Honeywell 6150RF Bedienungsanleitung

Honeywell Intelligentes Zuhause 6150RF

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Honeywell 6150RF (2 Seiten) in der Kategorie Intelligentes Zuhause. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/2

ADEMCO 6150RF

Keypad/Transceiver

User Guide

The keypad features a three digit numeric display for zone identification and pre- -designated English-language prompts

(e.g., “ALARM,” “AWAY,” “ ” “ ” STAY, CHECK, etc.) for indicating system status. (Refer to Figure 1.)

The function keys are located behind a decorative door and are continuously backlit for ease in use. (Refer to the User’s

Guide provided with the control panel for detailed instructions on the use of these keys.)

The function keys include keys for panic alarm activation. The panic alarms are activated by pressing key pairs [1] & [*], [3]

& [#], or [*] & [#], or a Special Function Key (see below). Whether these panic keys function and the type of panic alarms

they produce is determined by the control panel’s capability and programming. (Check with your installer for the further

information regarding these keys.)

The sounder is a piezo sound for burglary and audible - - electric sounder that pulses for fire alarms and generates a two tone

panic alarms.

The keypad contains two LEDs that indicate the status of the system as follows:

LED

Function

Green (Ready)

Lights when the system is ready to arm (no zone faults are present).

Red (Armed)

Lights when the system is armed.

These are four keys located to the left of the numeric keys (refer to Figure 1 ). The keys may be programmed by your

installer for panic alarms or other special functions such as macros (a frequently used series of key entries). Function keys

must be held down for at least 2 seconds to activate an alarm. (Check with your installer for the programmed function of

these keys.)

This mode gives you the capability of enabling and disabling individual wireless keys that have been directly programmed

into the ADEMCO 6150RF. This is particularly useful if a user loses a wireless key.

Press the [1] and [3] keys simultaneously for a few seconds (make sure the unit has been powered for at least 1 minute

prior).

On the display, “dE and ” “-” - flashes alternately. Enter the number of the wireless key transmitter (1 8).

Then “d” and the wireless key number you entered flash al on the display. A ternately with “1” or “0” “1” indicates the

wireless key is enabled, a “0” indicates it is disabled. Enter [1] to enable or [0] to disable the wireless key. All wireless keys

are defaulted to 1 (enabled).

Press the [*] to accept the entry.

Repeat the procedure for all the wireless keys whose status you want to change.

To exit the User mode press [*] when “ ” “–” dE and flash alternately on the display.

FEDERAL COMMUNICATIONS COMMISSION STATEMENTS

The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual.

Unauthorized changes or modifications could void the user's authority to operate the equipment.

FCC CLASS B STATEMENT

This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for

your information:

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the

manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the

limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide

reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• If using an indoor antenna, have a quality outdoor antenna installed.

• Reorient the receiving antenna until interference is reduced or eliminated.

• Move the radio or television receiver away from the receiver/control.

• Move the antenna leads away from any wire runs to the receiver/control.

• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.

• Consult the dealer or an experienced radio/TV technician for help.

INDUSTRY CANADA CLASS B STATEMENT

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB 003 du Canada.-

FCC / IC STATEMENT

This device complies with Part 15 of the FCC Rules, and RSS 210 of IC. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired

operation.

Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est soumis aux

conditions suivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit accepter toute interference reçue y

compris les interferences causant une reception indésirable.

The product should not be disposed of with other household waste. Check for the nearest authorized collection centers or authorized recyclers. The

correct disposal of end-of-life equipment will help prevent potential negative consequences for the environment and human health.

The Honeywell Home Trademark is used under license from Honeywell International Inc.

This product is manufactured by Resideo Technologies, Inc. and its affiliates

ÊK4461-1V1D1Š

2 Corporate Center Drive, Suite 100

P.O. Box 9040, Melville, NY 11747

www.resideo.com

Produktspezifikationen

Marke:	Honeywell
Kategorie:	Intelligentes Zuhause
Modell:	6150RF
Breite:	160 mm
Tiefe:	25 mm
Produktfarbe:	Weiß
Übertragungstechnik:	Verkabelt & Kabellos
Höhe:	125 mm
Eingebautes Display:	Ja
Typ:	Wand-montiert
Anzahl Kanäle:	- Kanäle