Hifonics BXiPro3.0 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Hifonics BXiPro3.0 (10 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/10
Operator’s Guide
BXiPRO3.0
Digital Bass Enhancement Processor
Thank you for purchasing the HIFONICS BXiPRO3.0 Digital Bass
Enhancement Processor. This unit has the ability to îšżne tuning bass
width and sweep for increased sound performance. Please read the
entire manual to ensure proper connections and application.
CAUTION
Always consider consulting a professional audio installer
before installing any audio components. Be careful and take
your time. Do not let wires make contact with metal edges or
hot engine components.
Features
• Enhances and restores the bass level
• Screw in power and speaker connecters to chassis for secure
connections that prevent disconnection
• Dual function bass remote
• Remote wire input, DC sense and music sense turn on
• Input and output signal clip indicators
• Mono adjustable output level (can be controlled by bass remote)
• 48v high level inputs
• Ability to use test tones to set input and output levels
• Fine tuning adjustability using bass width and sweep
• Fixed 4v full range output
• Small prole
• Tiffany style RCA connectors
• Low and high level audio inputs (speaker level inputs)
• Balanced differential inputs (for noise reduction).
Mounting and Hardware
Prior to mounting, connect the wires
to ensure proper operation.
MOUNTING
1. Select the desired mounting location that allows the unit to be
mounted on a at surface with room for connections.
2. Use the mounting brackets that are attached to the unit and use
the provided hardware for mounting the unit. Make sure there is
proper clearance for the mounting bracket screws when attaching
to selected location. Use caution to ensure there are no wiring
harnesses, mechanical or gas tanks under the location selected.
3. Route the power, ground and remote wires away from moving parts to
prevent pinching or shorting the wires. Also keep in mind of anything
that can creates excessive heat to avoid wires from detreating.
WIRING
1. : The power wire should connect to a constant or Power Wire
switched +12 volt source with a (1 Amp) provided in-line fuse. We
recommend that you use the radio constant or switch +12 volt source.
2. : Connect the ground wire to a clean chassis ground Gound Wire
point. Be sure to remove all paint and primer to expose clean metal.
Use a ring terminal and lock or star washer to secure the ground wire.
3. : The remote wire should be connected to the source Remote Wire
unit remote wire (ampliîšżer turn on or accessory wire) that provides
+12 volts when the source unit is “on” and 0 volts when the source
unit is turned “off”. (please note that some source unit’s antenna
connections will only show + 12 volts when AM/FM is selected
and 0 volts when other sources are selected).


Produktspezifikationen

Marke: Hifonics
Kategorie: Nicht kategorisiert
Modell: BXiPro3.0

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hifonics BXiPro3.0 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Hifonics

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-