IFi Audio micro iPhono2 Bedienungsanleitung

IFi Audio Hi-Fi-Anlage micro iPhono2

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für IFi Audio micro iPhono2 (15 Seiten) in der Kategorie Hi-Fi-Anlage. Dieser Bedienungsanleitung war für 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/15
Set-Up Guide
iFi iPhono 2 Quick Cartridge Setup Guide–
Step 1: Select and Connect MM/MC Input.
The cartridge manual will tell you the output voltage of the cartridge.
Eg The output voltage of a the MC cartridge Denon DL- 103R is 0.25mV;
The output voltage of a the MM cartridge Shure M97xE is 4mV.
Thus the Shure M97xE (4mV) should be connected to the MM input of the iPhono; the
Denon DL 103R (0.25mV) should be connected to the MC input of the iPhono.-
Note: MM MC and inputs should not be connected simultaneously.
Tip: For a High Output MC cartridge like the Ortofon -3 MC Turbo, its output is 3.3mV
,
so it should be
connected to the MM input of the iPhono. The actual output voltage determinates which input should
be used.
Tip: Remember to connect the ground wire from the turntable to the iPhono2 I. f
required, use the small extension lead included for ease of connection.
Step 2: Select and Set Gain.
Most - phono pre amplifiers have gain adjustment levels. Different cartridges require
different gain s. MM cartridges require lower gain and MC cartridge require higher gain. level
Normally gain is expressed in decibel (dB); dB means times gain. 36 63
The iPhono 2 allows gain s from 36dB (63 times) to 72dB (4,000 times) to be set level
allowing for Cartridges with rated outputs from <= 0.1mV to >= 10mV eaning your choice . M
of cartridge is completely free and not limited by the iPhono 2.
C artridge Output
Gain Required
Input & Switch Settings
> 4.8mV
36dB
MM
1 – .2 mV 4.8 mV
48 dB
MM & +12dB
0.3 .2 - 1 mV
60dB
MC
< 0.3 mV
72dB
MC & +12dB
Cartridge output
iPhono 2 input connection
< 1 .2 mV
MC
≥ 1 .2 mV
MM
1
Set-Up Guide
From the the previous table, Shure M97xE 40dB 103R should should use gain, and Denon DL-
use 66dB gain. As long as the right connection (MM/MC) is made as per Step 1: Connect ‘
MM/MC Input,’ there is no need to distinguish MM/MC cartridge anymore for the following
steps.
Steps to set gain
(i) Please look at the output voltage of the cartridge;
(ii) Connect the cable from the turntable to the correct input (Step 1)
(iii) Determinate the gain required (dB) from the table overleaf;
(iv) S et the micro switches exactly as follows, ignore the grayed out switches for
now.
Tip: If you are not sure which gain to set as your cartridge output is near the borderlevel line of
recommendations, first choose the lower gain. Increase gain if you cannot get satisfactory volume
levels at your desired volume control setting on your Amplifier/Preamplifier.
MM - 36dB Gain
2
Set-Up Guide
MM - 48 dB Gain
MC - 6 0dB Gain
3


Produktspezifikationen

Marke: IFi Audio
Kategorie: Hi-Fi-Anlage
Modell: micro iPhono2

Brauchst du Hilfe?

Wenn Sie Hilfe mit IFi Audio micro iPhono2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Hi-Fi-Anlage IFi Audio

Bedienungsanleitung Hi-Fi-Anlage

Neueste Bedienungsanleitung für -Kategorien-