Hestan AGSDR42-BU Bedienungsanleitung

Hestan Grill AGSDR42-BU

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hestan AGSDR42-BU (18 Seiten) in der Kategorie Grill. Dieser Bedienungsanleitung war für 13 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/18
©2016 Hestan Commercial Corporation
1
EN
OUTDOOR CABINETS
Installation Instructions
AGAD / AGSD / AGSDR / AGSR / AGDR
IMPORTANT - READ ALL INSTRUCTIONS BEFORE YOU BEGIN
INSTALLER SHOULD LEAVE THESE INSTRUCTIONS WITH THE HOMEOWNER
Some parts have sharp edges. Care must be taken when handling the various components to avoid
personal injury. Wear gloves when handling.
TOOLS REQUIRED:
Work gloves
Safety glasses
Electric drill with assorted bits for mounting hardware, masonry anchors, etc. where needed
Phillips screwdriver
Flat-blade screwdriver
Level
Tape measure
Inspect the product to verify that there is no shipping damage. If any damage is detected, call the shipper
and initiate a damage claim. Hestan Commercial Corp. is not responsible for shipping damage. DO NOT
discard any packing material (box, pallet, straps) until the unit has been inspected.
Remove all exterior packaging materials, banding, tape, etc. Remove all protective film from the inside of
your cabinets. You may leave any exterior protective film on until after installation is complete.
ACCESS
DOOR
FRAME
PRY UP HERE TO
REMOVE DAMPER
DOOR
MOUNTING
BASE
STRUCTURE
(DOOR JAMB)
DAMPER
ACCESS
DOOR
FRAME DOOR
MOUNTING
BASE
STRUCTURE
(DOOR JAMB)
PINCH HERE
TO UN-CLIP
HINGE
CABINET DOOR INSTALLATION (AGAD, AGSD, AGDR, AGSDR)
1. Your new Hestan cabinets come with doors pre-installed in their frames. It will be necessary to detach
them before installing the frame in your island structure. As shown below, remove the dampers, then
pinch the back of the hinge to un-clip it from the mounting base. The door may now be removed.
©2016 Hestan Commercial Corporation
2
EN
2. Consult the table at the end of this instruction manual to determine the appropriate cutout dimensions
for the Hestan Outdoor cabinet product you are installing. The cutouts should be square at all corners
for proper fitment of the cabinet. The installer will have to build up any internal structural elements or
supports in the island in order to secure the cabinet in place. Stainless steel hardware (not included) is
highly recommended.
3. Slide the frame into the opening and check for proper alignment. Secure the frame to the structural
members of your island using the various available mounting holes in the frame.
4. To re-install the door, follow the instructions shown below.
ACCESS
DOOR
FRAME
ATTACH AT THIS
NOTCH FIRST
DOOR
STRUCTURE
(DOOR JAMB)
MOUNTING
BASE
PUSH HINGE
UNTIL REAR
CLIP ENGAGES
ACCESS
DOOR
FRAME
ATTACH DAMPER
AT THIS NOTCH
DOOR
STRUCTURE
(DOOR JAMB)
MOUNTING
BASE
PUSH HERE
UNTIL REAR
ENGAGES
CABINET DOOR INSTALLATION
(continued)
©2016 Hestan Commercial Corporation
3
EN
CABINET DOOR INSTALLATION
(continued)
5. Hestan cabinet doors feature 3-way adjustable hinges. It is recommended to do the height
adjustment first. Loosen the top & bottom screw on each mounting base, then use the height
adjustment screw shown below to fine-tune the vertical height of the door in the frame. Tighten
the top and bottom screws when done.
HEIGHT
ADJUSTMENT
6. The side and depth adjustment of the doors are shown below.
SIDE-TO-SIDE
ADJUSTMENT
DEPTH
ADJUSTMENT


Produktspezifikationen

Marke: Hestan
Kategorie: Grill
Modell: AGSDR42-BU

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hestan AGSDR42-BU benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Grill Hestan

Bedienungsanleitung Grill

Neueste Bedienungsanleitung für -Kategorien-