Hotpoint HDM67I9H2CX/UK Bedienungsanleitung

Hotpoint Herde HDM67I9H2CX/UK

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hotpoint HDM67I9H2CX/UK (6 Seiten) in der Kategorie Herde. Dieser Bedienungsanleitung war für 17 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/6

HDM67I9H2CX/UKHDM67I9H2CX/UKHDM67I9H2CX/UK

EN ENGLISH

Health and Safety guide

Installation guide

Quick guide

ACCESSORIES

FIRST TIME USE

POWER MANAGEMENT

At the time of purchase, the hob is set to the maximum possible power.

Adjust the setting in relation to the limits of the electrical system in your

home as described in the following paragraph.

N.B: Depending on the power selected for the hob, some of the cooking

zone power levels and functions (e.g. boil or quick reheating) could be

automatically limited, in order to prevent the selected limit from being

exceeded.

To set the power of the hob:

Once you have connected the device to the mains power supply, you

can set the power level within 60 seconds.

Press the ”+” button for at least 3 seconds. The display shows . Conrm

by pressing . The last power level selected appears on the display.

Use the ”+”

and

”−”

buttons to select the desired power level. The power

levels available are: 2.5 kW – 4.0 kW – 6.0 kW – 7.2 kW.

Conrm by pressing

The power level selected will stay in the memory even if the power supply

is interrupted.

To change the power level, disconnect the appliance from the mains for at

least 60 seconds, then plug it back in and repeat the steps above.

If an error occurs during the setting sequence, the

symbol will appear,

and you will hear a beep. If this happens, repeat the operation.

If the error persists, contact the After-Sales Service.

ACOUSTIC SIGNAL ON / OFF

To switch the acoustic signal on/o:

• Connect the hob to the power supply;

• Wait for the switch-on sequence;

• Within 60 seconds, press the buttons

”+” and simultaneously for

at least 5 seconds.

DEMO MODE (reheating deactivated, see section on ”Troubleshooting”)

To switch the demo mode on and o:

• Connect the hob to the power supply;

• Wait for the switch-on sequence.

• Within 60 seconds, press the cooking zone selection buttons in the

top

left and top right simultaneously for at least 3 seconds

(as shown below);

• ”DE” will show on the display.

POTS AND PANS

Only use pots and pans made from ferromagnetic

material which are suitable for use with induction hobs:

• enamelled steel

• cast iron

• special pots and pans in stainless steel, suitable

for induction cooking

To determine whether a pot is suitable, check for the

symbol (usually

stamped on the bottom). A magnet may be used to check whether pots are

magnetic.

The quality and the structure of the pot base can alter cooking performance.

Some indications for the diameter of the base do not correspond to the

actual diameter of the ferromagnetic surface.

Some pots and pans have only a part of the bottom in ferromagnetic

material, with parts in another material that is not suitable for induction

cooking. These areas may heat up at dierent levels or with lower

temperatures. In certain cases, where the bottom is made mainly of

non-ferromagnetic materials, the hob might not recognise the pan and

therefore not switch on the cooking zone.

To ensure optimum eciency, always use pots and pans with a at bottom

that distributes the heat evenly. If the bottom is uneven, this will aect

power and heat conduction.

NOOK

Empty pots or pots with a thin base

Do not use empty pots or pans when the hob is on. The hob is equipped with

an internal safety system that constantly monitors the temperature, activating

the ”automatic o” function where high temperatures are detected. When

used with empty pots or pots with thin bases, the temperature may rise very

quickly, and the ”automatic o” function may not be triggered immediately,

damaging the pan or the hob surface. If this occurs, do not touch anything,

and wait for all components to cool down.

If any error messages appear, call the service centre.

Minimum diameter of pot/pan base for the dierent cooking areas

To ensure that the hob functions properly, the pot must cover one or

more of the reference points indicated on the surface of the hob, and

must be of a suitable minimum diameter.

Always use the cooking zone that best corresponds to the diameter of

the bottom of the pan.

min.

100 mm

min. 150 mm

min.

120 mmmin.

100 mm

ADAPTER FOR POTS/PANS UNSUITABLE FOR INDUCTION

Using this accessory makes it possible to use pots and pans that are not

suitable for induction hobs. It is important to bear in mind that using it

aects eciency and consequently the time needed to heat food. Its

use should be limited because the temperatures reached on its surface

depend signicantly on the pot/pan used, its atness and the type of

food being cooked. Using a pot or pan with a smaller diameter than the

adapter disc may cause heat to build up that is not transmitted to the

pot or pan and this could blacken both the hob and the disc. Adapt the

diameter of your pots/pans and the hob to the diameter of the adapter.

