Hooker 1672-75302-80 Bedienungsanleitung

Hooker Stuhl 1672-75302-80

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hooker 1672-75302-80 (2 Seiten) in der Kategorie Stuhl. Dieser Bedienungsanleitung war für 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
1/2
ASSEMBLY INSTRUCTION
Item#: 1672-
-
-
--75302-
-
-
--80 Upholstered Arm Chair
** Please make sure you have all parts indicated below prior to assembly.
Diagram 1 Diagram 2 Diagram 3
There are two K/D chairs in one box. Please follow numbers on one chair and letters on the other chair
during assembly.
1. Place chair back( )J on a clean surface.
2. Attach seat frame (L) to chair back (J) by using bolt (G), lock washer (B) , flat washer (C) at the
center location and tighten by Allen Wrench(D). Then, tighten seat frame (L) to chair back (J) by
using bolts (A), lock washers (B), flat washers (C) and secured by using allen wrench (D) at corner.
(See diagram 1)
3. Attach front legs (I) to seat frame (L) by using bolts (E), lock washers (B) ,flat washers (C) and
tighten by allen wrench (D) at corners.(See diagram 1)
4. After all bolts are attached and hand tightened, turn the chair upright.
2/2
5. Attach stretcher (H) to front legs( I )with screw (F) .(See diagram 2)
6. Screw (F) arm rest to chair back (J) tightly .(See diagram 3)
7. Make sure the chair is level and then tighten all bolts completely by using allen wrench (D).
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet prior to
assembling of the chair. Make sure all hardware listed is included. To properly assemble the chair, none of
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs upward to their fullest length.
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. Re-tighten all bolts and nuts.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.


Produktspezifikationen

Marke: Hooker
Kategorie: Stuhl
Modell: 1672-75302-80

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hooker 1672-75302-80 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Stuhl Hooker

Bedienungsanleitung Stuhl

Neueste Bedienungsanleitung für -Kategorien-