requirements of EC Directives:
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking Directive
We recommend that the first wash cycle be carried out empty. This will remove any residual water used
in the factory checks.
1.Turn on the tap.
2.Close the drum flaps.
3.Pour a small amount of detergent (about 30 ml) into the detergent dispenser .
4.Select a short programme (see programme chart).
5.Switch on the machine by pressing the “On/Off” button.
IFU_Alpha_Sc1-mech_GB.fm Page 3 Wednesday, March 30, 2005 6:52 PM
Black process 45.0° 100.0 LPI

Produktspezifikationen

Marke: Ignis
Kategorie: Waschmaschine
Modell: AWV 810

Brauchst du Hilfe?

Wenn Sie Hilfe mit Ignis AWV 810 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Waschmaschine Ignis

Ignis

Ignis AWV 421/1 Bedienungsanleitung

23 September 2024
Ignis

Ignis AWV 508 Bedienungsanleitung

17 September 2024
Ignis

Ignis AWP 092 Bedienungsanleitung

6 August 2024
Ignis

Ignis AWP 096 Bedienungsanleitung

5 August 2024
Ignis

Ignis LTA 70 Bedienungsanleitung

3 August 2024
Ignis

Ignis AWV 465 Bedienungsanleitung

2 August 2024
Ignis

Ignis AWV 810 Bedienungsanleitung

31 Juli 2024
Ignis

Ignis AWV 465/IG Bedienungsanleitung

26 Juli 2024
Ignis

Ignis AWV 9526 Bedienungsanleitung

22 Juli 2024
Ignis

Ignis LO A60 Bedienungsanleitung

22 Juli 2024

Bedienungsanleitung Waschmaschine

Neueste Bedienungsanleitung fĂĽr -Kategorien-

Candy

Candy CS 15102D3-80 Bedienungsanleitung

16 Oktober 2024
GE

GE GSD3715FAA Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia WTIE148 Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia WISE126R Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia WISE126B Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia WISE126 Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia WISA105 Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia WISA106 Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia WIA107 Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia WDIE14106 Bedienungsanleitung

16 Oktober 2024