Hooker 638-75006 Bedienungsanleitung

Hooker Stuhl 638-75006

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung fĂŒr Hooker 638-75006 (2 Seiten) in der Kategorie Stuhl. Dieser Bedienungsanleitung war fĂŒr 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
1/2
ASSEMBLY INSTRUCTION
Item#:638-75006 Brynlee Side Chair/2per ctn
** Please make sure you have all parts indicated below prior to assembly.
Assembly Steps:
There are two K/D chairs in one box. Please follow numbers on one chair and letters on the other chair
during assembly.
1. Place back frame (G) on a clean surface.
2. Tighten seat frame(I) to the back legs of frame(G) by using bolt(C), lock washer(B) and at
washer(A) at the center location (see diagram 2). Then, tighten seat frame (I) to back legs of frame
(G) using bolts (E), lock washers (B) and at washers (A) at corner blocks. (See diagram 1)
3. Install front legs (F) onto seat frame (I) using bolts (C), lock washers (B), at washers (A). Tighten
all bolts by hand. (See diagram 2)
4. After all bolts are attached and hand tightened, turn the chair upright.
5. Level the chair following the “chair leveling instruction” as below.
6. Make sure the chair is level and then tighten all bolts completely by using the allen wrench (D).
DIAGRAM 1
DIAGRAM 2
2/2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and ecient, please read the entire instruction sheet prior to
assembling of the chair. Make sure all hardware listed is included. To properly assemble the chair, none of
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most oors have slight irregularities that can aect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to nger tight.
2. Extend both front legs upward to their fullest length.
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. Re-tighten all bolts and nuts.
Cleaning Instruction: Clean nished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the nish with soft cloth and an industry recognized furniture polish.


Produktspezifikationen

Marke: Hooker
Kategorie: Stuhl
Modell: 638-75006

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hooker 638-75006 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Stuhl Hooker

Bedienungsanleitung Stuhl

Neueste Bedienungsanleitung fĂŒr -Kategorien-