Hooker 5751-75411-95 Bedienungsanleitung

Hooker Stuhl 5751-75411-95

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung fĂŒr Hooker 5751-75411-95 (2 Seiten) in der Kategorie Stuhl. Dieser Bedienungsanleitung war fĂŒr 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
1/2
ASSEMBLY INSTRUCTION
Item#: 1-75411-575 95 -Back Side Chair Shield
** Please make sure you have all parts indicated below prior to assembly.
Assembly Steps:
There are two K/D chairs in one box. Please follow numbers on one chair and letters on the other chair
during assembly.
1. Place chair back (G) on a clean surface.
2. Tighten seat frame (I) to chair back (G) by using bolt (C), lock washer (B) and at washer (A) at the
center location. (see diagram 1 Then tighten seat frame (I) to chair back (G) by using bolts (E), )
lock washers (B), at washers (A) at corner . (See diagram 1)
3. Please follow numbers on legs (F) and corner blocks. Assemble front legs (F) onto front corner
blocks of seat frame (I), using bolts (E), lock washers (B) and at washers (A). Tighten all bolts by
hand. (See diagram 1)
4. After all bolts are attached and hand tightened, turn the chair upright.
Diagram 1
2/2
5. Level the chair following the “chair leveling instruction” as below.
6. Make sure the chair is level and then tighten all bolts completely by using allen wrench (D).
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and ecient, please read the entire instruction sheet prior to
assembling the chair. Make sure all hardware listed is included. To properly assemble the chair, none of
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard at surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most oors have slight irregularities that can aect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to nger tight.
2. Extend both front legs ward to their fullest length. up
3. Gently push downward on the front edge of the seat until all four legs rest on the oor.
4. -tighten all bolts and nuts. Re
Cleaning Instruction: Clean nished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the nish with soft cloth and an industry recognized furniture polish.


Produktspezifikationen

Marke: Hooker
Kategorie: Stuhl
Modell: 5751-75411-95

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hooker 5751-75411-95 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Stuhl Hooker

Bedienungsanleitung Stuhl

Neueste Bedienungsanleitung fĂŒr -Kategorien-