HQ Power LAMP75ST2 Bedienungsanleitung
HQ Power
Effektmaschine
LAMP75ST2
Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr HQ Power LAMP75ST2 (18 Seiten) in der Kategorie Effektmaschine. Dieser Bedienungsanleitung war fĂĽr 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/18
VDL75ST
STROBO
USER MANUAL
GEBRUIKERSHANDLEIDING
NOTICE D’EMPLOI
MANUAL DEL USUARIO
BEDIENUNGSANLEITUNG
VDL75ST 2 VELLEMAN®
ENGLISH
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its
lifecycle could harm the environment. Do not dispose of the unit (or batteries) as unsorted
municipal waste; it should be taken to a specialised company for recycling. This device
should be returned to your distributor or to a local recycling service. Respect the local
environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VDL75ST! Please read the manual thoroughly before bringing this device
into service. If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
• This device falls under protection class I. It is therefore essential that the device be earthed. Have
a qualified person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of
this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it
if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord
by the plug only.
• There may be some smoke or a particular smell when the device is activated for the first time.
This is normal and any smoke or smell will gradually disappear.
• Replace the shields, lenses or UV screens if they have become visibly damaged (e.g. cracks, deep
scratches) to such an extent that their effectiveness is impaired.
• Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. General Guidelines
• This device is designed for discos, theatres, etc. The professional use on stage, in VDL75ST
should only be used indoors with the included power adapter connected to an alternating current
of max. 230VAC / 50Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see “Technical
Specifications”), dust and moisture.
• Familiarise yourself with the functions of the device before actually using it. Do not allow
operation by unqualified people. Any damage that may occur will most probably be due to
unprofessional use of the device.
• Use the original packaging if the device is to be transported.
Be very careful during the installation: touching live wires can cause life-threatening
electroshocks.
Do not touch the device durin
g
o
p
eration as the housin
g
heats u
p
.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
VDL75ST 3 VELLEMAN®
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
• Never operate the device without glass pane or with a broken glass pane. Ask your dealer or
authorized agent to replace the pane if necessary.
4. Installation
a) Installing or replacing a lamp
• Only fit or replace a lamp when the device is unplugged from the mains.
• Let a lamp cool down before replacing it as the temperature of a lamp can reach 700°C during
operation.
• When handling a halogen lamp, do not touch it with your bare hands. Use a cloth to insert or
remove it.
• Replace the glass pane when damaged.
• Do not install lamps with a higher wattage than that for which this device was designed.
• Replace any deformed or damaged lamp with a lamp of the same type. For the installation, you
need a 75W strobe lamp, order code LAMP75ST2.
1) Remove the screw on the front.
2) Carefully remove the glass pane by rotating it anti-clockwise. Do not damage the pane.
3) Remove the old lamp and place a new one.
4) Close the glass pane by rotating it clockwise.
5) Fasten the screw.
Remark: Do not operate the device when the lid is off.
b) Replacing the fuse
• Only replace a fuse with a fuse of the same type and rating.
• Only replace a fuse when the device is unplugged from the mains.
• The fuse is an internal fuse. It should be replaced by your agent or an authorized dealer.
c) Mounting the device
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used. Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
• Before mounting make sure the installation area can hold a minimum point load of 10 times the
device's weight.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• The installation has to be approved by an expert before the device is taken into service.
Produktspezifikationen
| Marke: | HQ Power |
| Kategorie: | Effektmaschine |
| Modell: | LAMP75ST2 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit HQ Power LAMP75ST2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Effektmaschine HQ Power
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
Bedienungsanleitung Effektmaschine
- Effektmaschine NGS
- Effektmaschine Velleman
- Effektmaschine König
- Effektmaschine Pyle
- Effektmaschine Antari
- Effektmaschine BeamZ
- Effektmaschine Stairville
- Effektmaschine American DJ
- Effektmaschine Karma
- Effektmaschine Adj
- Effektmaschine Behringer
- Effektmaschine Eurolite
- Effektmaschine Showtec
- Effektmaschine Monoprice
- Effektmaschine Lexicon
- Effektmaschine Monacor
- Effektmaschine HQ
- Effektmaschine Viking
- Effektmaschine Elation
- Effektmaschine Cameo
- Effektmaschine Qtx
- Effektmaschine Midas
- Effektmaschine Black Lion Audio
- Effektmaschine Martin
- Effektmaschine Steren
- Effektmaschine TCM FX
- Effektmaschine Fun Generation
- Effektmaschine Futurelight
- Effektmaschine IMG Stage Line
- Effektmaschine TC Electronic
- Effektmaschine Lab Gruppen
- Effektmaschine Hazebase
- Effektmaschine Doepfer
- Effektmaschine Chauvet
- Effektmaschine Valueline
- Effektmaschine Laserworld
- Effektmaschine Klark Teknik
- Effektmaschine Eliminator Lighting
- Effektmaschine BoomTone DJ
- Effektmaschine Sagitter
- Effektmaschine Drawmer
- Effektmaschine DJPower
- Effektmaschine The Confetti Maker
- Effektmaschine Blizzard
- Effektmaschine ColorKey
- Effektmaschine Lotronic
- Effektmaschine Valcom
- Effektmaschine Evo-Lite
- Effektmaschine IGS Audio
- Effektmaschine Magmatic
- Effektmaschine Technical Pro
- Effektmaschine Rosco
- Effektmaschine Showven
Neueste Bedienungsanleitung fĂĽr -Kategorien-
10 Oktober 2024
8 Oktober 2024
6 Oktober 2024
2 Oktober 2024
2 Oktober 2024
2 Oktober 2024
30 September 2024
30 September 2024
28 September 2024
25 September 2024