Hooker 1618-75710-DKW Bedienungsanleitung

Hooker Stuhl 1618-75710-DKW

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Hooker 1618-75710-DKW (2 Seiten) in der Kategorie Stuhl. Dieser Bedienungsanleitung war fĂĽr 26 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
1/2
ASSEMBLY INSTRUCTION
Item#:161 757108- - DKW Deconstructed Upholstered Side Chair
** Please make sure you have all prior to assembly.parts indicated below
Assembly Steps:
There are two K/D chairs in one box. Please follow numbers on one chair and letters on the other chair
during assembly.
1. Place chair back on a clean surface.
2. Insert front leg and back leg into corner block of seat frame by using lock washer (I) 2 (A 2bolt ), (B)
and 2flat washer Tighten all bolts by (see diagram (C) , allen wrench (D) 1).
3. Attach the back rail on the seat frame back by by using 1bolt (A 1), lock washer (B) and 1flat
washer Tighten (C) , the bolts by allen wrench (D)
4. After all bolts are attached and hand tightened, turn the chair upright.
5. Level the chair following the “chair leveling instruction” as below.
6. Make sure the chair is level and then tighten all bolts completely by using allen wrench . (D)
Diagram 1
I
2/2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet prior to
assembling the chair. Make sure all hardware listed is included. To properly assemble the chair, none of
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs ward to their fullest length.up
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. -Re tighten all bolts and nuts.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.


Produktspezifikationen

Marke: Hooker
Kategorie: Stuhl
Modell: 1618-75710-DKW

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hooker 1618-75710-DKW benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Stuhl Hooker

Bedienungsanleitung Stuhl

Neueste Bedienungsanleitung fĂĽr -Kategorien-