HQ HA30W Bedienungsanleitung

HQ Empfänger HA30W

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für HQ HA30W (60 Seiten) in der Kategorie Empfänger. Dieser Bedienungsanleitung war für 13 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/60

PUBLIC ADDRESS

AMPLIFIER

Installation and User Instructions

For models:

• HQ-HA30W

WARNING:THIS APPLIANCE MUST BE EARTHED

RISK OF ELECTRIC SHOCK

DO NOT OPEN

IMPORTANT

The wires in the mains lead are coloured

in accordance with the following code:

GENERAL INSTALLATION

DO NOT run microphone cables near mains, data, telephone or 100V line cables.

DO NOT run 100V line cables near data, telephone or other low voltage cables.

DO NOT exceed 90% of the amplifiers output power when using 100V line (speech only).

DO NOT exceed 70% of the amplifiers output power when using 100V line (high level

background music).

DO NOT use re-entrant horn loudspeakers for background music unless the loudspeaker has

been specifically designed for this purpose.

AVOID jointing the microphone cable, when this is unavoidable make sure a good screened

connector is used, e.g. XLR.

ALWAYS use a balanced or floating low impedance microphone terminating into a balanced

input on long microphone cable runs.

ALWAYS use a mains grade double insulated cable for the loudspeaker cable runs.

ENSURE that all loudspeakers are in-phase.

ENSURE that there are no short circuits on the loudspeaker line before connecting to the

amplifier.

Green and Yellow: Earth (E)

Blue: Neutral (N)

Brown : Live (L)

As the colours of the wires in the mains lead of this

appliance may not correspond with the coloured markings

identifying the terminals in your plug proceed as follows:

• The green and yellow coloured wire must be

connected to the terminal that is marked by the letter E,

marked by the safety earth symbol or coloured green

and yellow.

• The blue coloured wire must be connected to the

terminal that is marked with the letter N or coloured

black.

• The brown coloured wire must be connected to the

terminal that is marked with the letter L or coloured red.

If a 13 Amp (B.S.1363) plug or any other type of plug is

used,a 5 Amp fuse must be fitted either in the plug or at the

distribution board.

FRONT PANEL Mixer Amplifier

2 3 4 5 6 7 8 9 10

11 12

1. Mic 1 Input (Phone) 7. Master Tone Control (Bass)

2. Mic 1 Volume Control 8. Master Tone Control (Treble)

3. Mic 2 Volume Control 9. Master Volume Control

4. Mic 3 Volume Control 10.Power On/Off Switch

5. Aux 1 Volume Control 11.Output Level Indicator LED

6. Aux 2 Volume Control 12.Power On/Off Indicator LED

REAR PANEL

34 6 9 11

13 1412

16 17 18 19 20 21

5 7 8 10

1. Earth Connection Screw 12. AC Fuse Holder

2. DC Power Supply Terminals 13. Mains Voltage (115V/230V) Selector Switch

3. Loudspeaker Output Terminals 14. Mains Input Socket

4. Mic3 (Line / Mic) Selector Switch 15. Power Input (RCA Phono)

5. Mic3 Input (XLR / Balanced) 16. Pre Output (RCA Phono)

6. Mic3 Input (Phone / Balanced) 17. Tape Output(2X RCA Phono)

7. Mic2 Input (XLR / Balanced) 18. Aux2 Input (2X RCA Phono)

8. Mic2 Input (phone / Balanced) 19. Aux1 Input (2X RCA Phono)

9. Mic1 Input (XLR / Balanced) 20. TEL / EMER Input Terminals

10. Mic1 Input (DIN / Balanced) 21. TEL / EMER Input Level Control

11. Chime On/Off switch

Produktspezifikationen

Marke:	HQ
Kategorie:	Empfänger
Modell:	HA30W
Breite:	430 mm
Tiefe:	300 mm
Produktfarbe:	Schwarz
Übertragungstechnik:	Kabelgebunden
Höhe:	88 mm
Zweck:	Haus
RMS-Leistung:	30 W
AC Eingangsspannung:	230 V
DC input Spannung:	24 V
Eingebautes Display:	Nein
Paketgewicht:	6740 g
Schnellstartübersicht:	Ja
Betriebsanleitung:	Ja
Audio Kanäle:	- Kanäle
THD, totalklirren:	1 %
Rauschverhältnis (SNR):	- dB
Frequenzbereich:	30 - 17000 Hz
Benutzerhandbuch:	Ja
Verpackungsabmessungen (BxTxH):	350 x 510 x 175 mm
Leistungshöhepunkt pro Kanal:	- W
Output Widerstand:	8 Ohm