3 sec.

Produktspezifikationen

Marke:	Hotpoint
Kategorie:	Herde
Modell:	HDM67I9H2CX/UK
Display-Typ:	LED
Breite:	600 mm
Tiefe:	600 mm
Gewicht:	52000 g
Produkttyp:	Freistehender Herd
Produktfarbe:	Silber
Steuerung:	Buttons, Rotary
Höhe:	900 mm
AC Eingangsspannung:	230 - 240 V
Eingebautes Display:	Ja
Verpackungsbreite:	660 mm
Verpackungstiefe:	660 mm
Verpackungshöhe:	920 mm
Paketgewicht:	57 g
Ursprungsland:	Polen
Selbstreinigend:	Ja
Energieeffizienzklasse:	A
Einfach zu bedienen:	Ja
Betriebsanleitung:	Ja
Energieeffizienzskala:	A+++ bis G
Abtaufunktion:	Nein
Stromstärke:	46.5 A
Kindersicherung:	Nein
Integrierte Uhr:	Ja
Innenbeleuchtung:	Ja
Lampentyp:	Halogen
Kochfeldtyp:	Zonen-Induktionskochfeld
Anzahl Herdplatten/Kochzonen:	4 Zone(n)
Leistung Kochzone 1:	2100 W
Leistung Kochzone 2:	1200 W
Leistung Kochzone 3:	1200 W
Leistung Kochzone 4:	1800 W
Auftriebs-Funktion:	Ja
Steuerungsposition:	Vorderseite
Anschlusswert (elektrisch):	10800 W
Ofengröße:	Medium
Anzahl der Öfen:	2
Netto-Ofenvolumen:	72 l
Reinigungsart:	Katalytisch
Ober- und Unterhitze:	Nein
Energieverbrauch (konventionell):	0.82 kWh
Energieverbrauch (erzwungene Konvektion):	0.82 kWh
Pizzabackfunktion:	Nein
Unterhitze:	Nein
Anzahl der Regale:	2 Regale
Aufwärmfunktion:	Nein
Handgrifffarbe:	Silber
Mikrowellenkochen:	Nein
Konventionelle Beheizung (Ober-/Unterhitze):	Nein
Energieeffizienzindex (EEI):	99.5
Netzkabel enthalten:	Ja
Innenbeschichtung:	Emaille
Rotisserie:	Nein
Bruttorauminhalt Ofen:	72 l
Stromquelle Ofen:	Elektro
Ofenposition:	Boden
Langsames Garen:	Nein
Staufach:	Nein
Grillplatte:	Nein
Materiallgriff:	Metall
Teleskopschiene enthalten:	Nein
Ofen 2 Energieeffizienzklasse:	A
Ofen 2 Bruttorauminhalt:	46 l
Ofen 2 Grill:	Ja
Ofen-Warmhaltefunktion:	Nein
Licht an/aus:	Nein
Einfach zu reinigen (Kochfeld):	Ja
Ofentüröffnung:	Seitenöffnung
Teleskop-Regale:	Nein
Kochfeld-Timer:	Nein
Ofen 2 Größe:	Medium
Ofen 2 Stromquelle:	Elektro
Ofen 2 Nettokapazität:	46 l
Ofen 2 Leistung:	2600 W
Ofen 2 Türöffnung:	Drop-down-Öffnung
Türmaterial Ofen 2:	Glas
Ofen 2 Anzahl der Einschübe:	1 Regale
Ofen 2 Innenbeleuchtung:	Nein
Ofen-Timer:	Ja
Ofen-Timer-Typ:	Digital
Wokbrenner:	Nein
Ofen 2 Energieverbrauch (herkömmlich):	0.79 kWh
Speisensonde:	Nein
Ofen 2 herkömmliches Kochen:	Ja
Soft-Close-System:	Nein
Einfach zu reinigen (Ofen):	Ja
Ofen 2 Abtaufunktion:	Nein
Ofen 2 Langsames Kochen:	Nein
Ofen 2 Warmhaltefunktion:	Nein
Position Ofen 2:	Oben
Wok-Ring:	Nein
Abnehmbare Regalläufer:	Nein
Ofen 2 Sichtfenster:	Ja
Herausnehmbare Einlegeböden:	Ja
Ofen 2 Grillleistung:	2600 W
Anzahl der Kochzonen mit Boost-Funktion:	4
Heizschublade:	Nein
Läufer-Typ:	Geformte Laufschiene
Fischbrenner:	Nein